MITSUBISHI ASX 2014 Owner's Manual (in English)

2.Remove the screws (B), and then re-
move the lamp unit.
3. Turn the bulb (C) anticlockwise to re-
move it.
4. While holding down the tab (D), pull out
the socket (E).
5. To install the bulb, perform the removal
steps in reverse.
Rear fog lamp
E01004101596
1. When removing the lamp unit (A), push
it towards the left side of the vehicle body.
2. Remove the socket (B) and bulb assem-
bly by turning it anticlockwise.
3. Remove the bulb by pulling it out.
4. To install the bulb, perform the removal
steps in reverse.
Replacement of lamp bulbs
10-33
OGAE14E1Maintenance10

NOTElIf the wiring harness is pulled off the 2 har-
ness guides on the lamp unit while replacingthe bulb, make sure to secure the wiring har-
ness to the harness guides.
l When installing the lamp unit, first insert the
tab (C) into the groove (D) on the body, and then push on the lamp unit to fit it into place.Rear combination lamps
E01004201366
1. Remove the screws (A) that hold the
lamp unit and remove the lamp unit.
2. Turn the socket and bulb assembly anti-
clockwise to remove it.
B- Stop and tail lamp (LED) - cannot be
replaced
C- Rear turn-signal lamp
NOTEl An LED, not a bulb, is used in the stop
lamp/tail lamp.
Contact a MITSUBISHI MOTORS Author-
ized Service Point when there is a need for
repair or replacement.
3. Pull the bulb out of the socket.
4. To install the bulb, perform the removal
steps in reverse.
NOTEl When mounting the lamp unit, align the
groove (D) on the lamp unit with the clip onthe body and the pin (E) on the unit with the
hole in the body.
Replacement of lamp bulbs
10-34 OGAE14E1Maintenance10

Reversing lamps
E01004401430
1. Open the tailgate.
2. Insert a straight blade (or minus) screw-
driver into the notch of the cover and pry
gently to remove the cover.
NOTEl Wrap a piece of cloth around the tip of the
screwdriver in order to avoid scratching the
cover.
3. Remove the socket and bulb assembly
by turning it anticlockwise.
4. Remove the bulb by pulling it out.
5. To install the bulb, perform the removal
steps in reverse.NOTEl When installing the lid, align the tab on the
lid with the hole on the vehicle side.
Replacement of lamp bulbs
10-35
OGAE14E1Maintenance10

Licence plate lamps
E01004602093
1. When removing the lamp unit (A), push
it towards the left side of the vehicle body.
2. Remove the socket (B) and bulb assem-
bly by turning it anticlockwise.
3. Remove the bulb by pulling it out.
4. To install the bulb, perform the removal
steps in reverse.
NOTEl When installing the lamp, insert tab (C) first
then align and insert tab (D).High-mounted stop lamp
E01004500593
NOTEl An LED, not a bulb, is used in the high-
mounted stop lamp.
Contact a MITSUBISHI MOTORS Author-
ized Service Point when there is a need for
repair or replacement.
Replacement of lamp bulbs
10-36 OGAE14E1Maintenance10

Vehicle labeling................................................................................ 11-02
Vehicle dimensions........................................................................... 11-05
Vehicle performance......................................................................... 11-06 Vehicle weight.................................................................................. 11-07
Engine specifications........................................................................ 11-10
Electrical system............................................................................... 11-11
Tyres and wheels...............................................................................11-12
Fuel consumption.............................................................................. 11-13
Refill capacities................................................................................. 11-15Specifications
OGAE14E111

Vehicle labelingE01100104444
Vehicle identification number
The vehicle identification number is stamped on the bulkhead as shown in the illustration.
Vehicle information code la-
bel*
The vehicle information code label is located as shown in the illustration.
The label shows model code, engine model,
transmission model and body colour code, etc.
Please use this number when ordering re-
placement parts.
1- Model code
2- Engine model code
3- Exterior code
4- Transmission model code
5- Body colour code, Interior code,
Option code
6- Chassis number
7- Maximum gross vehicle weight
8- Gross combination weight
9- Maximum axle weight (Front)
10- Maximum axle weight (Rear)
Vehicle labeling
11-02 OGAE14E1Specifications11

Vehicle information codeplate*
The vehicle information code plate is riveted
as shown in the illustration.
The plate shows model code, engine model,
transmission model and body colour code,
etc.
Please use this number when ordering re-
placement parts.
1- Model code
2- Engine model code
3- Transmission model code
4- Body colour code
5- Interior code
6- Option code
7- Exterior code
Vehicle identification number
plate (RHD vehicles only)
The vehicle identification number is stamped on the plate riveted to the left front corner of
the vehicle body. It is visible from outside of
the vehicle through the windscreen.
Engine number
The engine number is stamped on the engine cylinder block as shown in the illustrations.
Vehicle labeling
11-03
OGAE14E1Specifications11

Petrol-powered vehicles
1600 models
*: Front of the vehicle
1800 models, 2000 models
*: Front of the vehicle
Diesel-powered vehicles
*: Front of the vehicle
Vehicle labeling
11-04OGAE14E1Specifications11

Vehicle dimensionsE011002040381Front track1,525 mm2Overall width1,770 mm3Front overhang870 mm4Wheel base2,670 mm5Rear overhang755 mm6Overall length4,295 mm7Ground clearance (unladen)Petrol-powered vehicles180 mm, 195 mm*1Diesel-powered vehicles180 mm*1
: Vehicles for Russia, Kazakhstan and Ukraine
Vehicle dimensions
11-05
OGAE14E1Specifications11

8Overall height (unladen)Without roof rails1,615 mm9With roof rails1,625 mm10Rear track1,530 mmMinimum turning radiusBody5.63 mWheel5.3 m*1: Vehicles for Russia, Kazakhstan and Ukraine

Vehicle performance
E01100302602Petrol-powered vehicles
Maximum speed
1600 models183 km/h (114 mph)1800 models186 km/h (116 mph)
2000 models
2WD194 km/h (121 mph)4WDM/T192 km/h (120 mph)CVT188 km/h (117 mph)Diesel-powered vehicles
Maximum speed1800 models2WD200 km/h (124 mph), 189 km/h (117 mph)*4WD198 km/h (123 mph), 185 km/h (115 mph)*2200 models190 km/h (118 mph)*
: 85 kW engine (Low CO 2 emissions)

Vehicle performance
11-06
OGAE14E1Specifications11