wheel MAZDA MODEL 626 2001 User Guide

Form No. 8P95-EA-00G
Protecting Your Mazda
4-9
036-1AE
Money-Saving SuggestionsHow you operate your Mazda
determines how far it will travel on a
tank of fuel. Use these suggestions to
help save money on fuel and repairs.
•Avoid long warm-ups. Once the
engine runs smoothly, begin
driving.
• Avoid fast starts.
• Keep the engine tuned. Follow the
maintenance schedule (page 8-3)
and have an Authorized Mazda
Dealer perform inspections and
servicing.
• Use the air conditioner only when
necessary. •
Slow down on rough roads.
• Keep the tires properly inflated.
• Don’ t carry unnecessary weight.
• Don’ t rest your foot on the brake
pedal while driving.
• Keep the wheels in correct
alignment.
• Keep windows closed at high
speeds.
• Slow down when driving in
crosswinds and headwinds.

036-2AE
WARNING
!
Coasting:Turning off the engine to coast
down a hill can be dangerous.
This causes the loss of power
steering and power brake control.
Any loss of steering or braking
control could cause an accident.
Never turn off the engine and
coast down a hill.

Form No. 8P95-EA-00G
Protecting Your Mazda4-10

037-1CE
Special Driving Conditions Hazardous Driving
When driving on ice or in water, snow,
mud, sand, or similar hazard:
• Be cautious and allow extra
distance for braking.
• Avoid sudden braking and quick
steering.
• Brake with the pedal by using a
light up-down motion. Don’ t hold
the pedal down constantly.
• If you get stuck, shift to 1 or 2 and
accelerate slowly. Don’ t spin the
front wheels. •
For more traction in starting, use
sand, rock salt, chains, carpeting, or
other nonslip material under the
front wheels.
037-3A1E
WARNING
!
Downshifting on SlipperySurfaces:Downshifting into first gear with
a manual transaxle or into low
with an automatic transaxle while
driving on slippery surfaces could
be dangerous. The sudden change
in tire speed could cause the tires
to skid. This could lead to loss of
vehicle control and an accident. If
it is necessary to downshift on
slippery surfaces, be very careful.

Form No. 8P95-EA-00G
Protecting Your Mazda
4-11

037-4A1E
 Rocking the Vehicle
If you must rock the vehicle to free it
from snow, sand, or mud, depress the
accelerator slightly and...
(Automatic transaxle)
Slowly move the shift lever back and
forth from D to R.
(Manual transaxle)
Slowly move the shift lever back and
forth from 1 to R.
037-6A1E
WARNING
!
Spinning the Wheels:When the vehicle is stuck,
spinning the wheels at high speed
could be dangerous. The
spinning tire could overheat and
explode. This could cause serious
injuries. Don’ t spin the wheels at
more than 56 km/h (35 mph), and
don’ t allow anyone to stand
behind a wheel when pushing the
vehicle.
CAUTION
!
Too much rocking may cause
engine overheating, transaxle
failure, and tire damage.

Form No. 8P95-EA-00G
Protecting Your Mazda4-12

Q037-7IE
 Winter Driving
• Carry emergency gear, including
tire chains, window scraper, flares,
a small shovel, jumper cables, and
a small bag of sand or salt.
• Have the proper ratio of antifreeze
in the radiator (page 8-22).
• Inspect the battery and its cables.
Cold reduces battery capacity.
• Use only cold-weather engine oil
(page 8-16).
• Inspect the ignition system for
damage and loose connections. •
Use washer fluid made with
antifreeze—but don’ t use engine
coolant antifreeze for washer fluid
(page 8-33).
• Don’ t use the parking brake if it
might freeze. Instead, shift to P
with an automatic transaxle and to
1 or R with a manual. Block the
rear wheels.

037-8H1E
 Snow tires
Your vehicle is originally equipped
with all season radials designed to be
used all year around. In some extreme
climates you may find it necessary to
replace them with snow tires during
the winter months to further improve
traction on snow and ice covered roads.
Use snow tires on all four wheels.
Don’ t go faster than 120 km/h (75
mph). Inflate snow tires 28 kPa (0.3
kgf/cm
2, 4 psi) more than
recommended on the tire pressure
label (driver ’s door), but never more
than the maximum cold-tire pressure
shown on the tires.

Form No. 8P95-EA-00G
Protecting Your Mazda
4-13
WARNING
!
Mixing Tire Types:Using tires different in size or type
is dangerous. Your vehicle’s
handling could be greatly affected
and result in an accident. Use
only the same size and type tires
(snow, radial, or non-radial) on
all four wheels.NOTECheck local regulations before
using studded tires.

