clock MAZDA MODEL CX-3 2015 (in English) Owner's Manual

*Some models.7–7
If Trouble Arises
Flat Tyre
To secure the jack
1. Insert the wing bolt into the jack with
the jack screw pointing down and turn
the wing bolt clockwise to temporarily
tighten it.
2. Turn the jack screw in the direction
shown in the fi gure.
Wing bolt
Jack screw
3. Turn the wing bolt completely to secure
the jack.
NOTE
If the jack is not completely secured, it
could rattle while driving. Make sure the
jack screw is suffi ciently tightened.
4. Insert the cover tabs and install the
cover.
NOTE
Verify that the cover is securely
installed.
Maintenance
 




 Always keep the jack clean.



 Make sure the moving parts are kept
free from dirt or rust.
 


 Make sure the screw thread is
adequately lubricated.
Spare Tyre *
Your Mazda has a temporary spare tyre.
The temporary spare tyre is lighter and
smaller than a conventional tyre, and is
designed only for emergency use and
should be used only for VERY short
periods. Temporary spare tyres should
NEVER be used for long drives or
extended periods.
WARNING
Do not install the temporary spare tyre
on the front wheels (driving wheels):
Driving with the temporary spare tyre
on one of the front driving wheels is
dangerous. Handling will be affected.
You could lose control of the vehicle,
especially on ice or snow bound roads,
and have an accident. Move a regular
tyre to the front wheel and install the
temporary spare tyre to the rear.
$9@&;&&%@&EJUJPOJOEC







7–9
If Trouble Arises
Flat Tyre
4. For vehicles equipped with a sub-
woofer, uncouple the connector.
Connector
NOTE
Extra strength may be required to
uncouple the connector. Be sure to
squeeze the tab fi rmly.
5. For vehicles equipped with a sub-
woofer, loosen the hold-down bolt and
remove the woofer and spare tyre.
For vehicles not equipped with a sub-
woofer, turn the spare tyre hold-down
bolt anticlockwise and remove the
spare tyre.
Spare tyre hold-down bolt
To secure the spare tyre
Store the spare tyre in the reverse order
of removal. After storing, verify that the
spare tyre is stored securely.
$9@&;&&%@&EJUJPOJOEC







7–12
If Trouble Arises
Flat Tyre
CAUTION
If the bottle is shaken after the injection
hose is screwed on, tyre sealant could
spray out from the injection hose. Tyre
sealant contacting clothing or other
objects may be impossible to remove.
Shake the bottle before screwing on the
injection hose.
NOTE
The tyre sealant can be used at outside
temperatures down to -30 °C (-22 °F). In
extremely cold temperatures (0 °C (32
°F) or below), the tyre sealant hardens
easily and injection of the sealant will
be diffi cult. Warm the sealant inside the
vehicle before doing the injection work.
6. Remove the cap from the bottle. Screw
on the injection hose with the bottle's
inner cap left on to break the inner cap.
Cap
Injection hose
Tyre sealant
7. Remove the valve cap from the fl at
tyre. Press the back of a valve core tool
to the core of the tyre valve and bleed
all the remaining air.
Valve core tool Valve
Valve cap
CAUTION
If there is air remaining in the tyre when
the valve core is removed, the valve core
could fl y out. Remove the valve core
carefully.
8. Turn the valve core anticlockwise with
the valve core tool and remove the
valve core.
Valve
Valve core
$9@&;&&%@&EJUJPOJOEC







7–13
If Trouble Arises
Flat Tyre
NOTE
Store the valve core in a place where it
will not get dirty.
9. Insert the injection hose into the valve.
Valve
Injection hose
10. Hold the bottom of the bottle upright,
squeeze the bottle with your hands, and
inject the entire amount of tyre sealant
into the tyre.
Valve
11. Pull out the injection hose from the
valve.
NOTE
The tyre sealant cannot be reused.
Purchase a new tyre sealant kit at an
Authorised Mazda Repairer. 12. Reinsert the valve core into the valve
and turn it clockwise to install it.
Injection hose
Valve core
tool Valve
Valve core
NOTE
Do not throw away the empty tyre
sealant bottle after use. Return the empty
tyre sealant bottle to an Authorised
Mazda Repairer when replacing the tyre.
The empty tyre sealant bottle will need
to be used to extract and dispose of the
used sealant from the tyre.
13. After that, install the injection hose to
the tab of the bottle to prevent leakage
of any remaining sealant.
Ta b
$9@&;&&%@&EJUJPOJOEC







