torque JAGUAR XFR 2010 1.G Workshop Manual
Page 1470 of 3039
Published: 11-May-2011
Automatic Transmission/Transaxle - TDV6 3.0L Diesel /V8 5.0L Petrol/V8 S/C 5.0L Petrol - Transmission Support Insulator V8 5.0L Petrol/V8 S/C 5.0L
Petrol
Removal and Installation
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. Refer to: Air Deflector (501-02 Front End Body Panels, Removal and Installation).
Installation
3. CAUTION: During this procedure the transmission
crossmember is removed, make sure the transmission is
correctly supported to avoid damaging associated
components.
Torque: 48 Nm
4. NOTE: Do not disassemble further if the component is
removed for access only.
Torque: 55 Nm
1. To install, reverse the removal procedure.
Page 1474 of 3039
12.
13.
14.
Make sure that the alignment mark is visible through
the inspection hole on removal of the last torque
converter bolt.
NOTE: Mark the position of the driveshaft on the
transmission flange.
Page 1477 of 3039
22.
23.
24.
CAUTION: Make sure that the torque converter
remains in the transmission.
NOTE: This step requires the aid of another
technician.
Install the torque converter retainer.
CAUTIONS:
Be prepared to collect escaping fluids.
Make sure that all openings are sealed. Use new
blanking caps.
Page 1479 of 3039
Installation
29.
NOTE: Some variation in the illustrations may occur,
but the essential information is always correct.
1. NOTE: Some variation in the illustrations may occur, but
the essential information is always correct.
2. Torque: 11 Nm
Page 1480 of 3039
3. Torque: 5 Nm 4.
5.
Clamp the hoses to minimize coolant loss.
6. CAUTIONS:
Be prepared to collect escaping fluids.
Make sure that all openings are sealed. Use new
blanking caps. www.JagDocs.com
Page 1481 of 3039
7. CAUTION: Make sure the torque converter is fully
located into the oil pump drive.
8. CAUTION: Make sure that the torque converter
remains in the transmission.
NOTE: Some variation in the illustrations may occur,
but the essential information is always correct.
Raise the powertrain assembly jack and transmission
assembly.
Page 1482 of 3039
9.
10.
11. NOTE: Transmission shown removed for clarity.
Torque: 48 Nm
Torque: 48 Nm
Torque: 48 Nm
Page 1483 of 3039
12. Torque: 45 Nm
13.
Remove the support.
14.
15. Torque: 110 Nm
CAUTION: Only rotate the crankshaft clockwise.
NOTE: Make sure that the alignment mark is visible
through the inspection hole as illustrated.
Torque: 63 Nm
Page 1485 of 3039
19.
20.
21.
Torque: 10 Nm
CAUTION: Install new o-ring seals
Torque: 10 Nm www.JagDocs.com
Page 1491 of 3039
12.
13.
14.
Make sure that the alignment mark is visible through
the inspection hole on removal of the last torque
converter bolt.
NOTE: Mark the position of the driveshaft on the
transmission flange.