hood release JEEP WRANGLER UNLIMITED 2013 Owners Manual

WARNING! (Continued)• Keep Remote Keyless Entry (RKE) transmitters
away from children. Operation of the Remote Start
System, windows, door locks or other controls
could cause serious injury or death.
Remote Start Abort Message On Electronic Vehicle
Information Center (EVIC) — If Equipped
The following messages will display in the EVIC if the
vehicle fails to remote start or exits remote start pre-
maturely:
• Remote Start Aborted — Door Ajar
• Remote Start Aborted — Hood Ajar
• Remote Start Aborted — Fuel Low
• Remote Start Aborted — L/Gate Ajar
• Remote Start Aborted — System Fault The EVIC message stays active until the ignition is turned
to the ON/RUN position.
To Enter Remote Start
Press and release the REMOTE START button
on the RKE transmitter twice within five sec-
onds. The vehicle doors will lock, the parking
lights will flash and the horn will chirp twice
(if programmed). Then, the engine will start and the
vehicle will remain in the Remote Start mode for a
15-minute cycle.
NOTE:
• The park lamps will turn on and remain on during
Remote Start mode.
• For security, power window operation is disabled
when the vehicle is in the Remote Start mode. 2 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 29

• The engine can be started two consecutive times (two
15-minute cycles) with the RKE transmitter. However,
the ignition switch must be cycled to the ON/RUN
position before you can repeat the start sequence for a
third cycle.
Remote start will also cancel if any of the following occur:
• The engine stalls or RPM exceeds 2500
• Any engine warning lamps come on
• The hood is opened
• The hazard switch is pressed
• The transmission is moved out of PARK
• The brake pedal is pressed To Exit Remote Start Mode Without Driving The
Vehicle
Press and release the REMOTE START button one time or
allow the engine to run for the entire 15-minute cycle.
NOTE: To avoid unintentional shut downs, the system
will disable the one time press of the REMOTE START
button for two seconds after receiving a valid Remote
Start request.
To Exit Remote Start Mode And Drive The Vehicle
Before the end of the 15-minute cycle, press and release
the UNLOCK button on the RKE transmitter to unlock
the doors and disarm the Vehicle Security Alarm (if
equipped). Then, insert the key into the ignition switch
and turn the switch to the ON/RUN position.
NOTE: The ignition switch must be in the ON/RUN
position in order to drive the vehicle.30 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE

TO OPEN AND CLOSE THE HOOD
Release both the hood latches.
Raise the hood and locate the safety latch, located in the
middle of the hood opening. Push the latch to the left side
of the vehicle, to open the hood. You may have to push down slightly on the hood before pushing the safety
latch. Insert the support rod into the slot on the hood.
To close the hood, remove the support rod from the hood
panel and place it in the retaining clip. Lower the hood
slowly. Secure both of the hood latches.
WARNING!Be sure the hood is fully latched before driving your
vehicle. If the hood is not fully latched, it could open
when the vehicle is in motion and block your vision.
Failure to follow this warning could result in serious
injury or death.Hood Latch166 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

With Tip Start – Automatic Transmission Only
If the engine fails to start after you have followed the
“Normal Starting” or “Extreme Cold Weather” proce-
dures, it may be flooded. To clear any excess fuel, push
the accelerator pedal all the way to the floor and hold it.
Then, turn the ignition switch to the START position and
release it as soon as the starter engages. The starter motor
will disengage automatically in 10 seconds. Once this
occurs, release the accelerator pedal, turn the ignition
switch to the LOCK position, wait 10 to 15 seconds, then
repeat the “Normal Starting” procedure.
CAUTION!To prevent damage to the starter, wait 10 to 15 sec-
onds before trying again.
After Starting
The idle speed is controlled automatically and it will
decrease as the engine warms up. ENGINE BLOCK HEATER — IF EQUIPPED
The engine block heater warms the engine, and permits
quicker starts in cold weather. Connect the cord to a
standard 110-115 Volt AC electrical outlet with a
grounded, three-wire extension cord.
The engine block heater must be plugged in at least one
hour to have an adequate warming effect on the engine.
The engine block heater cord is found under the hood
bundled in front of the battery tray.
WARNING!Remember to disconnect the engine block heater
cord before driving. Damage to the 110-115 Volt AC
electrical cord could cause electrocution.
5 STARTING AND OPERATING 413