7–18
If Trouble Arises
Flat Tyre
Removing a Flat Tyre
1. If your vehicle is equipped with a
wheel cover, pry off the wheel cover
with the bevelled end of the jack lever.
NOTE
Force the end of the jack lever fi rmly
between wheel and cover, or removal
will be diffi cult.
CAUTION
Align the notch on the wheel cover with
the valve stem when installing it.
Tyre valve Notch
Damage could occur during installation
if the wheel cover is not properly
aligned.
2. Loosen the wheel nuts by turning them
anticlockwise one turn each, but do not
remove any wheel nuts until the tyre
has been raised off the ground.
3. Place the jack on the ground.
$9@&;&&%@&EJUJPOJOEC







7–20
If Trouble Arises
Flat Tyre
WARNING
Do not jack up the vehicle in a position
other than the designated jack-up
position or place any objects on or
under the jack:
Jacking up the vehicle in a position
other than the designated jack-up
position or placing objects on or
under the jack is dangerous as it could
deform the vehicle body or the vehicle
could fall off the jack resulting in an
accident.
Use only the jack provided with your
Mazda:
Using a jack that is not designed for
your Mazda is dangerous. The vehicle
could slip off the jack and seriously
injure someone.
Never place objects under the jack:
Jacking the vehicle with an object
under the jack is dangerous. The
jack could slip and someone could be
seriously injured by the jack or the
falling vehicle.
7. Insert the jack lever and attach the
wheel brace to tyre jack.
8. Turn the jack handle clockwise and
raise the vehicle high enough so that
the spare tyre can be installed. Before
removing the wheel nuts, make sure
your Mazda is fi rmly in position and
that it cannot slip or move.
WARNING
Do not jack up the vehicle higher than
is necessary:
Jacking up the vehicle higher than
is necessary is dangerous as it could
destabilize the vehicle resulting in an
accident.
Do not start the engine or shake the
vehicle while it is jacked up:
Starting the engine or shaking
the vehicle while it is jacked up is
dangerous as it could cause the vehicle
to fall off the jack resulting in an
accident.
Never go under the vehicle while it is
jacked up:
Going under the vehicle while it is
jacked up is dangerous as it could
result in death or serious injury if the
vehicle were to fall off the jack.
$9@&;&&%@&EJUJPOJOEC







7–21
If Trouble Arises
Flat Tyre
9. Remove the wheel nuts by turning
them anticlockwise; then remove the
wheel and centre cap.
Mounting the Spare Tyre
1. Remove dirt and grime from the
mounting surfaces of the wheel and
hub, including the hub bolts, with a
cloth.
WARNING
Make sure the mounting surfaces of
the wheel, hub and wheel nuts are
clean before changing or replacing
tyres:
When changing or replacing a tyre,
not removing dirt and grime from the
mounting surfaces of the wheel, hub
and hub bolts is dangerous. The wheel
nuts could loosen while driving and
cause the tyre to come off, resulting in
an accident.
2. Mount the spare tyre. 3. Install the wheel nuts with the bevelled
edge inward; tighten them by hand.
WARNING
Do not apply oil or grease to wheel
nuts and bolts and do not tighten the
wheel nuts beyond the recommended
tightening torque:
Applying oil or grease to wheel nuts
and bolts is dangerous. The wheel nuts
could loosen while driving and cause
the tyre to come off, resulting in an
accident. In addition, wheel nuts and
bolts could be damaged if tightened
more than necessary.
$9@&;&&%@&EJUJPOJOEC







