PEUGEOT 206 2004.5 Manual Online

80 -
31-01-2005
81
-
31-01-2005
4. Air conditioning
Press this button to stop air
cooling. The symbol ECO is
displayed. Automatic opera-
tion of the air conditioning is
resumed when the button is pressed
again. The symbol A/C is displayed.
Note
It is quite normal that the condensa-
tion created by the air conditioning
results in a low of water under the
vehicle when it is stationary.
To prevent condensation on the
inside of the vehicle in cold or wet
weather, you are advised to avoid
using the ECO mode.
5. Air distribution Pressing this button several
times in succession enables
the air low to be directed in
turn towards:
- the windscreen (de-icing or de- misting),
- the windscreen and the footwells,
- the footwells,
- the centre and side vents and the footwells,
- the centre and side vents. 6. Air low
The low of air can be
increased or reduced
by pressing buttons +
or - respectively.
7. Air intake 8. Switching the system off
The OFF button switches
off all the functions of the
system.
Temperature-related com-
fort and demisting are no longer
guaranteed but a slight low of air is
maintained.
Pressing the OFF, AUTO , or vis-
ibility button again reactivates the
system with the values set before it
was switched off.
Note: if you wish to cut off the low
of air completely, press the air intake
button 7.
9. Demisting the rear screen and the mirrors
Press this button to demist
the rear screen and the mir-
rors. Demisting switches off
automatically. It is possible
to stop operation of the demisting
before it is switched off automatically
by pressing the button again.
Important precaution
Operate the air conditioning for 5 to
10 minutes, once or twice a month,
to keep it in good working order.
If the system does not produce cold
air, do not use it and contact your
PEUGEOT dealer.
Press this button for recir-
culation of the interior air.
Recirculation, shown on the
display, enables the pas-
senger compartment to be insulated
from exterior odours and smoke.
Avoid prolonged recirculation of inte-
rior air. To do this, press the button
again to resume automatic manage-
ment of the intake of air.
Note: To prevent condensation on
the inside of the vehicle in cold or wet
weather, you are advised to avoid us-
ing this mode.
Comfort

82 -
31-01-2005
83
-
31-01-2005
Saloon and 206 SW
Comfort

82 -
31-01-2005
83
-
31-01-2005
206 GTi 180
Comfort

84 -
31-01-2005
85
-
31-01-2005
FRONT SEATS
1 - Forwards-backwards
adjustment
Lift the control and slide the seat for-
wards or backwards.
2 - Head restraint height and angle adjustment
(except 206 GTi 180)
To raise the restraint, push it up-
wards.
The adjustment is correct when
the upper edge of the head re-
straint is level with the top of the
head.
The head restraint is itted with a
frame with notches, which prevent
the head restraint dropping down
(this is a safety device in the case of
impact).
To lower the head restraint, it is nec-
essary to push simultaneously:
- the button located at the base of the head restraint frame,
- the head restraint downwards.
To remove the head restraint, press
the lug.
The head restraint angle can also be
adjusted. 4 - Height adjustment
Pull the handle upwards.
Remove your weight from the seat to
raise, or press on the seat to lower.
5 - Seat back angle adjustment
Push the handle towards the rear.
Never drive with the head
restraints removed; they
should be in place and
correctly adjusted. Rear head restraints
These have one position for when
they are in use (high) and a stor-
age position (low). They can be
removed.
To lower the head restraints, press
the lug.
To remove them, pull upwards as far
as the stop then press the release
control.
3 - Access to the rear seats
(3-door), A or B according to
version
A - Place your ingers in one of the
two handles and push forwards to
fold down the seat back and move
the seat forwards.
When put back, the seat returns to its
initial position.
No person or object must prevent
the seat from returning to its initial
position. Returning to this position is
necessary for it to be locked.
It is impossible to access the rear
seats if the front seat is in a reclining
position.
B - Place your ingers in one of the
two handles and push forwards to
fold down the seat back.
When put back, the seat back returns
to its initial position.
Comfort

84 -
31-01-2005
85
-
31-01-2005
FRONT SEATS
1 - Forwards-backwards
adjustment
Lift the control and slide the seat for-
wards or backwards.
2 - Head restraint height and angle adjustment
(except 206 GTi 180)
To raise the restraint, push it up-
wards.
The adjustment is correct when
the upper edge of the head re-
straint is level with the top of the
head.
The head restraint is itted with a
frame with notches, which prevent
the head restraint dropping down
(this is a safety device in the case of
impact).
To lower the head restraint, it is nec-
essary to push simultaneously:
- the button located at the base of the head restraint frame,
- the head restraint downwards.
To remove the head restraint, press
the lug.
The head restraint angle can also be
adjusted. 4 - Height adjustment
Pull the handle upwards.
Remove your weight from the seat to
raise, or press on the seat to lower.
5 - Seat back angle adjustment
Push the handle towards the rear.
Never drive with the head
restraints removed; they
should be in place and
correctly adjusted. Rear head restraints
These have one position for when
they are in use (high) and a stor-
age position (low). They can be
removed.
To lower the head restraints, press
the lug.
To remove them, pull upwards as far
as the stop then press the release
control.
3 - Access to the rear seats
(3-door), A or B according to
version
A - Place your ingers in one of the
two handles and push forwards to
fold down the seat back and move
the seat forwards.
When put back, the seat returns to its
initial position.
No person or object must prevent
the seat from returning to its initial
position. Returning to this position is
necessary for it to be locked.
It is impossible to access the rear
seats if the front seat is in a reclining
position.
B - Place your ingers in one of the
two handles and push forwards to
fold down the seat back.
When put back, the seat back returns
to its initial position.
Comfort

