warning MAZDA MODEL CX-3 2018 Smart Start Guide (in English)

m{zd{ c x-3 27
TRAFFI\b \fIGN RE\bOGNITION
(IF EQUIPPED)
TRAFFIC SIGN RECOGNITION (TSR) SYSTEM
The TSR system helps prevent the driver from overlooking traffic signs and provides
support for safe driving by displaying traffic signs on the Active Driving Display. TSR
recognizes traffic signs using the \XForward Sensing Camera (FSC) or the navigation
system while driving.
When vehicle speed exceeds the speed lim\.it sign displayed in the Active Driving Display,
the system notifies the driver with an indication in the Active Driving Display and a
warning sound.
The T\fR displays the \fPEED LIMIT
, DO NOT ENTER , and traffic \fTOP signs.
NOTE: The T\fR system is not supported in some countries or regions. For more
information, consult an Authorized Mazda Dealer. The T\fR system operates only if the
navigation system \fD card (Mazda Genuine) is inserted into the \fD card slot. \bonsult an
Authorized Mazda Dealer for details.
SPEED LIMIT SIGN DISPLAYEDSPEED LIMIT SIGN RECOGNIZED
STOP SIGN RECOGNIZED AND DISPLAYED
2940109_18b CX-3 SSG_060817.indd 276/8/17 2:39 PM

28 MAZDAUSA.COM
BLIND SPOT MONITORING (BSM)
The BSM system is designed to assist the driver by monitoring blind spots on the left
and right sides of the vehicle in certain situations, such as lane chan\Xges.
•
The B\fM detects vehicles approaching from the rear while traveling in
the forward direction at a speed \.of 6.3 mph or more and notifies the
driver by turning on the B\fM w\.arning indicator light and displaying the vehicle detection screen (vehicles with Active Driving Display).
•
If the turn signal lever is operated to signal a turn in the direction
in which the B\fM warning indicator light is illuminated while the
approaching vehicle is detected, the B\fM warns the driver by turning on the B\fM warning indicator light, and by activating the warning sound and
the warning screen indicator display
(vehicles with Active Driving Display).
•
The detection area on this system
covers the driving lane\.s on both sides
of the vehicle and from the rear part
of the front doors to about 164 ft behind the vehicle.
• B\fM sensors are located under the
left and right rear bumper areas.
The B\fM system may not operate properly if the rear bumper is dirty,
so keep the rear bumper area clean
and free of bumper stickers.
NOTE:
•
The B\fM can assist the driver in confirming the safety
of the surroundings, but is not a complete substitute.
•
The driver is responsible for ensuring safe lane changes
and other maneuvers.
•
Always pay attention to the direction in which th\.e vehicle
is traveling and the vehicle’s surroundings.
Turning BSM System Off:
Turning the B\fM system off will turn off both the light and sound indicators. To turn the B\fM system off, push the B\fM OFF \.switch on the dash.
The B\fM OFF indicator in the instrument cluster will turn on to indicate the B\fM system is off.
NOTE: Turning the B\fM system off will also turn off the Rear \bross Traffic Alert system.
BLIND \fPOT MONITORING \fY\fTEM
WARNING:
B\fM is only a
supplementary
system to help
aid in monitoring
blind spots;
however, B\fM
has limitations.
The system may
not detect all
vehicles, especially
a motorcycle. Do
not rely solely on
the B\fM. Relying
solely on the
B\fM may cause
an unexpected
accident resulting
in death or serious
injury. Make sure
to look over your
shoulder before
changing lanes.
Your
vehicle
Detection areas
ACTIVE DRIVING DISPLA\XY
WHITE Vehicle
Detected
AMBER Vehicle
Detected
with Turn
\fignal On
BSM switch
2940109_18b CX-3 SSG_060817.indd 286/8/17 2:39 PM

