clock MITSUBISHI COLT 2008 (in English) Owner's Guide

8-56 Maintenance
8
4. Remove the entire socket and bulb assembly (D) by turn-ing it anticlockwise.NOTE● When mounting the lamp unit, align the holes in the lamp
unit with the pins (E) on the vehicle body.

Maintenance8-59
8
4. Remove the bulb by turning it anticlockwise while press-ing in.NOTE● When mounting the lamp unit, align the pins (G) on the
lamp unit with the holes in the body.
E- Rear turn-signal lamp
F- Stop lamp

Maintenance8-61
8
3. Undo the clips (D) (8 locations) one by one, starting at thetop and finishing at the bottom. (Pull each clip in the
direction of the arrow to undo it.) Then, remove the bulb
holder. 4. Remove the bulb by turning it anticlockwise while press-
ing in.
E- Stop lamp
F- Rear turn-signal lamp
G- Reversing lamp
H- Rear fog lamp (driver’s side) Tail lamp

Maintenance8-63
8
2. Remove the socket and bulb assembly (C) together byturning it anticlockwise, and then remove the bulb by
turning it anticlockwise while pressing in.High-mounted stop lampsE01004500287
3-door models
1. Open the tailgate and remove the clips (A) (2 locations).
To remove each clip, press part (B) of the clip then pry
around the clip to get the clip out.

Maintenance8-67
8
Licence plate lampsE01004600116
1. Remove the lamp assemblies by levering them out with astraight blade (or minus) screwdriver. 2. Remove the socket and bulb assembly together by turning
it anticlockwise, and then remo ve the bulb by pulling out.

8-68 Maintenance
8
NOTE●When installing the lamp, insert tab (A) first, then align
and insert tab (B).Room lamps & map lampsE01004700104
Insert a straight blade (or minus) screwdriver into the notch of
the lens and pry gently to remove the lens.
Turn the lamp bulb anticlockwise to remove it from the lamp
bulb holder.
NOTE●Wrap a piece of cloth around th e tip of the screwdriver in
order to avoid scratching the lens.