MOPAR  Spray White Lube or equivalent to assure
quiet, easy operation and to protect against rust and
wear. Prior to the application of any lubricant, the parts
concerned should be wiped clean to remove dust and
grit; after lubricating excess oil and grease should be
removed. Particular attention should also be given to
hood latching components to ensure proper function.
When performing other underhood services, the hood
latch, release mechanism and safety catch should be
cleaned and lubricated.
The external lock cylinders should be lubricated twice a
year, preferably in the Fall and Spring. Apply a small
amount of a high quality lubricant, such as MOPAR 
Lock Cylinder Lubricant or equivalent directly into the
lock cylinder. Windshield Wiper Blades
Clean the rubber edges of the wiper blades and the
windshield periodically with a sponge or soft cloth and a
mild nonabrasive cleaner. This will remove accumula-
tions of salt or road film.
Operation of the wipers on dry glass for long periods
may cause deterioration of the wiper blades. Always use
washer fluid when using the wipers to remove salt or dirt
from a dry windshield.
Avoid using the wiper blades to remove frost or ice from
the windshield. Keep the blade rubber out of contact with
petroleum products such as engine oil, gasoline, etc.
NOTE: Life expectancy of wiper blades varies depending
on geographical area and frequency of use. Poor perfor-
mance of blades may be present with chattering, marks,
water lines or wet spots. If any of these conditions are
present, clean the wiper blades or replace as necessary.
7 MAINTAINING YOUR VEHICLE 573

Heated Seats ............................ .159
Heater ................................ .392
Heater, Engine Block ...................... .413
High Beam Indicator ...................... .301
Hill Descent Control ...................... .470
Hill Descent Control Indicator ............... .470
Hill Start Assist .......................... .458
Hitches
Trailer Towing ........................ .518
Hood Release ........................... .166
Ignition .................................14
Key .................................14
Ignition Key Removal .......................14
Illuminated Entry ..........................21
Immobilizer (Sentry Key) ....................16
Infant Restraint ...........................76
Inflation Pressure Tires .................... .483
Information Center, Vehicle ................. .321 Inside Rearview Mirror .....................111
Instrument Cluster ....................... .299
Instrument Panel and Controls ............... .298
Instrument Panel Lens Cleaning .............. .595
Integrated Power Module (Fuses) ............. .598
Interior Appearance Care ................... .594
Interior Lights .......................... .171
Intermittent Wipers (Delay Wipers) ............ .174
Introduction ..............................4
Inverter, Power .......................... .186
Jacking Instructions ....................... .543
Jack Location ........................... .541
Jack Operation .......................... .540
Jump Starting ........................... .548
Key-In Reminder ..........................16
Keyless Entry System .......................22
Key, Programming .........................18
10 INDEX 641

Rear Window Features .................... .293
Rear Wiper/Washer ....................... .293
Recorder, Event Data .......................75
Recreational Towing ...................... .532
Shifting into Transfer Case Neutral (N) ...... .534
Shifting out of Transfer Case Neutral (N) ..... .536
Reformulated Gasoline .................... .507
Refrigerant ............................. .572
Release, Hood ........................... .166
Reminder, Seat Belt .........................59
Remote Control
Door Locks ............................22
Starting System .........................28
Remote Keyless Entry (RKE) ..................22
Remote Sound System (Radio) Controls ........ .389
Remote Starting System ......................28
Replacement Bulbs ....................... .606
Replacement Keys .........................17
Replacement Parts ........................ .564 Replacement Tires ........................ .491
Reporting Safety Defects ................... .629
Resetting Oil Change Indicator ............... .325
Restraint, Head .......................... .160
Restraints, Child ...........................76
Restraints, Occupant ........................45
Rotation, Tires .......................... .494
Safety Checks Inside Vehicle ................ .101
Safety Checks Outside Vehicle ............... .103
Safety Defects, Reporting ................... .629
Safety, Exhaust Gas ....................... .100
Safety Information, Tire .................... .471
Safety Tips ...............................99
Satellite Radio Antenna .................... .352
Schedule, Maintenance .................... .614
Seat Belt Maintenance ..................... .595
Seat Belt Reminder .........................59
Seat Belts ................................48646 INDEX