KIA CARNIVAL 2007 Workshop Manual
Page 1421 of 1575
Windshield Wiper / Washer
Page 1422 of 1575
2007 > 2.7L V6 GASOLINE >
COMPONENT LOCATION
Page 1423 of 1575
Windshield Wiper-Washer Switch
Page 1424 of 1575
2007 > 2.7L V6 GASOLINE >
REPLACEMENT
1.Remove the steering column upper and lower shrouds (A) after removing 3 screws.
2.Remove the wiper switch (A) by pushing the lock pin (B) after disconnecting the connector.
[LHD]
[RHD]
3.Installation is the reverse of removal.
INSPECTION
Check for continuity between the terminals while operating the wiper and washer switch. If it is not normal condition,
replace wiper and wiper switch.
[LHD]
Page 1425 of 1575
[RHD]
WIPER SWITCH
WASHER SWITCH
Page 1426 of 1575
Front Wiper Motor
Page 1427 of 1575
2007 > 2.7L V6 GASOLINE >
COMPONENT LOCATION
Page 1428 of 1575
2007 > 2.7L V6 GASOLINE >
REMOVAL
1.Remove the windshield wiper arm and blade after removing the mounting nut (A).
TORQUE: 28~32 Nm (2.8~3.2 kgf.m, 20~23.1 lbf.ft)
2.Remove the weather strip and the cowl top cover (A) after removing 4 fasteners.
3.Remove the windshield wiper motor and linkage assembly after removing 4 bolts. Disconnect the wiper motor
connector (A) and windshield deicer connector (B) from the wiper motor & linkage assembly.
Torque: 7 - 11Nm (0.7- 1.1, kgf.m, 5.0 - 7.9 lbf.ft)
4.Installation is the reverse of removal.
INSTALLATION
1.Install the wiper arm and blade to the specified position.
Specified position AB
Page 1429 of 1575
Distance[in (mm)]1.57+0.19/0
(40+5/0) 1.57+0.19/0
(40+5/0)
2. Set the washer nozzle on the specified spray position.
INSPECTION
SPEED OPERATION CHECK
1. Remove the connector from the wiper motor.
2. Attach the positive (+) lead from the battery to terminal 4 and the negative ( - ) lead to terminal 1.
3. Check that the motor operates at low speed.
4. Connect the positive (+) lead from the battery to terminal 5 and the negative ( - ) lead to terminal 1.
5. Check that the motor operates at high speed.
Page 1430 of 1575
Front Washer Motor