Ignition Peugeot 307 CC 2003 Owner's Guide

22-09-2003
YOUR 307 CC IN DETAIL
94
Make a careful note of the number on each key. The key number is coded on the label attached to the key. If the keys are lost, your PEUGEOT dealer can rapidly supply you with new keys.The high frequency remote control is a sensitive system; do not operate it while it is in your pocket as there is a possibility that it may unlock your vehicle, without you being aware of it.
The remote control does not operate when the key is in the ignition, even when the ignition is switched off, except forreprogramming. Do not operate the deadlocking function if there is anyone inside the vehicle.Driving with the doors locked may make access to the passenger compartment by the emergency services more difficult
in an emergency. As a safety precaution (with children on board), remove the ignition key when you leave the vehicle, even for a short time.
Do not repeatedly press the button of your remote control out of range of your vehicle. You run the risk of stopping it from working and the remote control would have to be reprogrammed. When purchasing a second-hand vehicle: Ð ensure that you are given the confidential card;
Ð have the key codes memorised by a PEUGEOT dealer, to ensure that the keys in your possession are the only ones which can start the vehicle.
Do not make any modifications to the electronic engine immobiliser system.

22-09-2003
YOUR 307 CC IN DETAIL93
Confidential card The confidential card contains the identification code necessary for anywork carried out by a PEUGEOTdealer on the electronic immobiliser
system. This code is hidden by afilm, which should be removed only
if necessary. Keep your card in a safe place, never inside the vehicle. Key in ignition
A buzzer sounds on opening the dri-
ver's door, if the key has been left inthe ignition. Changing the battery of the remote control
Warning that the battery is flat is given by an audible signal accompa-nied by the message
''Remote con-
trol battery low'' on the multifunc-
tion display.
To replace the battery, remove the screw then unclip the casing using acoin at the ring (CR 2016/3 volt bat-tery). If the remote control does not work after the battery has been changed,reprogramme the remote control. Programming the remote control  Switch off the ignition.
 Switch the ignition on again.
 Press button Aimmediately.
 Switch off the ignition and remove the remote control key
from the ignition lock. The remotecontrol is now working again.
ELECTRONIC ENGINE IMMOBILISER This locks the engine control system as soon as the ignition has been
switched off and therefore preventsstarting of the vehicle by anyone
who does not have the key. The ignition key has an electronic chip which has a special code.When the ignition is switched on, thecode must be recognised for startingto be possible. If the system does not function correctly , the central locking button
indicator light, situated in the centreof the fascia, flashes rapidly whenthe ignition is switched on (2ndnotch), accompanied by an audiblesignal and the message ''Anti-theft
device faulty'' on the multi-function
display. In this case your vehicle will not start.
Contact a PEUGEOT dealer as soon as possible.

22-09-2003
YOUR 307 CC IN DETAIL
94
Make a careful note of the number on each key. The key number is coded on the label attached to the key. If the keys are lost, your PEUGEOT dealer can rapidly supply you with new keys.The high frequency remote control is a sensitive system; do not operate it while it is in your pocket as there is a possibility that it may unlock your vehicle, without you being aware of it.
The remote control does not operate when the key is in the ignition, even when the ignition is switched off, except forreprogramming. Do not operate the deadlocking function if there is anyone inside the vehicle.Driving with the doors locked may make access to the passenger compartment by the emergency services more difficult
in an emergency. As a safety precaution (with children on board), remove the ignition key when you leave the vehicle, even for a short time.
Do not repeatedly press the button of your remote control out of range of your vehicle. You run the risk of stopping it from working and the remote control would have to be reprogrammed. When purchasing a second-hand vehicle: Ð ensure that you are given the confidential card;
Ð have the key codes memorised by a PEUGEOT dealer, to ensure that the keys in your possession are the only ones which can start the vehicle.
Do not make any modifications to the electronic engine immobiliser system.

