Lexus IS300 2004 Electrical Components / LEXUS 2004 IS300 OWNER'S MANUAL (OM53461U)

ELECTRICAL COMPONENTS
387
The inside of the lens of exterior lights such as headlights may
temporarily
fog up when the lens becomes wet in the rain or in
a car wash. This is not a problem because the fogging is
caused by the temperature dif ference between the outside and
inside of the lens, just like the windshield fogged up in the rain.
However, if there is a large drop of water on the inside of the
lens, or if there is water pooled inside the light, contact your
Lexus dealer. LIGHT LOCATION
SV64032
Light Bulbs
Bulb No. W Type
1Headlights (High beam) HB3 60 A
2Parking lights 168 5 E
3Headlights (Low beam) D2R 35 B
4Front fog lights --- 55 C
5Front turn signal lights --- 21 D
6Front side marker lights 194 3.8 E
03 07.09

ELECTRICAL COMPONENTS
388Sedan
SV64013
Light Bulbs
Bulb No. W Type
1High mounted stop light 921 18 E
2License plate lights 168 5 E
3Tail/stop lights 7443 5/21 E
Rear fog lights 7440 21 E
4Back-up lights7440 21 E
5Rear turn signal lights --- 21 G
6Rear side marker lights 194 3.8 E
7Tail/stop lights 7443 5/21 E
8Trunk light 194 3.8 E SportCross
SV64026
Light Bulbs
Bulb No. W Type
1Tail/stop lights 7443 5/21 E
2Rear side marker lights 194 3.8 E
3Rear turn signal lights --- 21 D
4Back-up lights 921 18 E
5Tail/stop lights7443 5/21 E
Rear fog lights 7440 21 E
6License plate lights 168 5 E
7Luggage compartment light --- 5 F
03 07.09

ELECTRICAL COMPONENTS
389
SV64012
Light BulbsBulb No. W Type
1Front personal lights
with moon roof --- 10 H
without moon roof --- 8 H
2Vanity lights --- 3 F
3Glove box light--- 1.2 E
4Door courtesy lights 194 3.8 E
5Interior light --- 8 F A: HB3 halogen bulbs
B: D2R discharge bulbs
C: H3 halogen bulbs
D: Wedge base bulbs (amber)
E: Wedge base bulbs
F: Double end bulbs
G: Single end bulbs (amber)
H: Single end bulbs
03 07.09

ELECTRICAL COMPONENTS
390
03 07.09

SECTION 6 ± 5
391
SERVICE PROCEDURES AND
SPECIFICATIONS
Body
Specifications (Sedan)392
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .\
. . . . . . . . . . . . . . . . . . . . . . . . .
Specifications (SportCross) 393
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .\
. . . . . . . . . . . . . . . . . . . . .
Protecting your vehicle from corrosion 394
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .\
. . . . . . . . . . .
Washing and waxing 395
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .\
. . . . . . . . . . . . . . . . . . . . . . . . . . .
Cleaning the interior 397
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .\
. . . . . . . . . . . . . . . . . . . . . . . . . . .
Rain clearing mirrors 400
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .\
. . . . . . . . . . . . . . . . . . . . . . . . . .
03 07.09

BODY
392
SPECIFICATIONS (Sedan)
- DIMENSIONS AND WEIGHTOverall length
4485 mm (176.6 in.)
Overall width1725 mm (67.9 in.)
Overall height1410 mm (55.5 in.)*
Wheelbase2670 mm (105.1 in.)
Tread - Front - Rear1495 mm (58.9 in.)
1485 mm (58.5 in.)
Vehicle capacity weight (occupants + cargo)390 kg (860 lb.)
*Unladen vehicle
- FUEL TANK
Capacity
66 L (17.5 gal., 14.5 lmp.gal.)
03 07.09

BODY
393
SPECIFICATIONS (SportCross)
- DIMENSIONS AND WEIGHTOverall length
4495 mm (177.0 in.)
Overall width1725 mm (68.0 in.)
Overall height1430 mm (56.3 in.)*
Wheelbase2670 mm (105.1 in.)
Tread - Front - Rear1495 mm (58.9 in.)
1475 mm (58.1 in.) (with the 225/45ZR17 tires)
1485 mm (58.5 in.) (except the 225/45ZR17 tires)
Vehicle capacity weight (occupants + cargo)390 kg (860 lb.)
*Unladen vehicle
- FUEL TANK
Capacity
66 L (17.5 gal., 14.5 lmp.gal.)
03 07.09

BODY
394
PROTECTING YOUR VEHICLEFROM CORROSION
Proper care of your Lexus can help ensure long-term
corrosion prevention.
The most common causes of corrosion to your vehicle
are:

The accumulation of road salt, dirt and moisture in
hard-to-reach areas under the vehicle.

