Lexus GS300h 2013 Owner's Manual

2003-3. Adjusting the seats
GS450h_300h_OM_OM30D53E_(EE)
If the front passenger’s door is opened while the vehicle is
stopped, the adjusted lumbar support, ottoman (if equipped), etc.
will return to its original position.
Operation of the power easy access system
When exiting the vehicle, the power easy access system may not operate if
the seat is already close to the rearmost position, etc.
Customization
The seat movement amount settings of the power easy access system can be
customized. (Customizable features: P. 942)
Your preferred driving position (the position of the driver’s seat,
steering wheel and outside rear view mirrors) can be recorded and
recalled by pressing a button.
Three different driving positions can be recorded into memory.
Recording procedure
Check that the shift lever is in P.
Turn the power switch to ON mode.
Adjust the driver’s seat, steering wheel, and outside rear view
mirrors to the desired positions.
While pressing the “SET”
button, or within 3 seconds
after the “SET” button is
pressed, press button “1”,
“2” or “3” until the buzzer
sounds.
If the selected button has
already been preset, the previ-
ously recorded position will be
overwritten.
Driving position memory
1
2
3
4

2013-3. Adjusting the seats
3
Operation of each component
GS450h_300h_OM_OM30D53E_(EE)
Vehicles with the driving position memory for the front passen-
ger’s seat: To record the position of the front passenger’s seat,
adjust the front passenger’s seat to the desired position and per-
form step using the buttons on the front passenger’s side.
4

2023-3. Adjusting the seats
GS450h_300h_OM_OM30D53E_(EE)
Recall procedure
Check that the shift lever is in P.
Turn the power switch to ON mode.
Press one of the buttons for
the driving position you
want to recall until the
buzzer sounds.
Vehicles with front passenger’s
seat ottoman:
The recorded position will only
be recalled if the ottoman is in a
position higher than the
recorded position. It will not
move in an upward direction.
To stop the position recall operation part-way through
Perform any of the following:
Press the “SET” button.
Press button “1”, “2” or “3”.
Operate any of the seat adjustment switches (only cancels seat position
recall).
Operate the tilt and telescopic steering control switch (only cancels steering
wheel position recall).
Seat positions that can be memorized (P. 194)
Vehicles without seatback side support adjustment switch
The adjusted positions other than the position adjusted by lumbar support
switch can be recorded.
Vehicles with seatback side support adjustment switch
All adjusted positions can be recorded.
Automatic ottoman adjustment (if equipped)
While the recorded position is being recalled, if it appears that the front edge
of the cushion will touch the area surrounding the instrument panel, the otto-
man will be automatically stowed.
1
2
3

2033-3. Adjusting the seats
3
Operation of each component
GS450h_300h_OM_OM30D53E_(EE)
Operating the driving position memory after turning the power switch off
Driver’s seat:
Recorded seat positions can be activated up to 180 seconds after the driver’s
door is opened and another 60 seconds after it is closed again.
Front passenger’s seat:
Recorded seat positions can be activated up to 180 seconds after the front
passenger’s door is opened.
In order to correctly use the driving position memory function
If a seat position is already in the furthest possible position and the seat is
operated in the same direction, the recorded position may be slightly differ-
ent when it is recalled.
Each electronic key (including a card key) can be registered to
recall your preferred driving position.
Registering procedure
Record your driving position to button “1”, “2” or “3” before
performing the following:
Carry only the key you want to register, and then close the
driver’s door.
If 2 or more keys are in the vehicle, the driving position cannot
be recorded properly.
Check that the shift lever is in P.
Turn the power switch to ON mode.
Recall the driving position that you want to record.
Memory recall function (driver’s side only)
1
2
3

2043-3. Adjusting the seats
GS450h_300h_OM_OM30D53E_(EE)
While pressing the recalled
button, press and hold the
door lock switch (either
lock or unlock) until the
buzzer sounds.
If the button could not be regis-
tered, the buzzer sounds contin-
uously for approximately 3
seconds.
Recall procedure
Carry the electronic key that has been registered to the driving
position, and then unlock and open the driver’s door using the
smart entry & start system or wireless remote control.
The driving position will move to the recorded position (not including
the steering wheel). However, the seat will move to a position slightly
behind the recorded position in order to make entering the vehicle eas-
ier.
If the driving position is in a position that has already been recorded,
the seat and outside rear view mirrors will not move.
Turn the power switch to ACCESSORY mode or ON mode, or
fasten a seat belt.
The seat and steering wheel will move to the recorded position.
4
1
2

