OPEL MERIVA 2009 Workshop Manual

45
Seats, Interior
Picture no: 13979s.tif
Adjusting the seat height3
Lift front side lever and relieve some weight
from seat to raise it or press down on seat
with body weight to lower it.
Picture no: 16098s.tif
Adjusting the lumbar support 3
Turn side hand wheel on backrest while
relieving the load on the backrest.
Picture no: 18530s.tif
Seat position
z Sit with your buttocks as far back against
the backrest as possible. Adjust the
distance between your feet and the
pedals so that your legs are slightly
angled when pressing the pedals. Slide
the passenger seat as far back as
possible.
9 Warning
Only drive with the seat correctly
adjusted.

46 Seats, InteriorzSit with your shoulders as far back
against the backrest as possible. Set the
backrest rake so that you can easily
reach the steering wheel with your arms
slightly bent. Mainta in contact between
your shoulders and the backrest when
turning the steering wheel. Do not angle
the backrest too far back. We
recommend a maximum rake of
approx. 25.
z Adjust the steering wheel 35.
z Set seat height 3 high enough to have a
clear field of vision on all sides and of all
display instruments. There should be at
least six inches of clearance between
your head and the headlining. Your
thighs should rest lightly on the seat
without pressing into it.
z Adjust the head restraint.
z Adjust the height of the seat belt 362.
z Adjust the lumbar support 3 so that it
supports the natural shape of the spine.
Picture no: 14153s.tif
Heated front seats 3
Two buttons between the centre air vents
for the left and right seats.
To heat with the ignition switched on, press
button ß.
Picture no: 13980s.tif
Head restraints Adjusting the front head restraints and
the rear outboard head restraints 3
Tip head restraint forw ard, hold and adjust
height.
To fold over the rear seats or lower the
front passenger seat head restraint all the
way down and remove, see next page.
With the seats occupi ed, adjust height
according to body size.

47
Seats, Interior
Picture no: 14102s.tif
Adjusting the rear centre head restraint
Pull head restraint upwards, press springs
and push head restraint down.
To improve visibility push headrest down
as far as possible if middle seat is
unoccupied or to increase the size of the
luggage compartment.
Fold down centre seat 354.
If centre seat is occupied, pull head
restraint upwards.
Picture no: 14101s.tif
Head restraint position
The middle of the head restraint should be
at eye level. If this is not possible for
extremely tall persons, set to highest
position, and set to lowest position for
small persons.
Picture no: 14287j.tif
Active head restraints 3 on front seats
In the event of a rear-end impact, the
active head restraints automatically tilt
slightly forward. The head is more
effectively supported by the head restraint
and the danger of injury in the area of the
cervical vertebra is reduced.
Active head restraints can be recognised
by the word ACTIVE.
9 Warning
Only drive with the head restraint set to
the proper position.

48 Seats, Interior
Picture no: 11581s.tif
Removing
Press and release the two catches. Pull and
remove the head restraint.
To fold down the rear seat backrests 3
3 53, push rear head re straints fully down.
Note
Only approved objects or components
must be attached to the head restraint of
the unoccupied front passenger seat.
Picture no: 14738s.tif
Armrest
3
Armrest at driver’s seat
Push raised armrest backward against
resistance and fold down.
The armrest can be moved to different
positions in stages by lifting it.
If the armrest is not required, it can be
folded up.
Armrest 3 between rear seats
See "Travel Assistant, armrest" 3 49.
Picture no: 14304s.tif
Travel Assistant
3
The Travel Assistant Contains
zArmrest,
z Tray,
z Drink holders.
The Travel Assistant is mounted on the
lowered centre seat 354.

49
Seats, Interior
Picture no: 14310s.tif
Installing The Travel Assistant
Lower centre seat 354.
Insert Travel Assistant in rear recesses on
back of middle seat.
Picture no: 14311s.tif
Fold Travel Assistant down and audibly
engage in front recesses.
Picture no: 14312s.tif
Armrest
The arm rest can be moved and therefore
adapted to the position of the outboard
seats.
9 Warning
If it is not correctly engaged, the Travel
Assistant can be propelled forward with
considerable force if hard braking
occurs, possibly causing injury.

50 Seats, Interior
Picture no: 14313s.tif
Tray
There is a tray beneath the armrest. Open
tray by pushing upper button.
Picture no: 14314s.tif
Drink holder
Open drink holder on front by pressing
front face.
Picture no: 14315s.tif
Dismantling the Travel Assistant
Press lower button on the Travel Assistant.