037-9A5E
 Tire chains
Check local regulations before using
tire chains.
Install the chains on the front tires.
Don’ t use chains on the rear tires.
Use only SAE Class “S” chains, and
make sure they fit.
To install the chains:
1. Remove the wheel covers, or the chain bands will scratch them.
2. Secure the chains on the front tires as tightly as possible. Always
follow the chain manufacturer ’s
instructions. 3. Retighten the chains after driving
1/2-1 km (1/4-1/2 mile).

Form No. 8P95-EA-00G
Protecting Your Mazda4-14
CAUTION
!
•Chains may scratch or chip
aluminum wheels. Install tire
chains on steel wheels only.
• Chains may affect handling.
• Don’ t go faster than 50 km/h
(30 mph) or the chain
manufacturer ’s recommended
limit, whichever is lower.
• Drive carefully and avoid
bumps, holes, and sharp turns.
• Avoid locked-wheel braking.
(Continued)
•Don’ t use chains on the
temporary tire; it may result in
damage to the vehicle and to
the tire.
• Don’ t use chains on roads that
are free of snow or ice. The
tires and chains could be
damaged.

037-10AE
 Driving in Flooded Areas
CAUTION
!
Make sure water does not enter the
vehicle interior or the engine area.
The vehicle interior could become
wet or the engine could be
damaged.

Form No. 8P95-EA-00G
Driving Your Mazda5-2

042-1CE
Ignition Switch PositionsWithout immobilizer
system
J94A4001A
 ON
This is the normal running position
after the engine is started. The warning
lights (except brakes) should be
inspected before the engine is started
(page 5-35).
With immobilizer
system
J94S5001
 START
The engine is started in this position. It
will crank until you release the key;
then it returns to the ON position. The
brake warning light can be checked
after the engine is started (page 5-35). 
ACC (Accessory)
The steering wheel unlocks and some
electrical accessories will operate.
 LOCK
The steering wheel locks to protect
against theft. Only in this position can
the key be removed.

Form No. 8P95-EA-00G
Driving Your Mazda
5-3
042-2DE
LOCK(0)ON(II)
ACC(I)
Push the key
J94A4003 Manual transaxle
When turning the ignition switch to
the LOCK position, push the key in at
the ACC position.

042-3FE
J94S.J94A4004
LOCK(0) ON(II)
ACC(I)
Shift lever
engaged in P
(park)
 Automatic transaxle
When turning the ignition switch to
the LOCK position, keep the shift
lever at P.

042-4AE
NOTEIf turning the key is difficult, jiggle
the steering wheel from side to
side.

042-5BE
WARNING
!
Removing the Key:It’s dangerous to remove the key
from the ignition switch while the
vehicle is moving. Removing the
key allows the steering wheel to
lock. You will lose steering control
and a serious accident could
occur. Remove the key only when
the vehicle is parked.

Form No. 8P95-EA-00G
Driving Your Mazda5-10

045-2AE
 Transaxle Ranges
The shift lever must be at P or N to
operate the starter.

Q045-3A4E
 P (Park)
P locks the transaxle and prevents the
front wheels from rotating.
WARNING
!
Holding the Vehicle with P:Setting the shift lever at the P
position without using the parking
brake to hold the vehicle could be
dangerous. If P fails to hold, the
vehicle could move and cause an
accident. To hold the vehicle, set
the shift lever at P AND set the
parking brake.
CAUTION
!
• Shifting into P or R while the
vehicle is moving can damage
your transaxle.
• Shifting into a driving gear or
reverse when the engine is
running faster than idle can
damage the transaxle.

Form No. 8P95-EA-00G
Driving Your Mazda
5-11

045-4AE
 R (Reverse)
In position R, the vehicle moves only
backward. You must be at a complete
stop before shifting from R, except as
explained under Rocking the Vehicle
(page 4-11).
Q045-5AE
 N (Neutral)
In N, the wheels and transaxle are not
locked. The vehicle will roll freely
even on the slightest incline unless the
parking brake or brakes are on.
WARNING
!
Shifting from N or P:It’ s dangerous to shift from N or
P into a driving gear when the
engine is running faster than idle.
If this is done, the vehicle could
move suddenly, causing an
accident or serious injury. If the
engine is running faster than idle,
don’ t shift from N or P into a
driving gear. D (Drive)
D is the normal driving position. From
a stop, the transaxle will automatically
shift through a 4-gear sequence.

045-14A1E
 2 (Second)
The 2 position is helpful when driving
in heavy, slow-moving traffic and
climbing hills; for braking assist when
going down hills; or for starting on
slick surfaces and other situations
where gentle acceleration may be
necessary. Do not exceed 116 km/h
(72 mph)
*1 or 104 km/h (65 mph)
*2 in
the 2 position.
*1
2.0-liter engine
*2
2.5-liter engine