m{zd{ c x-3 29
REAR \bRO\f\f TRAFFI\b ALERT
(IF EQUIPPED)
REAR CROSS TRAFFIC ALERT (RCTA)
The RCTA is designed to alert the driver of oncoming traffic when backing out of a parking spot. RCTA is active when the vehicle is in reverse and the vehicle speed is between 0 mph and 6 mp\Xh.
When the B\fM sensors detect a moving object, the R\bTA will notify the driver with indicators and sound:
• Rear view monitor and outside mirror flashing indications.
Refer to your Owner’s Manual for complete details.
WARNING:
R\bTA is only a
supplementary
system to help aid
when backing up; however, R\bTA
has limitations.
The system does not detect all
vehicles, especially motorcycles. Do
not rely solely on the R\bTA. Relying
solely on the R\bTA may cause
an unexpected
accident resulting in serious injury.
Always back up slowly.
BSM/RCTA (Left)BSM/RCTA (Right)
Rear view monitor
Object
detected
Object
detected
2940109_18b CX-3 SSG_060817.indd 296/8/17 2:39 PM

40 MAZDAUSA.COM
GLOSSARY OF WARNING AND INDICATOR LIGHTS

Lane Departure Warning System
(LDW\f) On (Amber)/
Lane Detected (Green) (p. 24)

Lane Departure Warning System
(LDW\f) OFF
Traction Control System (T\b\f)/
Dynamic Stability Control (D\f\b)
On: T\b\f/D\f\b malfunction
Flashing: T\b\f/D\f\b operating
Traction Control System (TCS) OFF
SPORT Mode ON
Lights ON (Exterior) (p. 30)
Headlight High Beams ON
Airbag/Front Seat Belt
Pretensioner System Malfunction
Seat Belt Unbuckled/Malfun\Xction
Turn Signals/Hazard Warning
Tire Pressure Monitoring System
(TPM\f) Warning (p. 6)
On/Warning Beep: Low tire pressure in one or more tires
Flashing: TPM\f malf\.unction
Cruise Main ON (Amber)/
Cruise Set ON (Green)
Shift Position
Smart Brake Support (\fB\f) and
Smart City Brake Support (\f\bB\f)
Flashing Red: \fB\f and \f\bB\f
are operating
LED Headlight
High Beam Control ON
Smart Brake Support (\fB\f) and
Smart City Brake Support (\f\bB\f)
Amber: \fB\f and/or \f\bB\f OFF
Check Engine
Security
Brake Warning
Parking brake on/
low brake fluid/malfunction
Master Warning
Low Fuel Level
Low Engine Oil Pressure
Power Steering Malfunction
Automatic Transaxle Warning
Charging System Malfunction
Door/Tailgate Ajar
Low Washer Fluid Level
Advanced Key Detected
Advanced Key Not Detected (p. 4)
Check Fuel Cap
Perform Maintenance
Blind Spot Monitoring
(B\fM) OFF
Mazda Radar Cruise Control
On (Amber) Set (Green
4WD AWD Warning
IN\fTRUMENT \bLU\fTER
Speedometer
Shift
positionOdometer/
trip meter
Fuel gauge
Dashboard
illumination/
dimmer
1/
trip meter2
Information display/
trip computer
2940109_18b CX-3 SSG_060817.indd 406/8/17 2:40 PM

m{zd{ c x-3 41
IN\fTRUMENT \bLU\fTER
\fee your Owner’s Manual for more details and explanations. 1 Rotate the knob to adjust the brightness of the instrument cluster and other dashboard illuminations.
2 Push to toggle between trip meter (A & B). When a trip meter is selected, push and hold \.to reset to zero.
Push the knob for 1.5 seconds or more to change the speed\. units between mph.
ENGINE COOLANT TEMPERATURE LIGHTS
Since this vehicle does not use an engine coolant temperature gauge, red and blue
engine coolant temperature lights are used to indicate high and low coolant temperature.
Red Coolant Temperature
FLA\fHING: Engine is starting to run hot.
Drive slowly to reduce engine load.
ON: Engine is overheating. \fafely pull
over to the side of the road and turn the
engine off. Refer to the Owner’s Manual for more information. Blue Coolant Temperature
ON: Engine coolant is cold and no warm air is available for heater/defroster.
OFF: Engine coolant is warm and warm air is available for heater/defroster. The light
may stay on for a few minutes after start- up when the engine\. is cold, but the vehicle
can be driven with the light on or off.
TRIP COMPUTER
The following information can be selected by pushing the or of the INFO button on
the steering wheel.
• Approximate distance you can travel on the available fuel (RANGE)
•
Average fuel economy •
\burrent fuel economy • Average vehicle speed

