buttons INFINITI QX50 2019 Quick Reference Guide

10
Heater and Air Conditioner (automatic)
The climate controls can be adjusted using the
buttons on either side of the lower display
and through the “CLIMATE” screen
on the
lower display.
•


To access the “CLIMATE” screen
, press the
CLIMATE button
below the lower display.
HEATED STEERING WHEEL (if so equipped)
To turn the heated steering wheel on or off, touch the
“Steering Heater” key
on the lower display.
REAR CONTROLS


•

A

djust the temperature up or down using the
temperature buttons
.
SYNC MODE SETTING
The driver’s, passenger’s and rear (if so equipped) temperature set points can
be synchronized touching the “SYNC” key
on the lower display. If the feature
is engaged, the rear temperature settings will synchronize with the driver’s and
passenger’s side settings. The temperature can then be controlled by using the
temperature control buttons
.
Please see your Owner’s Manual for important safety information, system limitations, and additional
operating and feature information.

15
If you have a compatible Bluetooth® device with
streaming audio (A2DP and AVRCP profiles), you can set
up a wireless connection between your Bluetooth
® device
and the in-vehicle audio system, enabling you to listen
to the audio from your device through the vehicle’s
audio system.
After connecting your Bluetooth
® device, press the
MEDIA button
on the control panel to switch to
Bluetooth® Streaming Audio.
For any Bluetooth
® connectivity issues, reboot your
cellular phone or device.
* Some jurisdictions prohibit the use of cellular telephones while driving.
Please see your INFINITI InTouch™ Owner’s Manual for important safety
information, system limitations, and additional operating and
feature information.
Bluetooth® Streaming Audio*HomeLink® Universal Transceiver
(if so equipped)
HomeLink
To program the HomeLink® Universal Transceiver:


1 .

P

osition the handheld transceiver 1-3 in (26-76 mm) away from the HomeLink
surface, keeping the HomeLink indicator light in view.


2 .

Pr

ess and hold the desired HomeLink button and the handheld transmitter
button simultaneously until the HomeLink indicator light flashes slowly and
then rapidly.
3

.



Bo

th buttons may now be released.


4 .

Pr

ess and hold the HomeLink button, and a blinking light that turns to a solid,
continuous light after 2 seconds will display.


5 .

A

t the receiver of the device press and release the program button (this button
can typically be found near the hanging antenna wire of the device you are
programing into HomeLink).
6.


Pr

ess and hold the programed HomeLink button for 2 seconds and release.
Please see your Owner’s Manual for important safety information, system limitations, and additional
operating and feature information.