buttons OLDSMOBILE AURORA 1995 User Guide

Close the door by sliding it all the way to the left. If the
door is left partially open, the changer will
not operate
and an error will occur.
When the door is closed, the changer
will begin
checking for discs
in the cartridge. This will continue
for
up to 1 1/2 minutes depending on the number of
discs loaded.
To eject the cartridge from the player, simply slide
the
CD changer door all the way open. The cartridge will
automatically eject. Remember to keep the door closed
whenever possible to prevent dirt and dust from getting
inside the changer.
AI1 of the CD functions are controlled by the radio
buttons except for ejecting the cartridge. Whenever
a
CD cartridge with discs is loaded in the changer, “CD”
will appear
in the radio display. If the CD changer is
checking the cartridge for CD’s, TD”
will flash in the
display
until the changer is ready to play. When a CD
begins playing, a box will appear around “CD“ along
with the disc number and track number. The disc
numbers are listed on the front
of the cartridge.
If or “E“ and a number appear on the display at
any time, an error has occurred. See “Cassette Tape and
CD Errors” later
in this section.
TAPE/CD or TAPE/AUX: If you have a cartridge
loaded
in the changer and the radio is playing, press
TAPE/CD
or TAPE/AUX to play the CD. To return to
the radio while a CD is playing, press
AM/FM. You can
also press TAPE/CD or TAPE/AUX to switch between a
tape and compact disc if both are loaded.
PROG: Press PROG to select the next disc in the
cartridge. Each time you press PROG, the disc number
on the radio display
will increment to the next available
CD.
If one of your CD’s cannot be played, its number
will be skipped when selecting discs with PROG.
3-23
-
ProCarManuals.com

To Enable the Theftlock@ Feature
The instructions which follow explain how to enter your
secret code to activate the Theftlock@ system. It
is
recommended that you read through all nine steps
before starting the procedure.
1. Write down any three- or four-digit number from
000 to 1999 and keep it in a safe place separate from
the
vehicle.
2. Turn the ignition to the ACCESSORY or RUN
position.
3. Press the PWR/VOL button to turn the radio off.
NOTE:
If you allow more than 15 seconds to elapse
between any steps,
the radio automatically reverts to
time and you must start the procedure over at step 4.
4. Press the 1 and 4 buttons together. Hold them down
until “---” shows on the display. Next you will use
the secret code number which you have written
down.
5. Press the MN button and “000” will appear on the
display.
6. Press MN again to make the last two digits agree
7. Press the HR button to make the first one or two
with
your code.
digits agree with your code.
8. After you have confirmed that the code matches the
one you wrote down, press AM/FM. The display will
show “rEP” to indicate that you need to repeat steps
5-7 to confirm your secret code.
9. Press AMEM and this time the display will show
Any time Theftlock@
is activated and the battery power
is removed, the radio
will display “LOC.”
“SEC” indicating that your radio is secure.
To Unlock Theftlock@ After a Power Loss
Enter your secret code as follows; pause no more than
15 seconds between steps:
1. “LO”’ will appear when the ignition is on.
2. Press the MN button and “000” will appear on the
display.
3. Press MN again to make the last two digits agree
with your code.
ProCarManuals.com

4. Press the HR button to make the first one or two
digits agree with your code.
5. After you have confirmed that the code in the display
matches the secret code
you have written down,
press AM/FM. “SEC” will appear
in the display,
indicating that the radio is now operable and secure.
If the code entered to unlock Theftlock@ is incorrect, the
radio will remain locked. After eight unsuccessful
attempts to unlock
the radio, the display will show
“InOP” (inoperative). At this point you will need
to
keep the ignition on for one hour before you may
attempt to enter another code. After three unsuccessful
attempts to unlock the radio,
the display will show
“InOP” (inoperative) again.
If you forget your code or cannot unlock the radio,
contact your retailer for assistance.
To Disable Theftlock@
Enter your secret code as follows; pause no more than
15 seconds between steps:
1.
2.
3.
4.
5.
4.
7.
Turn the ignition to the ACCESSORY or RUN
position.
Press the PWR/VOL button to
turn the radio off.
Press the
1 and 4 buttons together. Hold them down
until “SEC” shows in the display.
Press the MN button and
“000” will appear on the
display.
Press MN again to make the last two digits agree
with your code.
Press the
HR button to make the first one or two
digits agree with your code.
After you have confirmed that the code in the display
matches the secret code you have written down,
press AMEM. The display will show
“---”
indicating that the radio is no longer secured.
If the code entered is incorrect, “SEC” will appear in the
display. The radio
will remain secured until the correct
code is entered.
3-27
ProCarManuals.com