MITSUBISHI L200 2019 (in English) Owner's Guide

Page 21 of 458

The following information is included on themulti information display: odometer, tripme-
ter, average fuel consumption etc.
1- Engine coolant temperature display
o p. 5-06
2- Selector lever position display*
o p. 6-31
3- Speed limiter display* o p. 6-69
4- Gearshift indicator* o p. 6-26
5- Fuel remaining display o p. 5-06
6- Frozen road warning* o p. 5-06
7- Information display o p. 5-03
8- Service reminder o p. 5-07

Refer to “Multi-information display” on page 5-02.
Quick guide
1-192.7((Overview/Quick guide1

Page 22 of 458




























2.7((

Page 23 of 458

Fuel selection...................................................................................... 2-02Filling the fuel tank............................................................................. 2-03Entering or leaving the vehicle........................................................... 2-05Installation of accessories................................................................... 2-05
Modification/alterations to the electrical or fuel systems................... 2-06
Genuine parts...................................................................................... 2-06
Safety and disposal information for used engine oil........................... 2-06
Disposal information for used batteries.............................................. 2-07Generalinformation
2.7((2

Page 24 of 458

Fuel selectionRecommended fuel
Cetane number (EN
590) 51 or higherCAUT,ONzYour vehicle is designed to use only diesel
fuel that meets the EN590 standard.
Use of any other type of diesel fuel (bio die- sel, methylester, etc.) would adversely affect
the engine’s performance and durability.
z If proper “winter” fuel is not used in winter,
the diesel preheat indication lamp may blink and the engine speed may not rise above the
idling speed because of fuel freezing. In this case, keep the engine idling for approxi- mately 10 minutes, then turn off the ignition
switch or put the operation mode in OFF and immediately turn it on or put in ON again to
confirm that the diesel preheat indication lamp is off. (Refer to “Diesel preheat indica-
tion lamp” on page 5-12)NOTEz For diesel fuel, due to the separation of par-
affin, the fluidity of the fuel decreases con- siderably as the temperature falls.
Because of this fact there are two kinds of
fuel: “summer” and “winter”.
This must be considered in winter use.
Select either of the two kinds of fuel in ac- cordance with ambient temperature. Above -5

Page 25 of 458

Filling the fuel tank:ARN,NGzWhen handling fuel, comply with the safe-
ty regulations displayed by garages and
filling stations.
z Fuel is highly flammable and explosive.
You could be burned or seriously injured when handling it. When refueling your
vehicle, always turn the engine off and
keep away from flames, sparks and smok- ing materials. Always handle fuel in well- ventilated outdoor areas.
z Before removing the fuel cap, be sure to
get rid of your body

Page 26 of 458

1- Remove
2- Close

[Vehicles for Type 3@
Open the cover (1). Insert the key in the
fuel cap (2) and unlock it.
Turn the fuel cap and remove it.
CAUT,ONz Since the fuel system may be under pressure,
remove the fuel cap slowly. This relieves any pressure or vacuum that might have
built up in the fuel tank. If you hear a hissing sound, wait until it stops before removing the fuel cap. Otherwise, fuel may spray out,
injuring you or others.NOTEz While filling with fuel, hang the fuel cap on
the hook (A) located on the inside of the fuel
tank filler door.4. Insert the gun in the tank port as far as it
goes.CAUT,ONz Do not tilt the gun.
5.
When the gun stops automatically, do
not fill with fuel any more.

6. [Vehicles for Type 1, 2@ To close, turn the fuel cap slowly clock-
wise until you hear clicking sounds, then
gently push the fuel tank filler door closed.
[Vehicles for Type 3@
To close, turn the fuel cap slowly clock-
wise until you hear clicking sounds, then
turn the key clockwise to lock the fuel cap.
Filling the fuel tank
2-042.7((General information2Type 2 Type 3 Type 1 Type 2