84 -
31-01-2005
85
-
31-01-2005
- position the seat belt under the belt
holder 2,
- pull control 3 to unlock the seat
back 4,
- remove or lower the head restraint,
- tilt the seat back 4.
Always start with the seat, never
the seat back (risk of damage).
REAR SEATS
To fold the rear seats:
- lift the front of the seat cushion 1,
- tilt the seat cushion 1 against the
front seats, When repositioning:
- return the seat back to the upright
position,
- fold back the seat cushion,
- reposition the lap belt and the buckles before locking the front of
the seat cushion.
Take care not to trap the seat
belts.
Comfort

86 -
31-01-2005
87
-
31-01-2005
- position the seat belt under the belt
holder 2,
- pull the controls 3 to unlock the
seat back 4,
- remove or lower the head re- straints,
- tilt the seat back 4.
Always start with the seat, never
the seat back (risk of damage).
BENCH SEAT
To fold the bench seat:
- lift the front of the seat cushion 1,
- tilt the seat cushion 1 against the
front seats, When repositioning:
- return the seat back to the upright
position,
- fold back the seat cushion,
- reposition the lap belt and the buckles before locking the front of
the seat cushion.
Take care not to trap the seat
belts.
Comfort

86 -
31-01-2005
87
-
31-01-2005
TRANSPORTING LONG
OBJECTS
Front seat:
- Tilt the seat back towards the front
using the control 5 (see corres-
ponding paragraph).
Removing the rear seat
- Tilt the seat cushion against the front seats.
- Squeeze the seat fasteners to re- lease them from their attachments.
- Remove the seat cushion.
Folding seat back
- Remove the head restraint for com- plete folding of the seat back.
- Push either of the two handles 5 to-
wards the rear to tilt the seat back.
Rear seat:
- Remove the seat cushion,
- Tilt the seat back.
Comfort

86 -
31-01-2005
87
-
31-01-2005
- position the seat belt under the belt
holder 2,
- pull the controls 3 to unlock the
seat back 4,
- remove or lower the head re- straints,
- tilt the seat back 4.
Always start with the seat, never
the seat back (risk of damage).
BENCH SEAT
To fold the bench seat:
- lift the front of the seat cushion 1,
- tilt the seat cushion 1 against the
front seats, When repositioning:
- return the seat back to the upright
position,
- fold back the seat cushion,
- reposition the lap belt and the buckles before locking the front of
the seat cushion.
Take care not to trap the seat
belts.
Comfort

88 -
31-01-2005
89
-
31-01-2005
GENERAL POINTS RELATING
TO CHILD SEATS
Although one of PEUGEOT's main
criteria when designing your vehicle,
the safety of your children also de-
pends on you.
For maximum safety, please follow
these precautions:
- Since 1992, all children under
the age of 10 must travel in ap-
proved child seats* suited to
their weight , on seats itted with a
seat belt or ISOFIX mountings**.
- A child weighing less than 9 kg
must travel in the rearwards
facing position both in the front
and in the rear. PEUGEOT rec-
ommends that children should
travel in the "rearwards facing"
position up to the age of two.
- Statistically, the safest seats in
your vehicle for the transpor-
tation of children are the rear
seats. PEUGEOT recommends
that children travel in the rear
even when a "rearwards facing"
child seat is used.
- If a child is travelling on a booster seat, check that the lap section of
the seat belt passes over the child's
thighs correctly. The chest section of the seat belt
must be positioned on the child's
shoulder without touching the
neck. PEUGEOT recommends
that you use a booster seat with a
back, itted with a seat belt guide at
shoulder level.
- Remember to fasten the seat belt or the child seat harness keeping
the slack in relation to the child's
body to a minimum , even for short
journeys.
Special points relating to the
transportation of children on the
front passenger seat*
Children under the age of 10 must not
travel in the forwards facing position,
unless the rear seats are already oc-
cupied by other children or the rear
seats cannot be used (absent or
folded). In this case, adjust the front
passenger seat to the intermediate
longitudinal position and leave the
passenger air bag armed**.
The transportation of children in the
rearwards facing position is permit-
ted. In this position, it is essential
to disarm the passenger air bag**.
Otherwise, the child would risk be-
ing killed or seriously injured if the air
bag were to inlate.
"ISOFIX" MOUNTINGS (a)
The right side seat and left side
seat (a) of the rear seat (saloon and
206 SW) and the one third section of
the rear seat (206 GTi 180) are itted
with ISOFIX mountings . These are
two rings located between the seat
back and the seat cushion.
The ISOFIX child seats are itted
with two locks which are secured
easily on these rings.
Installing a child seat in a vehicle
incorrectly compromises the protec-
tion of the child in the event of an
impact.
This ISOFIX system guarantees reli-
able, safe and fast itting of the child
seat in your vehicle.
* According to current legislation in the country.
** According to model.
Comfort