JAGUAR XFR 2010 1.G Workshop Manual
Page 2511 of 3039
Installation
1. CAUTION: Make sure that the wiring harnesses are
correctly located.
To install, reverse the removal procedure.
Page 2512 of 3039
Published: 11-May-2011
Handles, Locks, Latches and Entry Systems - Exterior Luggage Compartment Lid Release Switch
Removal and Installation
Removal
All vehicles
NOTE: Removal steps in this procedure may contain installation details.
1. Refer to: Luggage Compartment Lid Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).
2.
3. Torque: 3 Nm 4.
Page 2513 of 3039
Page 2514 of 3039
Published: 11-May-2011
Handles, Locks, Latches and Entry Systems - Exterior Rear Door Handle
Removal and Installation
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. NOTE: Remove the screw sufficiently, only to release the
component.
Torque: 4 Nm
2. NOTE: Some variation in the illustrations may occur,
but the essential information is always correct. www.JagDocs.com
Page 2515 of 3039
3. CAUTION: Take extra care not to damage the wiring
harnesses.
NOTE: Secure the connection in the service position.
4.
Page 2516 of 3039
Page 2517 of 3039
Handles, Locks, Latches and Entry Systems - Front Door Latch
Removal and Installation
Removal Published: 04-Feb-2013
1. Refer to: Front Door Window Glass (501-11 Glass, Frames and Mechanisms, Removal and Installation).
2. NOTE: Left-hand shown, right-hand similar.
Refer to: Exterior Front Door Handle (501-14 Handles, Locks, Latches and Entry Systems, Removal and Installation).
3. Refer to: Front Door Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).
4. NOTE: Right-hand shown, left-hand similar.
Page 2518 of 3039
5. NOTE: Left-hand shown, right-hand similar.
Torque: 7 Nm
6. NOTE: Left-hand shown, right-hand similar.
7. NOTE: Right-hand shown, left-hand similar.
Torque: 3 Nm
Page 2519 of 3039
8.
9.
10.
NOTE: Right-hand shown, left-hand similar.
Torque: 7 Nm
NOTE: Left-hand shown, right-hand similar.
NOTE: Do not disassemble further if the component is
removed for access only. www.JagDocs.com
Page 2520 of 3039
11.
12.
13.
14. NOTE: Note the position of the wiring harness.
NOTE: Some variation in the illustrations may occur,
but the essential information is always correct.