screen HYUNDAI I20 2023 Owner's Manual

Page 214 of 649

5-73
05
2SHUDWLRQ7LSV
[ 7RNHHSGXVWRUXQSOHDVDQWIXPHV
from entering the vehicle through the
ventilation system, temporarily set the
air intake control to the recirculation
mode. Be sure to return the control
to fresh mode position when the
irritation has passed to keep fresh air
in the vehicle. This will help keep the
driver alert and comfortable.
[ 7RSUHYHQWLQWHULRUIRJRQWKH
windscreen, set the air intake control
to fresh mode and fan speed to
the desired position, turn on the
air conditioning system, and adjust
the temperature control to desired
temperature.
Air conditioning
HYUNDAI Air Conditioning Systems are
filled with R-134a or R-1234yf refrigerant.
1. Start the engine.
2. Push the air conditioning button.
3. Select the Face Level
mode.
4. Set the air intake control to
Recirculation mode temporarily to
allow the cabin to cool quickly. When
the desired temperature in the cabin is
reached, change the air intake control
back to Fresh mode.
5. Adjust the fan speed control and
temperature control to maintain
maximum comfort.
i Information
OBC3050052
<RXUYHKLFOHLVILOOHGZLWK5D
according to the regulation in your
FRXQWU\DWWKHWLPHRISURGXFWLRQ<RX
can find out which air conditioning
refrigerant is applied to your vehicle on
the label located in front of the engine
compartment.

Page 216 of 649

5-75
05
System maintenance
Climate control air filter
OIK047401L
[A] : Outside air, [B] : Recirculated air
[C] : Climate control air filter, [D] : Blower
[E] : Evaporator core, [F] : Heater core
The climate control air filter installed
behind the glove box filters the dust
or other pollutants that come into the
vehicle from the outside through the
heating and air conditioning system. If
dust or other pollutants accumulate in
the filter over a period of time, the air
flow from the air vents may decrease,
resulting in moisture accumulation
on the inside of the windscreen even
when the outside (fresh) air position is
selected.
If this happens, we recommend that the
climate control air filter be replaced by a
HYUNDAI authorised repairer.
i Information

Page 218 of 649

5-77
05
WARNING
Windscreen heating
Do not use the
or position
during cooling operation in extremely
humid weather. The difference
between the temperature of the
outside air and that of the windscreen
could cause the outer surface of the
windscreen to fog up, causing loss of
visibility. In this case, set the mode
selection knob or button to the

position and fan speed control knob or
button to lower speed.
[ )RUPD[LPXPGHIURVWSHUIRUPDQFH
set the temperature control knob
to the highest temperature setting
(rotated all the way to the right) and
the fan speed control to the highest
setting.
[ ,IZDUPDLUWRWKHIORRULVGHVLUHG
whilst defrosting or defogging, set the
mode to the floor-defrost position.
[ %HIRUHGULYLQJFOHDUDOOVQRZDQGLFH
from the windscreen, rear window,
outside rear view mirrors, and all side
windows.
[ &OHDUDOOVQRZDQGLFHIURPWKH
bonnet and air inlet in the cowl grill
to improve heater and defroster
efficiency and to reduce the
probability of fogging up inside of the
windscreen.
i Information
,IWKHHQJLQHWHPSHUDWXUHLVVWLOOFROGDIWHU
starting, then a brief engine warm up
period may be required for the vented air
flow to become warm or hot.
Manual climate control system
To defog inside windscreen
OBC3050118
1. Select any fan speed except
"0"position.
2. Select the desired temperature.
3. Select the
or position.
4. The outside (fresh) air will be selected
automatically. Additionally, the
air conditioning (if equipped) will
automatically operate if the mode is
selected to the
position.
If the air conditioning and outside
(fresh) air position are not selected
automatically, press the corresponding
button manually.
WINDSCREEN DEFROSTING AND DEFOGGING

Page 219 of 649

5-78
Convenient features
To defrost outside windscreen
OBC3050119
1. Set the fan speed to the highest
(extreme right) position.
2. Set the temperature to the extreme
hot position.
3. Select the
position.
4. The outside (fresh) air and air
conditioning (if equipped) will be
selected automatically.
Automatic climate control
system
To defog inside windscreen
OBC3050120R
1. Select desired blower speed.
2. Select desired temperature.
3. Press the defroster button (
).
4. The air-conditioning will turn on
according to the detected ambient
temperature, fresh mode and higher
blower speed will be selected
automatically.
If the air-conditioning, fresh mode and
higher blower speed are not selected
automatically, adjust the corresponding
button or knob manually.
If the
position is selected, lower
blower speed is controlled to higher
blower speed.