Chipping of paint or undercoating caused by minor
accidents or by stones and gravel.
The following conditions will cause or accelerate
corrosion of your vehicle, so it is important to keep your
vehicle, particularly the underside, as clean as possible
and to repair any damage to paint or protective coatings
as soon as possible.

The presence of road salt or dust control chemicals, salt in
the air near the sea coast, industrial air pollution.

High humidity, especially at temperatures just above
freezing point.

Certain parts of your vehicle are wet or damp for an
extended period of time, even though other parts of the vehicle are dry.

Components of the vehicle which are prevented from
quick-drying due to lack of proper ventilation are exposed to high ambient temperature. To help prevent corrosion on your Lexus, follow these
guidelines:
Keep your vehicle clean by regular washing.
In addition,
observe the following points.

If you drive on salted roads in the winter or if you live near
the ocean, you should hose off the undercarriage at least
once a month to minimize corrosion.

High pressure water or steam is effective for cleaning the
vehicle's underside and wheel housings. Pay particular
attention to these areas as it is difficult to see all the mud and
dirt. It will do more harm than good to simply wet the mud
and debris without removing. The lower edge of doors,
rocker panels and frame members have drain holes which
should not be allowed to clog with dirt as trapped water in these areas can cause corrosion.

Wash the underside of the vehicle thoroughly when winter
is over.
See ºWashing and waxingº on page 395 for more tips.
Check the c ondition of your vehicle's paint and trim. If you
find any chips or scratches in the paint, touch them up
immediately to prevent corrosion from starting. If the chips or
scratches have gone through the bare metal, have a qualified
body shop make the repair.
03 07.09

BODY
395
Check the interior of your vehicle. Water and dirt can
accumulate under the floor mats and could cause corrosion.
Occasionally check under the mats to make sure the area is
dry. Be particularly careful when transporting chemicals,
cleansers,
fertilizers, salt, etc. These should be transported in
proper containers. If a spill or leak should occur, immediately
clean and dry the area.
Keep your vehicle in a well ventilated garage or a roofed
place. Do not park your vehicle in a damp, poorly
ventilated garage. If you wash your vehicle in the garage, or
if you drive it covered with water or snow, your garage may be
so damp and it will cause corrosion. Even if your garage is
heated, a wet vehicle can corrode if the ventilation is poor.
WASHING AND WAXING
Washing your Lexus
Keep your vehicle clean by regular washing.
The following cases may cause weakness to the paint or
corrosion to the body and parts. Wash your vehicle as soon
as possible.

When driving in a coastal area

When driving on a road sprinkled with antifreeze

When having coal tar, tree sap, bird droppings and carcass
of an insect

When driving in the areas where there is a lot of smoke,
soot, dust, iron dust and chemical substances

When the vehicle becomes remarkably dirty with dust and
mud
Hand-washing your Lexus
Work in the shade and wait until the vehicle body is not hot
to the touch.
1. Rinse off loose dirt with a hose. Remove any mud or road
salt from the underside of the vehicle or in the wheel wells.
2. Wash with a mild car-wash soap, mixed according to the
manufacturer's instructions. Use a soft cotton mitt and keep
it wet by dipping it frequently into the wash water. Do not rub
hard - let the soap and water remove the dirt.
03 07.09

BODY
396Plastic wheel ornaments:
The plastic wheel ornaments are
damaged easily by organic substances. If any organic
substance splashes an ornament, be sure to wash it off with
water and check if the ornament is damaged.
CAUTION
Do not attach the heavily damaged plastic wheel
ornament. It may fly off the wheel and cause accidents
while the vehicle is moving.
Aluminum wheels: Use only a mild soap or neutral detergent.
Urethane bumpers and side moldings: Wash carefully. Do
not scrub with abrasive cleaners. The bumper and side
molding faces are soft.
Road tar: Remove with turpentine or cleaners that are marked
safe for painted surfaces.
NOTICE
Do not use organic substances (gasoline, kerosene,
benzine or strong solvents), which may be toxic orcause damage.
3. Rinse thoroughly - dried soap can cause streaking. In hot
weather you may need to rinse each section right after you
wash it.
4. To prevent water spots, dry the vehicle using a clean soft
cotton tow el. Do not rub or press hard - you might scratch the
paint.
Automatic car wash
NOTICE
To prevent damage to the antenna, make sure it is removed before driving your vehicle through anautomatic car wash.
Your vehicle may be washed in an automatic car wash, but
remember that the paint can be scratched by some types of
brushes, unfiltered washing water, or the washing process
itself. Scratching reduces paint durability and gloss, especially
on darker colors. The manager of the car wash should be able
to advise you whether the process is safe for the paint on your
vehicle.
03 07.09