2053-3. Adjusting the seats
3
Operation of each component
GS450h_300h_OM_OM30D53E_(EE)
Cancelation procedure
Carry only the key you want to cancel and then close the driver’s
door.
If 2 or more keys are in the vehicle, the driving position cannot
be canceled properly.
Turn the power switch to ON mode.
While pressing the “SET” button, press and hold the door lock
switch (either lock or unlock) until the buzzer sounds twice.
If the button could not be canceled, the buzzer sounds continuously for
approximately 3 seconds.
Recalling the driving position using the memory recall function
Different driving positions can be registered for each electronic key. There-
fore, the driving position that is recalled may be different depending on the
key being carried.
If a door other than the driver’s door is unlocked with the smart entry &
start system, the driving position cannot be recalled. In this case, press the
driving position button which has been set.
Customization
The unlock door settings of the memory recall function can be customized.
(Customizable features: P. 942)
CAUTION
Seat adjustment caution
Take care during seat adjustment so that the seat does not strike the rear
passenger or squeeze your body against the steering wheel.
1
2

2063-3. Adjusting the seats
GS450h_300h_OM_OM30D53E_(EE)
Head restraints
Vertical adjustment
Up
Pull the head restraints up.
Down
Push the head restraint down while
pressing the lock release button.
Head restraints are provided for all seats.
Front seats
Lock release but-
1
2
Horizontal adjustmentSide support adjustment
The position of the head restraint
can be adjusted forward in 4
stages.
If the head restraint is pulled for-
ward from the foremost position, it
will return to the rearmost posi-
tion.

2073-3. Adjusting the seats
3
Operation of each component
GS450h_300h_OM_OM30D53E_(EE)
Up
Pull the head restraints up.
Down
Push the head restraint down while
pressing the lock release button.
Removing the head restraints
Installing the head restraints
Front seats
Rear seats
Rear seats
Lock release but-
1
2
Pull the head restraint up while pressing
the lock release button.
Align the head restraint with the installa-
tion holes and push it down to the lock
position.
Press and hold the lock release button
when lowering the head restraint.
Align the head restraint with the installa-
tion holes and push it down to the lowest
lock position while pressing the lock
release button.
Lock release but-
Lock release but-
Lock release but-

2083-3. Adjusting the seats
GS450h_300h_OM_OM30D53E_(EE)
Adjusting the height of the head restraints
Adjusting the rear seat head restraint
Always raise the head restraint one level from the stowed position when
using. Make sure that the head restraints are
adjusted so that the center of the head
restraint is closest to the top of your ears.
CAUTION
Head restraint precautions
Observe the following precautions regarding the head restraints. Failure to
do so may result in death or serious injury.
Use the head restraints designed for each respective seat.
Adjust the head restraints to the correct position at all times.
After adjusting the head restraints, push down on them and make sure
they are locked in position.
Do not drive with the head restraints removed.

207
3 3-4. Adjusting the steering wheel and mirrors
Operation of each component
GS450h_300h_OM_OM30D53E_(EE)
Steering wheel
Operating the switch moves the steering wheel in the following
directions:
Up
Down
Toward the driver
Away from the driver
The steering wheel can be adjusted when
The power switch is in ACCESSORY or ON mode
*.
*: If the driver’s seat belt is fastened, the steering wheel can be adjusted
regardless of power switch mode.
Automatic adjustment of the steering position
A desired steering position can be entered to memory and recalled automati-
cally by the driving position memory system. (P. 199)
Power easy access system
The steering wheel and driver’s seat move in accordance with power switch
mode and the driver’s seat belt condition. (P. 199)
Adjustment procedure
1
2
3
4
CAUTION
Do not adjust the steering wheel while driving.
Doing so may cause the driver to mishandle the vehicle and cause an acci-
dent, resulting in death or serious injury.