warning light MITSUBISHI MONTERO 2000 Service User Guide

SWS -Troubleshooting54B-55
Terminal
No.Normal condition Checking requirements Check items
26Key reminder switch signal inputKey reminder switch: ON (Ignition key
removed)0V
27Hazard warning lamp switch signal
inputHazard warning lamp switch: ON0V
29Recognition line of daytime running
lamp (DRL) <Vehicles with DRL>Always0V
31Data request signal outputAlways0 - 5 V (pulse
signal)
34Windshield intermittent wiper interval
adjusting knob signal inputIgnition switch: ACC,
Windshield intermittent wiper interval
adjusting knob: FAST®SLOW0®2.5 V
35Back-up lamp switch signal input
<M/T>Ignition switch: ON,
Shift lever: RSystem voltage
Inhibitor switch (reverse) signal input
<A/T>Ignition switch: ON,
Selector lever: RSystem voltage
36Ignition key hole illumination lamp
outputWhen ignition key hole illumination
lamp is lighted2 V or less
37Diagnosis code or input signal check
outputWhen diagnosis code is output0 - 12 V (pulse
signal)
When input signal check is output0, 12 V (When input
pulse signal is
changed)
40Rear fog lamp relay outputWhen rear fog lamp is lighted2 V or less
53Front passenger’s and back door lock
key cylinder switch (LOCK) signal inputFront passenger’s or back door lock key
cylinder switch: LOCK0V
54Front passenger’s and back door lock
key cylinder switch (UNLOCK) signal
inputFront passenger’s or back door lock
switch: UNLOCK0V
55Driver’s door lock actuator switch
(LOCK) signal inputDriver’s door lock actuator switch:
LOCK0V
56Driver’s door lock actuator switch
(UNLOCK) signal inputDriver’s door lock actuator switch:
UNLCOK0V


www.WorkshopManuals.co.uk


Purchased from www.WorkshopManuals.co.uk