cylinder head MITSUBISHI LANCER 2006 Workshop Manual

EXHAUST MANIFOLD
INTAKE AND EXHAUST15-7
INSPECTION
M1151003100616
Check the following points; replace the part if a prob-
lem is found.
Inlet Manifold Check
1. Check for damage or cracking of any part.
2. Clogging of the negative pressure (vacuum) outlet port, or clogging of the exhaust gas recirculation
passages.
3. Using a straight edge and feeler gauge, check for distortion of the cylinder head installation surface.
Standard value: 0.15 mm or less
Limit: 0.20 mm
EXHAUST MANIFOLD
REMOVAL AND INSTALLATION <4G1>
M1151003300568
AC30366250 ± 10 N·m
24 ± 4 N·m
35 ± 6 N·m 17 ± 2 N·m
30 ± 2 N·m
N
3
7 12
4
N
6
8
44 ± 5 N·m
AB
9
5N
30 ± 2 N·m
30 ± 2 N·m
30 ± 2 N·m
(Engine oil)
8.Battery wirin g ha rne s s clamp
9.Inlet manifold st ay
10.Inlet manifold
11.Inlet manifold gask et
12.Emission vacuu m hose & pipe and
emis
sion s o lenoid valve assembly
13.EGR v a lve
14.EGR v a lve gasket
Remo va l st ep s ( C o n t in u e d)

STEERING COLUMN SHAFT ASSEMBLY
POWER STEERING37-22
DISASSEMBLY AND REASSEMBLY
M1372015000068
AC210967AD
3
2
14
Disassembly steps
<<A>>>>A<<1.Special bolt
>>A<<2.Steering lock bracket
>>A<<3.Steering lock cylinder assembly
4.Steering column shaft assembly
DISASSEMBL
Y SER V ICE POINT
<<A>> SPECIAL BOLT REMOV A L
ACX01138
AB
Steering lock
bracket
Reverse screw tap
Special bolt
Steering lock
cylinder
1. Drill in the special bo lt a ho le de ep enou gh for th e
t ap t o st and.
2.Remove the special b o lt with a lef t -h and t ap.
REASSEMBL Y SER V ICE POINT
>>A<< STEERING LOCK CYLINDER
ASSEMBL
Y /STEERING LOCK
BRACKET/SPECIAL BOL
T INST ALLA
-
TION
CAUTION
The steering lock bracket and bolts must be
replaced with new ones when the steering lock is
installed.
1. When installing the steering lock cylinder assembly and steering lock bracket to the column
tube, temporarily install the steering lock in
alignment with the column boss.
ACX01139 AB
2. After checking that the lock works properly,
tighten the special bolts until the head twists off.