Rear hub MITSUBISHI ENDEAVOR 2004 Service Owner's Guide

Fig. 28: Removing/Installing Drive Shaft Assembly Components

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Required Special Tools:
MB990767: End Yoke Holder
MB991354: Puller Body
MB990242: Puller Shaft
MB990244: Puller Bar
MB991721: Sliding Hammer
MB991833: Drive Shaft Puller
MB991961: Adapter
MB991017: Front Hub Remover and Installe
r

2004 Mitsubishi Endeavor LS
2004 SUSPENSION Rear Axle < AWD > - Endeavor

MB990998: Front Hub Remover and Installer REMOVAL SERVICE POINTS <<A>> DRIVE SHAFT NUT REMOVAL Use special tool MB990767 to fix the hub and remove the drive shaft nut.
Fig. 29: Removing Drive Shaft Nut

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
CAUTION: Do not apply pressure to wheel bearing by the
vehicle weight to avoid possible damage to wheel
bearing before tightening drive shaft nut fully.

2004 Mitsubishi Endeavor LS
2004 SUSPENSION Rear Axle < AWD > - Endeavor

<<B>> DRIVE SHAFT REMOVA
L
1. Use special tools MB990242, MB990244, MB991354 and MB990767 to push
out the drive shaft from the hub.
Fig. 30: Pusing Out Drive Shaft From Hub

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
CAUTION:
Do not pull on the drive shaft; doing so will
damage the TJ; be sure to use special tools
MB991721, MB991833 and MB991961. When pulling the drive shaft out from the
differential carrier, be careful that the spline
part of the drive shaft does not damage the
oil seal.

2004 Mitsubishi Endeavor LS
2004 SUSPENSION Rear Axle < AWD > - Endeavor

Q: Is the ABS sensor in good condition?
YES: Go to Step 6.
NO: Replace the ABS sensor. Then go to Step 16.
STEP 6. Check the wheel bearing for looseness.
DTC C1201 is set: Check the front right wheel bearing (Refer toWHEEL BEARING END PLAY CHECK
).
DTC C1206 is set: Check the front left wheel bearing (Refer to WHEEL BEARING END PLAY CHECK
).
DTC C1211 is set: Check the rear right wheel bearing (Refer to WHEEL BEARING END PLAY CHECK
).
DTC C1216 is set: Check the rear left wheel bearing (Refer to WHEEL BEARING END PLAY CHECK
).
Q: Is the wheel bearing end play within the standard value?
YES: Go to Step 7.
NO (front bearing end play is not within the standard value): Replace
the front hub assembly (Refer to FRONT AXLE HUB ASSEMBLY
, ).
Then go to Step 16.
NO (rear bearing end play is not within the standard value): Replace
the rear hub assembly (Refer to REAR AXLE
). Then go to Step 16.
STEP 7. Check the ABS rotor.
Check the ABS rotor, which DTC code indicates, for foreign material or
deformation.
DTC C1201 is set: Front right ABS sensor DTC C1206 is set: Front left ABS sensor
NOTE: If the wheel bearing is loose, the gap between the ABS
sensor and rotor may become excessive. Check the
wheel bearing, which DTC code indicates, for
looseness.

2004 Mitsubishi Endeavor LS
2004 BRAKES Traction Control, Active Skid Control System - Endeavor