JEEP WRANGLER 2016 JK / 3.G Owners Manual

CAUTION!
•Do not run a fabric top through an automatic car
wash. Window scratches and wax buildup may
result.
• Do not lower the top when the temperature is
below 41°F (5°C). Damage to the top may result.
• Do not lower the top when the windows are dirty.
Grit may scratch the window.
• Do not move your vehicle until the top has been
either fully attached to the windshield frame, or
fully lowered.
• Do not lower the top with the windows installed.
Window and top damage may occur.
• Refer to “Appearance Care for Fabric Top Models”
in “Maintaining Your Vehicle” for further informa-
tion. It contains important information on cleaning
and caring for your vehicle’s fabric top.
(Continued)
CAUTION! (Continued)
•Do not use any tools (screwdrivers, etc.) to pry or
force any of the clamps, clips, or retainers securing
the soft top. Do not force or pry the soft top
framework when opening or closing. Damage to
the top may result.
WARNING!
• Do not drive the vehicle with the rear window
curtain up unless the side curtains are also re-
moved. Dangerous exhaust gases could enter the
vehicle causing harm to the driver and passengers.
• The fabric upper doors and fabric top are designed
only for protection against the elements. Do not
(Continued)
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 259

WARNING!(Continued)
rely on them to contain occupants within the ve-
hicle or to protect against injury during an acci-
dent. Remember, always wear seat belts.
• Make sure hands and fingers are clear of all pinch
points when installing and removing the soft tops.
The zippers and side bows may cause serious
injury if fingers or hands get caught in between.
CAUTION!
Failure to follow these cautions may cause interior
water damage, stains or mildew on the top material:
• It is recommended that the top be free of water
prior to opening it. Operating the top, opening a
door or lowering a window while the top is wet
may allow water to drip into the vehicle’s interior.
(Continued)
CAUTION! (Continued)
•Careless handling and storage of the soft top may
damage the seals, causing water to leak into the
vehicle’s interior.
• The soft top must be positioned properly to ensure
sealing. Improper installation can cause water to
leak into the vehicle’s interior.
260 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

NOTE:Do not remove any of the three attachment knobs
unless you are planning on installing the hard top.Quick Steps For Lowering The Soft Top
1. Remove the side windows.
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 261

2. Remove the back window.
NOTE:Start zipper from the right side to remove back
window. 3. Release header latches from the windshield frame.
262 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

4. Release the sail panel retainers from the body sidechannel at the rear corners of the vehicle.
NOTE: When releasing the sail panel retainers, it is
helpful to pull down on the rear roof bow. 5. Fold the sail panels so that they rest on top of the soft
top.
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 263

6. Fold header rearward, pulling the fabric to the rear.7. Release Sunrider latch (both sides).
264 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

8. Open the swing gate and lower the top.NOTE:Ensure the fabric does not overhang the sides of
the vehicle.
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 265

Quick Steps For Raising The Soft Top
1. Open the swing gate and raise the top, engaging theSunrider latches (another person may be needed to
help with this operation).
266 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

2. Install rear corner panels.3. Rotate the header forward.
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 267

4. Engage the header latches.5. Install the back window.
268 UNDERSTANDING THE FEATURES OF YOUR VEHICLE