JEEP WRANGLER 2009 Owners Manual

3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 169

5. Insert the slider feature of the knuckles into the door
frame tracks and slide the top forward.6. Ensure that the top locks into the Sunrider
locking
mechanisms that are located above the front of the rear
doors.

3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 171

10. Open the header latches and engage the hook on each
side onto the windshield loops (do not close the latches).11. If the swing gate brackets were removed, install them
by hooking the rear edge of the bracket on the interior
side of the body channel. Then, rotate it rearward and
over the channel until it snaps onto the exterior part of
the rail. To be properly located, the bracket must only be
clipped to the shortened rail edge.

3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 173

13. To install the side windows, affix the window tem-
porarily by attaching it to the Velcroin the upper rear
corner. Start the zipper but close only about 1 in (2.5 cm). 14. Insert the front retainer of the window into the door
channel, making sure the retainer is fully seated and
properly positioned on the door frame. Failure to do so
can result in wind and water leaks or damage to the
window.

3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 175

16. Locate the black swing gate bar. Slide the swing gate
bar over the receiver at the bottom inside of the rear
window. The spongy part of the seal should be down and
pointed outward to seal with the swing gate when closed.

3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 177

21. Open the doors and insert the top retainers into the
channels in the door frame above the doors, starting at
the front and working toward the rear of the vehicle.22. Ensure the plastic retainer is tucked in properly at the
B-pillar and not pinching the seal.