starter KIA CARNIVAL 2007 Owner's Manual

13.Tighten the transaxle mounting bolts (A).
TORQUE:
65~85 Nm(6.5~8.5 kgf.m, 47.0~61.5 lb - ft)
14.Remove the SST (09200- 38001) holding the engine and transaxle assembly.
15.Install the starter motor. (see EE group).
TORQUE:
65~85 Nm(6.5~8.5 kgf.m, 47.0~61.5 lb - ft)
16. Connect the power steering pressure tube (A) to the power steering oil pump.

2007 > 2.7L V6 GASOLINE >
REPLACEMENT
1.Pull up the parking brake.
2. Position the shift lever in 'N' range.
3. Remove the air cleaner assembly.
4. Remove the battery.
5. Remove the battery tray.
6. Remove the inhibiter switch connector.
7. Remove the shift cable mounting nut(A).
8.Remove the inhibiter switch loosening the mounting bolts.
9. Refering to 'INSPECTION', check for continuity. If there is an error, replace the inhibiter switch.
10. After tightening the shift cable mounting nut, connect the inhibiter switch.
11. Install the battery, battery tray and the air cleaner assembly.
INSPECTION
1.Check for the starter motor when the ignition switch is at 'START' position and the shift lever at 'P' or 'N' range.
2. Check for the rear lamp when the ignition switch if it does not work properly.
3. Check for the inhibiter switch if it does not work properly.
4. If the inhibiter switch is not fixed in a proper position, reassemble it in the right position.
5. Re- check 1 and 2 procedures.
6. Using a scan tool, confirm the DTCs.
7. Disconnect the battery ( - ) terminal and the inhibiter switch.
8. Check for continuity between terminals at the switch connector.

30.Remove the starter motor cover(A).
31.Disconnect the starter motor connector and remove the starter motor(A). (see EE group)
32.Remove the mounting bolts(A) of lower part of the transaxle, and remove the transaxle assembly by supporting it
with a jack.
INSTALLATION
1.Lowering the vehicle or lifting up a jack, install the transaxle assembly.

2.Tighten the transaxle under mounting bolts.
TORQUE:
65~85 Nm(6.5~8.5 kgf.m, 47.0~61.5 lb - ft)
3.Install the starter motor(A) and connect the starter motor connector. (see EE group)
TORQUE:
65~85 Nm(6.5~8.5 kgf.m, 47.0~61.5 lb - ft)
4.install the starter motor cover(A).
5.install the side cover(A).