display HYUNDAI I20 2023 User Guide

4-16
Instrument cluster
Exhaust System (GPF)
Warning Light
(Petrol Engine,
if equipped)
7KLVZDUQLQJOLJKWLOOXPLQDWHV

[This warning light illuminates, when
accumulated soot reaches a certain
amount.

[When this warning light illuminates, it
may turn off after driving the vehicle
at more than 50 mph (80 km/h) for
about 30 minutes (above 3rd gear with
1500 ~ 4000 engine RPM).
If this warning light blinks in spite
of the procedure (at this time LCD
warning message will be displayed),
we recommend that you have the
GPF system checked by a HYUNDAI
authorised repairer.
NOTICE
If you continue to drive with the GPF
warning light blinking for a long time,
the GPF system can be damaged and
fuel consumption can worsen.
Electronic Stability
Control (ESC) indicator
light
7KLVLQGLFDWRUOLJKWLOOXPLQDWHV

[When you set the ignition switch or
the Engine Start/Stop button to the
ON position.
- The Electronic Stability Control
indicator light illuminates for about 3
seconds and then goes off.

[Whenever there is a malfunction with
ESC system.
If this occurs, we recommend that
you have the vehicle inspected by a
HYUNDAI authorised repairer.
7KLVLQGLFDWRUOLJKWEOLQNV

[Whilst the ESC is operating.
For more details, refer to “Electronic
Stability Control (ESC)” section in
chapter 6.
Electronic Stability
Control (ESC) OFF
Indicator Light
7KLVLQGLFDWRUOLJKWLOOXPLQDWHV

[When you set the ignition switch or
the Engine Start/Stop button to the
ON position.
- The ESC OFF indicator light illuminates
for approximately 3 seconds and then
goes off.

[When you deactivate the ESC system
by pressing the ESC OFF button.
For more details, refer to “Electronic
Stability Control (ESC)” section in
chapter 6.

4-21
04
LCD display messages
Key not in vehicle
(for smart key system)
This warning message is displayed if the
smart key is not in the vehicle when you
open or close door in the ACC position
or ON position. The warning sound is
heard when you close door without a
smart key in vehicle.
When attempting to start the vehicle
always have the smart key with you.
Key not detected
(for smart key system)
This warning message is displayed if
the smart key is not detected when you
press the Engine Start/Stop button.
Press START button with key (for
smart key system)
This warning message is displayed if
you press the Engine Start/Stop button
whilst the warning message “Key not
detected” is displayed.
At this time, the immobiliser indicator
light blinks.
Low key battery
(for smart key system)
This warning message is displayed if the
battery of the smart key is discharged
whilst changing the Engine Start/Stop
button to the OFF position.
Press brake pedal to start engine
(for smart key system and
Automatic transmission/Dual clutch
transmission)
This warning message is displayed if the
Engine Start/Stop button changes to
the ACC position twice by pressing the
button repeatedly without depressing
the brake pedal.
You can start the vehicle by depressing
the brake pedal.
Press clutch pedal to start engine
(for smart key system and Manual
transmission)
This warning message is displayed if the
Engine Start/Stop button is in the ACC
position twice by pressing the button
repeatedly without depressing the clutch
pedal.
Depress the clutch pedal to start the
engine.
Press START button again
(for smart key system)
This message is displayed if you were
unable to start the vehicle when the
Engine Start/Stop button was pressed.
If this occurs, attempt to start the engine
by pressing the Engine Start/Stop button
again.
If the warning message appears each
time you press the Engine Start/Stop
button, we recommend that you have
your vehicle inspected by a HYUNDAI
authorised repairer.

4-22
Instrument cluster
Shift to N to start engine
(for smart key system and
Automatic transmission/Dual clutch
transmission)
This warning message is displayed if
you try to start the engine with the shift
button not in the N (Neutral) position.
i Information
<RXFDQVWDUWWKHHQJLQHZLWKWKHVKLIW
OHYHULQWKH11HXWUDOSRVLWLRQ
Check BRAKE SWITCH fuse (for
smart key system and Automatic
transmission/Dual clutch
transmission)
This warning message is displayed if the
brake switch fuse is disconnected.
You need to replace the fuse with a new
one. If that is not possible, you can start
the engine by pressing the Engine Start/
Stop button for 10 seconds in the ACC
position.
Door, Bonnet, Tailgate open
indicator
OBC3040012
This warning is displayed if any door
or bonnet or tailgate is left open. The
warning will indicate which door is open
in the display.
CAUTION
Before driving the vehicle, you should
confirm that the door/bonnet/tailgate
is fully closed. Also, check there is no
door/bonnet/tailgate open warning
light or message displayed on the
instrument cluster.