To reset, push and hold th\.e INFO button for more than 1.5 seconds.
OUTSIDE TEMPERATURE DISPLAY
The outside temperature unit can be switched between °\b and °F using\. \fystem \fettings
in the Infotainment \fystem.
IMPORTANT: When your MAZDA \bONNE\bT display setting is set on “AUTO”, the
instrument cluster and display may become dimmer when th\.e headlights are on. If the
display and instrument cluster become too dim or too bright when the headlights are on, simply rotate the dimmer knob \.located on your instrument cluster to adjust the brightness.
TPMS NOTE: Low ambient temperature and/or high altitude may cause tire pressures to
change and turn the TPM\f warning light on. If the warning light comes on, see p. 6.
2940109_18b CX-3 SSG_060817.indd 416/8/17 2:40 PM

VEHICLE PRESENTATION:
Refer to the \fmart \ftart Guide during presentation.
ESSENTIAL INFORMATION
Driver\bs View
•
Location of \fwitches and \bontrols
Advanced Keyless Entry System*
•
Door Request \fwitch*
Starting the Engine
•
Accelerated Warm-up \fystem
•
Push-Button \ftart \fystem
•
Emergency Engine \ftart/\ftop
Tire Pressure Monitoring System
•
Initialize TPM\f before delivery
Seat Warmers*
Heated Steering Wheel*
Rear Seats
MAZDA CONNECT
Infotainment System*
MAZDA CONNECT Settings*
Commander Switch
Voice Control
Bluetooth®
• Pair Phone
• Make/Receive \ball
•
Toll-Free
\bustomer \fervice 800\f430\f0153
Navigation System*
• \fD \bard
• Planning a Route
SAFETY AND TECHNOLOGY INFORMATION
Active Driving Display*
Mazda Radar Cruise Control*
Smart City Brake Support*
Smart Brake Support*
Lane Departure Warning System*
Distance Recognition Support System*
Traffic Sign Recognition
Blind Spot Monitoring
Rear Cross Traffic Alert*
GENERAL INFORMATION
Exterior Lights
Wiper / Washer
Set Clock
Adaptive Front\flighting System *
High Beam Control
Audio Controls
• Bluetooth® Audio
• \firius XM® Activation and Operation
Audio USB and AUX Inputs
Automatic Climate Control
Instrument Cluster
•
Review of Warning and Indicator
Light Function and Location
Transmission
Auto\fDimming Mirror and HomeLink®*

*If equipped
\bU\fTOMER DELIVERY \bHE\bKLI\fT
2940109_18b CX-3 SSG_060817.indd 466/8/17 2:41 PM

DEALERSHIPD AT E
SALES CONSULTANT CUSTOMER\bS NAME
VIN E\fMAIL
SALES CONSULTANTD AT ECUSTOMER D AT E
PRESENTATION OF OWNER’S MATERIALS:
Review the following items with the customer.
Smart Start Guide
•
Remove this checklist from
\fmart \ftart Guide
•
Personalization Features
(refer to your Owner’s Manual)
Warranty Information
Warranty \ftart Date: _____________
\bustomer Initial: _________________
•
Basic Vehicle –
36 months/36,000 miles
• Roadside assistance program
www.MyMazda.com
•
Offer to register customer
on www.MyMazda.com
Owner\bs Manual
Maintenance Passport
Floor Mats
• Ensure floor mats are properly
hooked after cleaning
•
Do not install two floor mats, one on
top of the other, on the driver’s side
•
Accessory rubber floor ma\.ts should be
cleaned with mild soap and water only
Tire Pressure Monitoring System
• \fystem overview
•
Demonstrate how to initialize the
TPM\f system
•
Push and hold the \.“\fET \fwitch" until
the TPM\f warning light flashes twice
and one beep is he\.ard
• Review the system caution
SERVICE DEPARTMENT
Introduce Service Manager
• Provide business cards
Review Service and Parts
Department Hours of Operation
Explain FREE Mazda Full Circle
Service Inspection
Schedule First
Maintenance Service
\bU\fTOMER DELIVERY \bHE\bKLI\fT
\bONTINUED
2940109_18b CX-3 SSG_060817.indd 476/8/17 2:41 PM