Page 220 of 649

5-79
05
To defrost outside windscreen
OBC3050121R
1. Set blower speed to the highest
position.
2. Set temperature to the extreme hot
(HI) position.
3. Press the defroster button (
).
4. The air-conditioning will turn on
according to the detected ambient
temperature and fresh mode will be
selected automatically.
If the
position is selected, lower
blower speed is controlled to higher
blower speed.
Auto defogging system (only
for automatic climate control
system, if equipped)
OBC3050124
Auto defogging helps reduce the
possibility of fogging up the inside of the
windscreen by automatically sensing the
moisture on inside the windscreen.
The auto defogging system operates
when the heater or air conditioning is on.
When the Auto Defogging
System operates, the indicator
will illuminate.
If a high amount of humidity is detected
in the vehicle, the Auto Defogging
System will be enabled.
The following steps will be performed
automatically:
Step 1) The A/C button will turn ON.
Step 2) The air intake control will change
to Fresh mode under low outside
temperature.
Step 3) The mode will be changed to
defrost to direct airflow to the
windscreen.
Step 4) The blower speed will be
increased.

Page 221 of 649

5-80
Convenient features
7RFDQFHORUUHVHWWKH$XWR'HIRJJLQJ
System
Press the front windscreen defroster
button for 3 seconds when the ignition
switch is in the ON position.
When the Auto Defogging System is
cancelled, defrost button indicator will
blink 3 times.
When the Auto Defogging System is
reset, defrost button indicator will blink
6 times without a signal.
i Information
:KHQWKHDLUFRQGLWLRQLQJLVWXUQHGRQE\
Auto defogging system, if you try to turn
off the air conditioning, the indicator will
blink 3 times and the air conditioning will
not be turned off.
7RPDLQWDLQWKHHIIHFWLYHQHVVDQG
HIILFLHQF\RIWKH$XWR'HIRJJLQJ6\VWHP
GRQRWVHOHFW5HFLUFXODWLRQPRGHZKLOVW
the system is operating.
:KHQWKH$XWR'HIRJJLQJ6\VWHPLV
operating, the blower speed adjustment
knob, the temperature adjustment knob,
and the air intake control button are all
disabled.
NOTICE
Do not remove the sensor cover
located at the top of the driver side
windscreen glass.
Damage to system parts could occur
and may not be covered by your vehicle
warranty.
Defroster
NOTICE
To prevent damage to the conductors
bonded to the inside surface of the rear
window, never use sharp instruments
or window cleaners containing
abrasives to clean the window.
i Information
,I\RXZDQWWRGHIURVWDQGGHIRJWKH
IURQWZLQGVFUHHQUHIHUWR

Page 228 of 649

5-87
05
USB charger (if equipped)
OBC3N051027AU
The USB charger is located inside the
FRQVROHER[EHWZHHQWKHGULYHUTVVHDW
DQGWKHIURQWSDVVHQJHUTVVHDW,QVHUW
the USB charger into the USB port, and
re-charge a smart phone or a tablet PC.
[ $FKDUJLQJVWDWXVFKDUJLQJFRPSOHWLRQ
message is displayed on a screen of a
smart phone or a tablet PC.
[ $VPDUWSKRQHRUDWDEOHW3&PD\
get warmer during the re-charging
process. It does not indicate any
malfunction with the charging system.
[ $VPDUWSKRQHRUDWDEOHW3&ZKLFK
adopts a different re-charging
method, may not be properly
re-charged. In this case, use an
exclusive charger of your device.
[ 7KHFKDUJLQJWHUPLQDOLVRQO\WR
re-charge a device. Do not use the
charging terminal either to turn ON an
audio or to play media on the AVN.
Wireless mobile phone charging
system (if equipped)
OBC3N050028
[A] : Charging pad
There is a wireless mobile phone charger
inside the front console.
The system is available when all doors
are closed, and when the ignition switch
is in the ON position.