Page 27 of 458

Entering or leaving the
vehicleCAUT,ONz To avoid slipping and damaging the painted
surface, do not step on the cover of the side
step (A).Installation of accessories
We recommend you to consult your
MITSUBISHI MOTORS Authorized Service
Point.
CAUT,ONz Your vehicle is equipped with a diagnosis
connector for checking and servicing the
electronic control system.
Do not connect a device other than a diagno- sis tool for inspections and service to this
connector.
Otherwise, the battery could be discharged, the electronic devices of the vehicle could malfunction, or other unexpected problems could result.
In addition, malfunctions caused by connect-
ing a device other than a diagnosis tool may not be covered under warranty.
z The installation of accessories, optional
parts, etc., should only be carried out
within the limits prescribed by law in your country, and in accordance with the
guidelines and warnings contained with-
in the documents accompanying this ve- hicle.
z Improper installation of electrical parts
could cause fire, please refer to the Mod-
ification/ alteration to the electrical or fuel systems section within this owner’s manual.
z When installing the radio, for the re-
quired information (frequency, transmis-
sion output, installing procedure), con-
sult a MITSUBISHI MOTORS Author-
ized Service Point.
If the frequency, transmission output and installing condition are not appropriate,
it can adversely affect the electronic de- vices and could lead to unsafe vehicle
operation.
z Using a cellular phone or radio set inside
the vehicle without an external antenna
may cause electrical system interference,
which could lead to unsafe vehicle oper- ation.
z Tyres and wheels which do not meet
specifications must not be used.
Refer to the “Specifications” section for
information regarding wheel and tyre
sizes.
Important points!
Due to a large number of accessories and re-
placement parts of different manufactures available in the market, it is not possible, not
only for MITSUBISHI MOTORS , but also
for a MITSUBISHI MOTORS Authorized
Service Point, to check whether the attach-
ment or installation of such parts affects the overall safety of your vehicle.

Entering or leaving the vehicle
2-052.7((General information2

Page 28 of 458

Even when such parts are officially Author-ized, for example by a “general operators per-
mit” (an appraisal for the part) or through the
execution of the part in an officially approved manner of construction, or when a single op-
eration permit following the attachment or in- stallation of such parts, it cannot be deduced from that alone, that the driving safety of your vehicles has not been affected.

Consider also that there basically exists no li-
ability on the part of the appraiser or the offi- cial. Maximum safety can only be ensured
with parts recommended, sold and fitted or
installed by a MITSUBISHI MOTORS Au-
thorized Service Point ( MITSUBISHI
MOTORS GENUINE replacement parts and
MITSUBISHI MOTORS accessories). The
same also pertains to modifications of vehi- cles with respect to the production specifica-
tions. For safety reasons, do not attempt any modifications other than those that follow the
recommendations of a MITSUBISHI
MOTORS Authorized Service Point.Modification/alterations to
the electrical or fuel systems
MITSUBISHI MOTORS has always manu-
factured safe, high quality vehicles. In order
to maintain this safety and quality, it is im-
portant that any accessory that is to be fitted,
or any modifications carried out which in-
volve the electrical or fuel systems, should be carried out in accordance with MITSUBISHI
MOTORS guidelines.CAUT,ONz If the wires interferes with the vehicle body
or improper installation methods are used (protective fuses not included, etc.), elec-
tronic devices may be adversely affected, re-
sulting in a fire or other accident.Genuine parts
MITSUBISHI MOTORS has gone to great
lengths to bring you a superbly crafted vehi-
cle offering the highest quality and dependa- bility.
Use MITSUBISHI MOTORS GENUINE
Parts, designed and manufactured to maintain your MITSUBISHI MOTORS vehicle at top
performance. MITSUBISHI MOTORS GEN-
UINE Parts are identified by this mark and are available at all MITSUBISHI MOTORS
Authorized Service Points.Safety and disposal
information for used engine
oil:ARN,NGz Prolonged and repeated contact may
cause serious skin disorders, including
dermatitis and cancer.
z Avoid contact with the skin as far as pos-
sible and wash thoroughly after any con-
tact.
z Keep used engine oils out of reach of chil-
dren.
Modification/alterations to the electrical or fuel systems
2-062.7((General information2

Page 29 of 458

Protect the environment
It is illegal to pollute drains, water coursesand soil. Use authorized waste collection fa-cilities, including civic amenity sites and ga- rages providing facilities for disposal of used
oil and used oil filters. If in doubt, contact your local authority for advice on disposal.
Disposal information for
used batteriesYour vehicle contains batter-
ies and/or accumulators.
Do not mix with general household waste.
For proper treatment, recov-
ery and recycling of used bat-
teries, please take them to ap- plicable collection points, in
accordance with your nation- al legislation and the Direc-tives 2006/66/EC.
By disposing of these batter- ies correctly, you will help to
save valuable resources and
prevent any potential nega-
tive effects on human health and the environment which could otherwise arise frominappropriate waste handling.
Disposal information for used batteries
2-072.7((General information2

Page 30 of 458




























2.7((

Page:   < prev 1-10 11-20 21-30 31-40 41-50 51-60 61-70 ... 460 next >