7–22
If Trouble Arises
Flat Tyre
4. Turn the wheel brace anticlockwise and
lower the vehicle. Use the wheel brace
to tighten the nuts in the order shown.
If you are unsure of how tight the nuts
should be, have them inspected at an
expert repairer, we recommend an
Authorised Mazda Repairer.
Nut tightening torque
N·m (kgf·m, ft·lbf) 108—147
(12—14, 80—108)
WARNING
Always securely and correctly tighten
the wheel nuts:
Improperly or loosely tightened wheel
nuts are dangerous. The wheel could
wobble or come off. This could result
in loss of vehicle control and cause a
serious accident.
WARNING
Be sure to reinstall the same nuts you
removed or replace them with metric
nuts of the same confi guration:
Because the wheel studs and wheel
nuts on your Mazda have metric
threads, using a non-metric nut is
dangerous. On a metric stud, it would
not secure the wheel and would
damage the stud, which could cause the
wheel to slip off and cause an accident.
5. Remove the tyre blocks and store the
tools and jack.
6. Store the damaged tyre in the luggage
compartment.
7. Check the infl ation pressure. Refer to
Tyres on page 9-9 .
8. Have the fl at tyre repaired or replaced
as soon as possible.
NOTE
(With tyre pressure monitoring
system)
Do not press the tyre pressure
monitoring system set switch after
installing the spare tyre. The switch
is only to be pressed after installing
the repaired fl at tyre or installing a
replacement tyre (page 4-36 ).
$9@&;&&%@&EJUJPOJOEC







10–3
Index
C
Capacities .............................................. 9-7
Carbon Monoxide ............................... 3-27
Cargo Sub-Compartment .................. 5-153
Cell Phones ........................................... 8-4
Child Restraint
Categories of child-restraint
systems .......................................... 2-26
Child-restraint precautions ............ 2-21
Child-restraint system installation ... 2-26
Child-restraint system suitability for
various seat positions table............ 2-31
Installing child-restraint systems... 2-35
Child Safety Locks for Rear Doors ..... 3-19
Clock ................................................... 5-30
Collision warning ................................ 7-54
Coming Home Light System .............. 4-63
Control Status Display ........................ 4-89
Cruise Control ................................... 4-158
Cruise Control Switch ................. 4-158
Cruise Main Indicator Light (Amber)/
Cruise Set Indicator Light
(Green) ........................................ 4-159
Cruise Control Set Vehicle Speed
Display ................................................ 4-31
Cup Holder ........................................ 5-150
D
Defogger
Mirror ............................................ 4-74
Rear window ................................. 4-73
Diesel Particulate Filter ..................... 4-167
Dimensions ........................................... 9-7
Direct Mode
Automatic transaxle ...................... 4-56
Direction Indicators ............................ 4-67
Distance Recognition Support System
(DRSS) .............................................. 4-118
Indication on display ................... 4-119
Door Locks .......................................... 3-10
Drive selection .................................... 4-93 Driving In Flooded Area ..................... 3-52
Driving Tips
Automatic transaxle ...................... 4-57
Driving in fl ooded area.................. 3-52
Floor mat ....................................... 3-48
Hazardous driving ......................... 3-47
Rocking the vehicle ....................... 3-49
Running-in..................................... 3-46
Saving fuel and protection of the
environment................................... 3-46
Turbocharged vehicles (SKYACTIV-D
1.5) ................................................ 3-53
Winter driving ............................... 3-49
Dynamic Stability Control (DSC) ....... 4-84
TCS/DSC Indicator Light ............. 4-84
E
Effectiveness Display .......................... 4-92
Electronic steering lock warning beep ... 7-54
Emergency Starting
Push-Starting ................................. 7-27
Running Out of Fuel (SKYACTIV-D
1.5) ................................................ 7-28
Starting a Flooded Engine
(SKYACTIV-G 2.0) ...................... 7-27
Emergency Stop Signal System .......... 4-79
Emergency Towing
Towing Description ....................... 7-31
Towing/Tiedown Hooks ................ 7-32
Emission Control System (SKYACTIV-D
1.5) ...................................................... 3-26
Emission Control System (SKYACTIV-G
2.0) ...................................................... 3-25
Ending Display .................................... 4-92
Engine
Bonnet release ............................... 6-19
Coolant .......................................... 6-29
Engine Compartment Overview .... 6-21
Exhaust gas.................................... 3-27
Oil .................................................. 6-23
Starting ............................................ 4-5
Essential information ............................ 6-2
$9@&;&&%@&EJUJPOJOEC