height adjustment MAZDA 626 1987 User Guide

1 4 SLIDING SUNROOF
76U14X-067
Set plate
76U14X-068
1.5mm (0.016 in)
: ? ©—
A-A Cross section
76U14X-069
B-B Cross section
Adjust screw Fitting screw jj
Fitting screw®
14. Fully close the lower panel.
15. Install the slide panel to the lower panel, and tight-
en securely.
16. Insert the sun shade from the notch in the set plate,
and push it all the way back.
17. Insert the set plate cap.
18. Adjust the height of the slide panel.
(Cross-section A-A)
Adjust so that the height difference between the
outer panel and roof panel is 1.5 mm (0.06 in)
max.
(Cross-section B-B adjustment)
(1) Loosen installation screws (1) and (2).
If the adjustment is only about 2 mm (0.08 in)
don't loosen screw (1).
(2) Turn the screws to adjust.
Turning to the right raises, and to the left lowers.
(3) Tighten installation screws (1) and (2).
76U14X-070
14-88

WINDSHIELD WIPER 1 4
INSTALLATION
Install in the reverse order of removal.
Note
The wiper arms are identified by marks on the
arms.
DL: driver side
PL: passenger side
76G14X-047
25 ± 5 mm
(0.98 ± 25 ± 5 mm
0.19 in) (0.98 ± 0.19 in)
ADJUSTMENT
Arm Height
Set the arm height as shown in the figure.
86U14X-173
Adjustment of washer spray
Inserting a needle or similar object into the nozzle hole
and bend to change the spray direction.
268 + 50 mm (10.6 + 1.97 in)
86U14X-174
14—93

14 REAR WINDOW WIPER
(0.98 ±0.19 in)
ADJUSTMENT
Arm Height
Set the height as shown in the figure.
86U14X-180
o
r ^
660 mm
(25.98 in)
Adjustment of washer spray
Insert a needle or similar object into the nozzle hole
and bend to change the spray direction.
86U14X-181
14—96