4-23
04
Lights mode
OIK047163L
This indicator displays which exterior
light is selected using the lighting
control.
Wiper mode
OCN7040039L
This indicator displays which wiper
speed is selected using the wiper
control.
Low pressure
ONX4E040019
This warning message is displayed if the
tyre pressure is low. The corresponding
tyre on the vehicle will be illuminated.
For more details, refer to “Tyre Pressure
Monitoring System (TPMS)” section in
chapter 8.
Heated Steering Wheel turned off
(if equipped)
This message illuminates if the heated
steering wheel will turn off automatically
approximately 30 minutes after the
heated steering wheel is turned on.
For more details, refer to “Heated
Steering Wheel” in chapter 5.
Low fuel
This warning message is displayed if the
fuel tank is almost out of fuel.
When this message is displayed, the low
fuel level warning light in the cluster will
come on.
It is recommended to look for the
nearest fuelling station and refuel as
soon as possible.

4-24
Instrument cluster
Low engine oil (if equipped)
This warning message is displayed when
the engine oil level should be checked.
If this warning message is displayed,
check the engine oil level as soon as
possible and add engine oil as required.
Slowly pour the recommended oil little
by little into a funnel.
Use only the specified engine oil. (Refer
to "Recommended lubricants and
capacities" section in chapter 2.)
Do not overfill the engine oil. Make sure
the oil level is not above F (Full) mark on
the dipstick.
NOTICE
If the message is displayed
continuously after adding the engine
oil and travelling approximately 31~
62 mile (50~100 km) after the engine
warms up, we recommend that the
system be checked by a HYUNDAI
authorised repairer.
Engine has overheated
(if equipped)
This warning message is displayed
when the engine coolant temperature
is above 120°C (248°F). This means that
the engine is overheated and may be
damaged.
If your vehicle is overheated, refer to
“Overheating” section in chapter 8.
Check headlight (if equipped)
This warning message is displayed if the
headlamps are not operating properly.
In addition, if a specific lamp(turn signal
lamp etc.) is not operating properly, the
warning message according to a specific
lamp (turn signal lamp etc.) is displayed.
A corresponding bulb may need to be
replaced.
Make sure to replace the burned out
bulb with a new one of the same
wattage rating.
Check brake light (if equipped)
This warning message is displayed if the
stop lamps are not operating properly. A
lamp may need to be replaced.
Make sure to replace the burned out
bulb with a new one of the same
wattage rating.
Check Active Air Flap system (if
equipped)
This message is displayed in the
following situations:
- There is a malfunction with the
actuator flap
- There is a malfunction with the
actuator air flap controller
- The air flap does not open
When all of the above conditions are
fixed, the warning will disappear.

4-26
Instrument cluster
LCD display modes
Modes Symbol Explanation
Trip
ComputerThis mode displays driving information such as the tripmeter,
fuel economy, etc.
For more details, refer to "Trip Computer" in this chapter.
Turn By
Turn (TBT)
This mode displays the state of the navigation.
Driving
Assist
- Smart Cruise Control
- Drive Attention Warning
- Intelligent Speed Limit Warning
User
Settings
In this mode, you can change settings of the doors, lamps,
etc.
Warning
- This mode displays warning messages related to the
lamp malfunction, etc.
- Tyre pressure information
The information provided may differ depending on which functions are applicable
to your vehicle.

