JEEP WRANGLER 2007 JK / 3.G Owners Manual

Putting Up The Soft Top
1 — Header Bow 6 — Body Side Retainer
2 — 2 Bow 7 — Quarter Window
3 — 3 Bow 8 — Check Strap
4 — Sail Panel 9 — Front Retainer — Quarter Window
5 — Plastic Retainer 10 — Bottom Retainer — Quarter WindowUNDERSTANDING THE FEATURES OF YOUR VEHICLE 151
3

1 — Zipper Start
2 — Zipper Finish
3 — Swing Gate Bar
4 — Swing Gate Brackets
5 — Sail Panels 152 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

1. Unclip and move the sun visors to the side.
2. Install door frames, if removed. Refer to “Door Frame”
in this section.
3. Standing on the side of the vehicle, lift the top by the
side bow and the 2–bow (middle bow) up and over the
sports bar until the header rests on the top of the
windshield frame.
4. Before attaching the header latches, be sure that the
top retainers above the door are not trapped between the
top and the door frame.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 153
3

5. Open the header latches and engage the hook on each
side onto the windshield loops (do not close the latches).
6. If the swing gate brackets were removed, install them
by hooking the rear edge of the bracket on the interiorside of the body channel. Then, rotate it rearward and
over the channel until it snaps onto the exterior part of
the rail. To be properly located, the bracket must only be
clipped to the shortened rail edge.
154 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

7. Move to the rear of the vehicle and gently pull the sail
panels over the rear roof bow.
8. Partially install the sail panel retainers into the body
side channel, leaving the last three (3) inches towards therear window loose (on both sides). Pulling down on the
rear roof bow (3 bow) will aid to reach the channel with
the retainers.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 155
3

9. To install the side windows, affix the window tempo-
rarily by attaching to the Velcroin the rear corner. Start
the zipper but close only about 1 inch (2.5 cm).
10. Insert the front retainer of the window into the door
channel, making sure the retainer is fully seated andproperly positioned on the door frame. Failure to do so
can result in wind and water leaks or damage to the
window.
156 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

11. Continue closing the zipper only along the top edge
of the window.
12. Insert the retainer along the bottom edge of the
window into the bottom side channel, beginning at thefront and working to the rear of the vehicle. Finish by
closing the zipper completely and attaching the Velcro
along the top and rear of the window. Repeat this step for
the opposite side.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 157
3

13. Locate the black swing gate bar. Slide the swing gate
bar over the receiver at the bottom inside of the rear
window. The spongy part of the seal should be down and
pointed outward to seal with the swing gate when closed.14. Install the rear window by starting both zipper ends
at the lower left corner of the rear window opening.
Ensure that the zippers are properly started and aligned
before zipping to prevent damage.
15. Run the zipper fully around to the right side of the
window.
158 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

16. Grasp the swing gate bar and position it into the
swing gate brackets.
17. Apply downward pressure on the top corner of the
rear soft top bow (3 bow), then complete attaching the
sail panel retainers into the body side channel.18. Open the doors and insert the roof retainers into the
channels above the door, starting at the front and work-
ing rearward.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 159
3

19. Close the header latches and return the sun visors to
their secured position.SUNRIDER — 4 DOOR MODELS
NOTE:If you are going to be driving faster than 40 mph
(64 km/h) with the Sunrider feature open, it is recom-
mended that you remove the rear window of the vehicle.
160 UNDERSTANDING THE FEATURES OF YOUR VEHICLE