Page 243 of 649

5-102
Convenient features
❈ The system’s actual appearance and layout may differ depending on the vehicle
model and specification.
„Type A
:LWKBluetoothp:LUHOHVV7HFKQRORJ\
(5) 6((.75$&.EXWWRQ
[Change the station/track/file.
[Whilst listening to the radio, press
and hold to search for a station.
[Whilst playing media, press and hold
to rewind or fast forward (except for
the Bluetooth audio mode).
(6) 0(18EXWWRQ&/2&.EXWWRQ
[Press to access the menu screen for
the current mode.
[Press and hold to access the time
setup screen.
(7) 781(NQRE),/(NQRE(17(5
EXWWRQ
[Whilst listening to the radio, turn to
adjust the frequency.
[Whilst playing media, turn to search
for a track/file (except for the
Bluetooth audio mode).
[Whilst searching by turning the
knob, press to select the current
track/file (except for the Bluetooth
audio mode).(8) 1XPEHUEXWWRQV 537a%$&.
[Whilst listening to the radio, press to
listen to a saved radio station.
[Whilst listening to the radio, press
and hold to save the current radio
station to the preset.
[In the USB/Bluetooth audio modes,
press the [537] button to change
the repeat play mode. Press the
[6+)/] button to change the
shuffle play mode.
[Press the [%$&.] button to return
to the previous screen (except for
the radio preset list).

Page 244 of 649

5-103
05
❈ The system’s actual appearance and layout may differ depending on the vehicle
model and specification.
„Type B
:LWKBluetoothp:LUHOHVV7HFKQRORJ\
(1) 6((.75$&.EXWWRQ
[Change the station/track/file.
[Whilst listening to the radio, press
and hold to search for a station.
[Whilst playing media, press and hold
to rewind or fast forward (except for
the Bluetooth audio mode).
(2) 0(18EXWWRQ&/2&.EXWWRQ
[Press to access the menu screen for
the current mode.
[Press and hold to access the time
setup screen.
(3) 781(NQRE),/(NQRE(17(5
EXWWRQ
[Whilst listening to the radio, turn to
adjust the frequency.
[Whilst playing media, turn to search
for a track/file (except for the
Bluetooth audio mode).
[Whilst searching by turning the
knob, press to select the current
track/file (except for the Bluetooth
audio mode).(4) $8',2EXWWRQ
[ Press to display the radio/media
mode selection window.
[When the mode selection window
displays, turn the [781(] knob to
select the desired mode and then
press the knob.
[When the Mode popup is not
selected in [0(18&/2&.] X 0RGH
SRSXS, press the [AUDIO] button
on the control panel to change the
mode. Each time you press the
[AUDIO] button on the control panel,
the mode switches to radio X media
in order.

Page 245 of 649

5-104
Convenient features
❈ The system’s actual appearance and layout may differ depending on the vehicle
model and specification.
„Type B
:LWKBluetoothp:LUHOHVV7HFKQRORJ\
(5) 3+21(EXWWRQ
[Press to start connecting a mobile
phone via Bluetooth.
[After a Bluetooth phone connection
is made, press to access the
Bluetooth phone menu.
(6) )$9EXWWRQ
[Whilst listening to the radio, press to
move to next page of the preset list.
(7) 3:5EXWWRQ92/NQRE
[Press to turn the system on or off.
[Turn to the left or right to adjust the
system sound volume.(8) 1XPEHUEXWWRQV 537a%$&.
[Whilst listening to the radio, press to
listen to a saved radio station.
[Whilst listening to the radio, press
and hold to save the current radio
station to the preset.
[In the USB/Bluetooth audio modes,
press the [537] button to change
the repeat play mode. Press the
[6+)/] button to change the
shuffle play mode.
[Press the [%$&.] button to return
to the previous screen (except for
the radio preset list).

Page:   < prev 1-10 11-20 21-30 31-40 41-50 51-60 61-70 ... 80 next >