KIA CARNIVAL 2007 Workshop Manual

SEAT BACK FRAME REPLACEMENT
1.Remove the following items.
a. Recliner cover.
b. Seat back panel.
c. Headrest guide.
d. Seat back cover.
2. Remove the pad (A) from frame (B).
a.Remove the side air bag for replacing side air bag installation seat.
b. Be fore service, be fully aware of precautions and service procedure relevant to air bag (See page RT -
Airbag).
3.Installation is the reverse of removal.
SEAT TRACK REPLACEMENT
1.Remove the recliner cover.
2. Remove the seat cushion cover.
3. Remove the seat track (A).

4.Installation is the reverse of removal.
SEAT BACK HEATER REPLACEMENT
1.Remove the seat back cover.
2. Cut the heater (A) attached to the pad (B), as shown in the picture.
3. Take off the paper from the backside of the heater assembly.
4. Attach the heater to the main part of pad.
5. Install the seat back cover.
SEAT CUSHION HEATER REPLACEMENT
1.Remove the seat back cover.
2. Cut the heater (A) attached to the pad (B), as shown in the picture.
3. Take off the paper from the backside of the heater assembly.
4. Attach the heater to the main part of pad.
5. Install the seat back cover.

2007 > 2.7L V6 GASOLINE >
COMPONENTS
SECONDARY SEAT
THIRD SEAT

2007 > 2.7L V6 GASOLINE >
REPLACEMENT
SECONDARY SEAT
REMOVEAL
1. Slide the seat to the rearward.
2. Back seat folding.
3.Remove the seat assembly (B) after pressing the lever(A).
INSTALLATION
1.Back seat folding.
2.Slide the seat to the rearward.

3.Lift the back side of the seat.
4.Arrange the seat to the rear side of the strike by using the roller.
5.Turn the seat to the forward at an angle of about 81 degrees for locking between the plate and striker.
6.Turn the seat to the rearward for locking between the rear latch and striker.

7.Uufold the back of the seat.
8.The leg cover hole color must be discolored to green.
RECLINER COVER REPLACEMENT
1.Remove the recliner lever(B) and cover (A).

2.Loosen the mounting bolts, then remove the seat back assembly (A).
3. Disconnect the auto tumble cable(B).
SEAT BACK COVER REPLACEMENT
1.Remove the recliner cover.
2. Remove the cover (A).
3. After the armrest mounting bolt, then remove the armrest (B).
4.Remove the seat back panel (A).

5.Remove the hog- ring clips (A).
6.Remove the headrest and headrest guide.
7. After removing the hog- ring clips (A) on the front of seat back remove the seat back cover (B).
8.Installation is the reverse of removal.
a.To prevent wrinkles, make sure the material is stretched evenly over the cover (A) before securing the
hogring clips (B)
b. Replace the hogring clips with new ones using special tool (C).