4-27
04
Trip computer mode
OIK047124N
The trip computer mode displays
information related to vehicle driving
parameters including fuel economy,
tripmeter information and vehicle speed.
For more details, refer to "Trip
Computer" in this chapter.
Turn By Turn (TBT) group
OIK047151N
This group displays the state of the
navigation.
Driving Assist mode
OBC3070041
6&&,6/$
This mode displays the state of Smart
Cruise Control, Intelligent Speed Limit
Assist.
For more details, refer to each system
information Section in chaptet 7.
OBC3070068
'ULYHU$WWHQWLRQ:DUQLQJ
LIHTXLSSHG
This group displays information related
to Driver Attention Warning.
For more details, refer to "Driver
Attention Warning (DAW)" in chapter 7.

4-28
Instrument cluster
Master warning
OTM050218L
This warning light informs the driver the
following situations.
- Forward Collision-Avoidance Assist
malfunction (if equipped)
- Forward Collision-Avoidance Assist
radar blocked (if equipped)
- Blind-Spot Collision Warning
malfunction (if equipped)
- Blind-Spot Collision Warning radar
blocked (if equipped)
- Lamp malfunction (if equipped)
- High Beam Assist malfunction
(if equipped)
- Smart Cruise Control malfunction
(if equipped)
- Tyre Pressure Monitoring System
malfunction
The Master Warning Light illuminates
if one or more of the above warning
situations occur.
At this time, a Master Warning icon (
)
will appear beside the User Settings icon
(
), on the LCD display.
If the warning situation is solved, the
master warning light will be turned
off and the Master Warning icon will
disappear.
ONX4E040023
7\UH3UHVVXUH
This mode displays information related
to Tyre Pressure.
For more details, refer to "Tyre Pressure
Monitoring System (TPMS)" in chapter
8.

4-32
Instrument cluster
&OXVWHU
ItemsExplanation
Fuel economy
[$IWHUYHKLFOHUHVWDUW

[$IWHUUHIXHOLQJ

[$YHUDJH)XHO(FRQRP\
For more details, refer to "Trip Computer" in this chapter
Fuel economy
auto reset
[2II

[$WGULYLQJ

[$WUHIXHOOLQJ
For more details, refer to "Trip Computer" in this chapter
Wiper/Lights
displayTo activate or deactivate the Wiper/Light mode.When activated, the
LCD display shows the selected Wiper/Light mode whenever you
changed the mode.
Traffic signsTo set the traffic signs displayed.
Icy road warningTo activate or deactivate the icy road warning.
Welcome soundTo activate or deactivate the welcome sound.
Theme selectionYou can select the theme of the cluster.

[7\SH%&OXVWHU
Link to Drive Mode / Theme A / Theme B / Theme C / Theme D
/LJKWV
ItemsExplanation
IlluminationTo adjust the illumination level.

[/HYHOa
One touch turn
indicator
[2II7KHRQHWRXFKWXUQVLJQDOIXQFWLRQZLOOEHGHDFWLYDWHG

[)ODVKHV7KHWXUQVLJQDOLQGLFDWRUZLOOEOLQNRUWLPHVZKHQ
the turn signal lever is moved slightly.
For more details, refer to “Lighting” in chapter 5.
Ambient light
brightness
[2II

[/HYHO
HBA (High Beam
Assist)To activate or deactivate High Beam Assist. For more details, refer to
"High Beam Assist (HBA)" in chapter 5.
❈ The information provided may differ depending on which functions are applicable
to your vehicle.

4-36
Instrument cluster
Trip computer
The trip computer is a microcomputer-
controlled driver information system that
displays information related to driving.
i Information
6RPHGULYLQJLQIRUPDWLRQVWRUHGLQWKH
WULSFRPSXWHUIRUH[DPSOH$YHUDJH
9HKLFOH6SHHGUHVHWVLIWKHEDWWHU\LV
GLVFRQQHFWHG
Trip modes
Fuel Economy

[Average Fuel Economy

[Instant Fuel Economy

Accumulated Info

[Tripmeter

[Average Fuel Economy

[Elapsed Time

Drive Info

[Tripmeter

[Average Fuel Economy

[Elapsed Time

Auto Stop (if equipped)

Digital Speedometer
OBC3050050
To change the trip mode, toggle the
", " switch on the steering wheel.
Fuel economy
OIK047124N
$YHUDJH)XHO(FRQRP\

[The average fuel economy is
calculated by the total driving distance
and fuel consumption since the last
average fuel economy reset.

[The average fuel economy can be
reset both manually and automatically.