engine oil MITSUBISHI TRITON 1997 Owner's Guide

STEERING ± Service Specifications37A-3
SERVICE SPECIFICATIONS37100030021
ItemsStandard valueLimit
Steering wheel free play mmWith engine running±50
With engine stopped10 or less±
Steering angle2WDInner wheel33
55' ± 36
55'±
Outer wheel30
57'±
4WDInner wheel29
40' ± 32
40'±
Outer wheel29
30'
Steering gear backlash mm±0.5
Variation of tie rod end ball joint shaft direction mm±1.5
Tie rod end ball joint starting torque Nm3.0±
Steering gear oil level mm22±
Engine idle speed r/min4G6750 + 100±
4D56750 + 100±
Stationary steering effort N39.2 or less±
Oil pump
p
ressure MPa
Oil pump relief pressure8.3 ± 9.0±
ressure MPa
Pressure under no-load conditions0.8 ± 1.0±
Steering gear retention hydraulic pressure8.3 ± 9.0±
Oil pressure switch operating pressure MPaOFF
ON1.5 ± 2.0±
ON
OFF0.7 ± 1.2±
Mainshaft starting torque Nm0.49 ± 0.78±
Cross-shaft axial play mm0.05 or less±
Mainshaft total starting torque Nm<2WD>0.98 ± 1.47±
<4WD>0.69 ± 1.28±
Pitman arm ball joint starting torque Nm0.5 ± 1.5±
Mainshaft axial play mm0.03 or less±
Backlash between ball groove of rack piston and balls mm±0.05
Idler arm sliding resistance N2WD8.8 ± 30±
4WD2.4 ± 16±

2
SERIVICE SPECIFICATIONS
ItemsStandard value Limit
With engine running - 50Steering W heel free play mm
With engine stopped 10 or less -
Inner wheel 33°55’-36°55’ -2W D
Outer wheel 30°57’ -
Inner wheel 29°40’-32°40’ -
Steering angle
4W D
Outer wheel 29°30’
Steering gear backlash mm - 0.5
Variation of tie rod end ball joint shaft direction mm - 1.5
Tie rod end ball joint starting torque Nm 3.0 -
Steering gear oil level mm 22 -
4G6 750 ± 100 -Engine idle speed r/min
4D56 750 ± 100 -
Stationairy steering effort N 39.2 or less -
Oil pump relief pressure 8.3 - 9.0 -
Pressure under no-load conditions 0.8 - 1.0 -
Oil pump
pressure MPa
Steering gear retention hydraulic pressure 8.3 - 9.0 -
OFF →
ON 1.5 – 2.0 -Oil pressure switch operating pressure Mpa
ON →
OFF 0.7 – 1.2 -
Mainshaft starting torque Nm 0.49 – 0.78 -
Cross-shaft axial play mm 0.05 or less -
<2WD> 0.98 – 1.47 -Mainshaft total starting torque Nm
<4WD> 0.69 – 1.28 -
Pitman arm ball joint starting torque Nm 0.5 – 1.5 -
Mainshaft axial play mm 0.03 or less -
Backlash between ball groove of rack piston and balls mm - 0.05
2WD 8.8 – 30 -Idler arm sliding resistance N
4WD 2.4 – 16 -
STEERING – Service Specifications37A-3
37100030021
<Deleted>