child restraint MITSUBISHI LANCER EVOLUTION X 2008 Workshop Manual
Page 156 of 241
SEAT
INTERIOR52A-7
REAR SEATM2520007000605
A low-back bench seat is used for rear seat. The rear
seat offer the following advantages:
•The center armrest has a cup holder.
•An upper tether anchor has been installed on the
rear shelf trim, and an ISO-FIX lower anchor has
been installed on the body side.
AC609174
Cup holderHead restraint
vertical adjustrment
Head restraint
vertical adjustrment
Rear seatback
forward folding
AB
<Bench seat>
<Trunk through seat>
<Lower anchorage for child seat>
<Uper tether anchor>
Page 171 of 241
TRIMS
TSB Revision
INTERIOR52A-10
TRIMS
REMOVAL AND INSTALLATIONM1521001101049
Required Special Tool:
•MB990784: Ornament Remover
AC610310
45
1 3
6
2 79
11
12
10
13
AB
8
14
22 ± 4 N·m
16 ± 3 ft-lb
Removal steps
1.Front scuff plate
2.Cowl side trim
•Rear seat cushion (Refer
to
P.52A-23).
3.Rear scuff plate
4.Front door opening trim
5.Rear door opening trim
<<A>>6.Front pillar trim
7.Lower center pillar trim
8.Upper center p illar trim cap
•Outer seat belt (Refer toP.52A-28).
9.Upper center pillar trim
10.Rear pillar trim
•Seat side back (Refer toP.52A-23).
11 .Rear shelf trim
12.Rear end trim
13.Trunk side trim
14.Child restraint fitting
Removal steps (Continued)