circuit diagram ISUZU TF SERIES 2004 Workshop Manual

Page 1065 of 4264

ELECTRICAL-BODY AND CHASSIS 8A-407

CIRCUIT DIAGRAM ANTI THEFT WITH SUPER LOCK (RHD) Sheet 3/3








RTW48AXF024901

Page 1066 of 4264

8A-408 ELECTRICAL-BODY AND CHASSIS
CIRCUIT DIAGRAM (LHD) Sheet 1/2





RTW48AXF025001

Page 1067 of 4264

ELECTRICAL-BODY AND CHASSIS 8A-409

CIRCUIT DIAGRAM (LHD) Sheet 2/2





RTW48AXF025101

Page 1072 of 4264

8A-414 ELECTRICAL-BODY AND CHASSIS

CIRCUIT DIAGRAM





RTW48AXF028201

Page 1075 of 4264

ELECTRICAL-BODY AND CHASSIS 8A-417

CIRCUIT DIAGRAM



RTW48AXF012501

Page 1100 of 4264

8B-2 CRUISE CONTROL SYSTEM
Diagnosis ..........................................................................................................................................8B- 10
DTC Display Condition ............................................................................................................8B- 10
DTC Display Format .................................................................................................................8B- 11
Circuit Diagram ..........................................................................................................................8B- 11
DTC 1-1 Motor System Short Circuit ....................................................................................8B- 13
DTC 1-2 Clutch Open or Short Circuit .................................................................................8B- 14
DTC 1-3 Mechanical Defect ....................................................................................................8B- 15
DTC 1-4 Close Side of Motor System ..................................................................................8B- 16
DTC 2-1 Signal of Vehicle Speed Malfunction ..................................................................8B- 17
DTC 3-1 Turning On Switch at All time or at the same time ..........................................8B- 18

Page 1110 of 4264

8B-12 CRUISE CONTROL SYSTEM

CIRCUIT DIAGRAM



RTW48AXF003801

Page 1341 of 4264

ENGINE ELECTRICAL 6D – 3

GENERAL DESCRIPTION
GENERATOR STARTER MOTOR



066L300004065L300002

The basic charging system is the IC integral regulator charging system. The internal components are connected
electrically as shown in charging circuit diagram.
The generator features a solid state regulator that is mounted inside the generator. All regulator components are
enclosed into a solid mold, and this unit along with the brush holder assembly is attached to the slip ring end frame.
The generator voltage setting cannot be adjusted.
The starter motor circuit is composed of a 4-pole 4-brush type direct current series motor. The starter motor circuit
utilizes negative ground polarity.

Page 1342 of 4264

6D – 4 ENGINE ELECTRICAL

CHARGING CIRCUIT DIAGRAM





RTW46DSH005101


STARTING CIRCUIT DIAGRAM



RTW46DSH005501


Page 1371 of 4264

ENGINE ELECTRICAL 6D – 33
PRE-HEATING SYSTEM
INSPECTION AND REPAIR
Make the necessary adjustments, repairs, and part replacement if excessive wear of damage is discovered during
inspection.

VISUAL CHECK
Check the main fuses and glow indicator for damage.
Replace the part(s) if required.
GLOW RELAY
The glow relay is located in the relay box the engine
compartment.



825R300046




Use an ohmmeter to measure the resistance between
terminals No.2 and No.3.
If the measured value is outside the specified range, the
glow relay must be replaced.
Glow Relay Resistance Ohms
94  114

GLOW PLUG


LNW21KSH001401
Use a circuit tester to test the glow plugs for continuity.
Glow Plug Resistance (Reference) Ohms
Approximately 0.9

EGR SYSTEM 4JA1T (L)
Refer to 6F-9. (EGR system diagram)

Page:   < prev 1-10 ... 91-100 101-110 111-120 121-130 131-140 141-150 151-160 161-170 171-180 ... 180 next >