51
Seats, Interior
Picture no: 14316s.tif
Pull Travel Assistant upwards out of
recesses.
There is a carrying handle on the back to
facilitate transport.
It is not necessary to remove the Travel
Assistant if you wish to raise the centre
seat, however, the armrest must be pushed
forwards. Be careful of any items in the
Travel Assistant.
Picture no: 14178s.tif
Rear seats Sliding outboard rear seats front-rear
The rear outboard seats can be
individually adjusted front-rear.
Pull handle under seat, move seat, release
handle and allow seat to engage.
When pushing the seats back, to prevent
damage make sure the backrests are not in
their furthest back position.
Picture no: 14179s.tif
Adjust backrest rake of rear outboard
seats
Grasp backrest, pull handle at outboard
side of seat and guide backrest, unloaded,
into the required position. Release handle
and allow backrest to engage.
The backrest rake can be set in three
positions.

52 Seats, InteriorTo achieve a flat loading surface in the
extended luggage compartment, the
outboard seats can be lowered slightly. We
recommend however only using the seats
as seats in the raised position. Extending
the luggage compartment 353.
Flexible Seat System (FlexSpace)The rear seat row on the Meriva can be
fitted with three seats in Variant 1, or two
seats with maximum seating space in
Variant 2. In Variant 2, the centre seat is
lowered.
The luggage compartment can only be
extended in Variant 1 353.
To extend the luggage compartment, the
outboard seats can be lowered slightly
3 54.
Picture no: 14730s.tif
Variant 1: Three rear seats
Set seat backrest to centre position using
the handle on the outside of the seat 351.
Pull the handle beneath the seat. Slide the
seat all the way forward, then outward
toward the door and then further forward
to the desired position.
Release handle and allow seat to engage
in position.
Raise centre seat 354.
9 Warning
To prevent injuries, always hold back
seat backrest firmly and guide
downward when folding.

53
Seats, Interior
Picture no: 14729s.tif
Variant 2: Two rear seats
Lower the centre seat by pulling the release
handle on the back of the centre seat
backrest, fold backrest forward and
engage 354.
Set seat backrest to centre position using
the handle on the outside of the seat 351.
Pull the handle beneath the seat. Slide the
seat all the way back, then inward toward
the middle of the vehicle, and then further
back to the desired position
Release handle and allow seat to engage
in position.
Luggage compartment extension To increase the size of the luggage
compartment you can
z fold down the outboard rear seat
backrests,
z lower the middle seat,
z lower the folded outboard seats,
z fold down the passenger seat
backrest 3,
see following instructions.
The rear seats must also be in "Variant 1:
Three rear seats" 352.
Picture no: 14184s.tif
Fold down the outboard rear seat
backrests
Remove the luggage compartment
cover 3 if necessary 355.
Push head restra ints down fully, 33, 346.
Take seat belt out of the belt guide on the
backrest.
Remove the push-in sleeves 3 for
mounting the ISO-FIX child restraint
system – see separate instructions for the
ISO-FIX child restraint system.

54 Seats, Interior
Picture no: 14182s.tif
Grasp the backrest, pull the handle at the
outboard side of the seat and fold the
backrest onto the seat. Release the handle
and engage the backrest.
To raise, pull the handle on the outboard
side of the seat and raise the backrest.
Release the handle and engage.
Insert the seat belt into the belt guide at
backrest.
Picture no: 14728s.tif
Fold the centre seat forward and lower.
House centre seat belt in the holder in the
ceiling 363.
Insert seat belts into recesses in seat
cushion.
Slide centre seat head rest all the way
down 347.
Pull release handle on the back of the
centre seat backrest, see figure. Fold
backrest forward and engage. The entire
seat is lowered.
Picture no: 14716s.tif
Raise centre seat
Pull release handle on the back of the
backrest, erect the ba ckrest and engage,
the outer seats must be in the outer
position, see Variant 1: Three rear seats
3 52.
Lower outboard seats
Push front seat forward and fully lower or
remove head restraints on the rear
outboard seats 347.
Fold outer rear seat backrests onto seat
bases.
To achieve a level loading surface, pull
release handle on back of backrest and
push seat down until it latches into
position.
9 Warning
To prevent injuries, always hold the seat
backrest firmly and guide downward
when folding.
9 Warning
The load must not hinder the operation
of the hand brake or gear lever 358.