MITSUBISHI ENDEAVOR 2004 Service Repair Manual
Page 2271 of 3870
Fig. 197: Locating Connector C
-108
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
STEP 13. Measure the resistance at power transistor connector C-108 in
order to the ground circuit to the front blower motor.
1. Disconnect power transistor connector C-108, and measure the resistance
at the wirin
g harness side.
2004 Mitsubishi Endeavor LS
2004 HVAC Heater Air Conditioning, Ventilation - Endeavor
Page 2272 of 3870
Fig. 198: Locating Connector C
-108
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
2. Measure the resistance value between terminal 2 and ground.
The measured value should be 2 ohms or less.
Q: Does the measured resistance value correspond with this range?
YES:
Go to Step 15 .
NO:
Go to Ste
p 14.
2004 Mitsubishi Endeavor LS
2004 HVAC Heater Air Conditioning, Ventilation - Endeavor
Page 2273 of 3870
Fig. 199: Measuring Resistance Between Terminal 2 And Ground
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
STEP 14. Check the wiring harness between power transistor connector
C-108 (terminal 2) and ground.
Q: Is the wiring harness between power transistor connector C-108
(terminal 2) and ground in good condition?
YES:
No action to be taken.
NO:
Repair the wiring harness. The front blower motor should operate
normall
y.
2004 Mitsubishi Endeavor LS
2004 HVAC Heater Air Conditioning, Ventilation - Endeavor
Page 2274 of 3870
Fig. 200: Locating Connector C
-108
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
STEP 15. Check the wirin
g harness between front blower motor connector
C-111 (terminal 2) and power transistor connector C-108 (terminal 4).
Q: Is the wiring harness between front blower motor connector C-111
(terminal 2) and power transistor connector C-108 (terminal 4) in good
condition?
YES:
Go to Step 16.
NO:
Repair the wiring harness. The front blower motor should operate
normally.
2004 Mitsubishi Endeavor LS
2004 HVAC Heater Air Conditioning, Ventilation - Endeavor
Page 2275 of 3870
Fig. 201: Locating Connectors C
-111 And C
-108
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
2004 Mitsubishi Endeavor LS
2004 HVAC Heater Air Conditioning, Ventilation - Endeavor
Page 2276 of 3870
STEP 16. Check the wiring harness between A/C-ECU connector C-16
(terminals 17 and 18) and power transistor connector C-108 (terminals 1
and 3).
Q: Is the wiring harness between A/C-ECU connector C-16 (terminals 17
and 18) and power transistor connector C-108 (terminals 1 and 3) in good
condition?
YES:
Go to Step 17.
NO:
Repair the wiring harness. The front blower motor should operate
normall
y.
2004 Mitsubishi Endeavor LS
2004 HVAC Heater Air Conditioning, Ventilation - Endeavor
Page 2277 of 3870
Fig. 202: Locating Connectors C
-16 And C
-108
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
2004 Mitsubishi Endeavor LS
2004 HVAC Heater Air Conditioning, Ventilation - Endeavor
Page 2278 of 3870
STEP 17. Replace the power transistor.
Q: Does the blower motor operate normally?
YES:
No action is necessary and testing is complete.
NO:
Replace the A/C-ECU. Check that the air conditioning works
normally.
INSPECTION PROCEDURE 6: FRONT BLOWER AIR AMOUNT CANNOT BE CHANGED
2004 Mitsubishi Endeavor LS
2004 HVAC Heater Air Conditioning, Ventilation - Endeavor
Page 2279 of 3870
Fig. 203: View Of Blower Motor Circuit
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
2004 Mitsubishi Endeavor LS
2004 HVAC Heater Air Conditioning, Ventilation - Endeavor
Page 2280 of 3870
Fig. 204: Identifying Connectors C
-16, C
-108 And C
-111
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
CIRCUIT OPERATION If the blower motor speed cannot be changed, the power transistor circuit is
suspected. TROUBLESHOOTING HINTS
Malfunction of the power transistor Malfunction of the front A/
C-ECU
2004 Mitsubishi Endeavor LS
2004 HVAC Heater Air Conditioning, Ventilation - Endeavor