22-09-2003
YOUR 307 CC IN DETAIL95
THE ALARM This provides two types of protec- tion: Ð
exterior protection: it sounds if a
door, the boot or the bonnet is opened.
Ð interior protection: it sounds if
the volume inside the passengercompartment changes (breaking ofa window or a movement insidethe vehicle).
Note: the interior protection alarm
does not function if the vehicle's roofis open (cabriolet position). Setting the alarm  Switch off the ignition and get out of the vehicle.
 Set the alarm by locking or dead-locking using the remote control(button Aindicator light flashes
once per second).
Note: if you wish to lock your vehicle
without setting the alarm, use thedoor lock. When the alarm is triggered, thesiren sounds and the direction indi-cator lights flash for thirty seconds. After triggering, the alarm remains set.
Warning:
if the alarm has been trig-
gered ten times in succession, on the eleventh time it becomes inac-tive. Note: if button Aindicator light flash-
es rapidly, the alarm has been trig- gered while you were away fromyour vehicle. Disarming Unlock the vehicle with the remote control key (button Aindicator light
goes out). Note: if the alarm has been triggered
while you were away from your vehi- cle, the rapid flashing of the indicatorlight will stop when you switch on theignition.
To set the alarm with exterior protection only If, while you are away from the vehi- cle, you wish to leave a window par-tially open or a pet inside the vehicle,you should choose exterior protec-
tion only.  Switch off the ignition,
 In the next ten seconds, press button Auntil the indicator light is
on continuously,
 Get out of the vehicle, 
Set the alarm by locking or dead-locking using the remote control(button Aindicator light flashes
once a second).
Note: when the alarm is set but the
remote control does not operate:  Unlock the door with the key and
open it. The alarm is triggered.
 Switch on the ignition. The alarmis disarmed.
Incorrect operation When the ignition is switched on, if button Alights for ten seconds, there
is a fault in the siren connection.
Contact a PEUGEOT dealer to have the system checked. Automatic activation* The alarm is activated automatically two minutes after the last closure ofa door or the boot. In order to avoid accidental triggering of the alarm when a door or the bootis opened, it is essential to first pressthe unlocking button on the remotecontrol.
* According to destination.

22-09-2003
YOUR 307 CC IN DETAIL97
BOOT Opening the boot 
Press and hold button Bon the
remote control to partially open the boot, or press button Con the
boot.Locking/Unlocking from the inside Pressing button Apermits:
Ð locking of the vehicle,
Ð unlocking of the vehicle (and in particular the boot) if you place the key in the switch.
"Door open" or "boot open" warnings When the engine is running, if a door
or the boot is not closed correctly,you are warned by an audible signaland a diagram on the multifunctiondisplay for a few seconds. In addition, when the vehicle is mov- ing, the courtesy lights flash.To protect the boot against theft, but- ton Ccan be disarmed. Turn the lock
D a quarter of a turn to the right using
the key. The boot can only be opened using the remote control. The boot locks automatically when the vehicle is being driven at 6 mph(10 km/h). It unlocks when one of thedoors is opened, if the speed is
below 6 mph (10 km/h) and the keyis in the ignition. Closing the boot  Use the interior grab handles to close the boot.
 Press the centre of the boot withboth hands until it locks.

22-09-2003
YOUR 307 CC IN DETAIL97
BOOT Opening the boot 
Press and hold button Bon the
remote control to partially open the boot, or press button Con the
boot.Locking/Unlocking from the inside Pressing button Apermits:
Ð locking of the vehicle,
Ð unlocking of the vehicle (and in particular the boot) if you place the key in the switch.
"Door open" or "boot open" warnings When the engine is running, if a door
or the boot is not closed correctly,you are warned by an audible signaland a diagram on the multifunctiondisplay for a few seconds. In addition, when the vehicle is mov- ing, the courtesy lights flash.To protect the boot against theft, but- ton Ccan be disarmed. Turn the lock
D a quarter of a turn to the right using
the key. The boot can only be opened using the remote control. The boot locks automatically when the vehicle is being driven at 6 mph(10 km/h). It unlocks when one of thedoors is opened, if the speed is
below 6 mph (10 km/h) and the keyis in the ignition. Closing the boot  Use the interior grab handles to close the boot.
 Press the centre of the boot withboth hands until it locks.

22-09-2003
YOUR 307 CC IN DETAIL
100
THE RETRACTABLE ROOF Before operating the roof: 
It is advisable to park the vehicle on horizontal ground, it is possible to carry out the operation at a speed below
6 mph (10 km/h).
 Ensure that the screen 1is hooked on (no object must
be placed on the screen or on the hinged covers 2; if
there is luggage in the boot, this must not push thescreen upwards).
 Check that no object has been placed on the rear par-cel shelf.
 Close the boot correctly.
 Turn the ignition switch to the accessories or runningposition (1st or 2nd notch). It is advisable to carry outthe operation with the engine running. Opening the roof: 
Carry out the preparatory operations, indicated opposite.
 Then, pull switch 3until the roof opening operation is
complete, confirmed by an audible signal.
When carrying out this manoeuvre, the four windows
lower, the boot opens, the hinged covers unfold, the rooffolds up and stores itself in the boot, the moving shelf posi-tions itself, then the boot closes. Notes: if you continue to pull button 3once the cycle is
complete, the four windows rise again. The control buttons for the windows become operational again at the end of the roof operation.

22-09-2003
YOUR 307 CC IN DETAIL
102
THE LIGHTS STALK Front and rear lights Selection is by turning ring
A.
Lights off Side lights Dipped/main beam headlamps Automatic switching on of lights Dipped/Main beam change Pull the stalk towards you. Note:
with the ignition off, if the
driver's door is open, a buzzer sounds if you have left your lights on. Front fog lamps and rear fog lamp Rotate the ring Bforwards
to switch on and backwards to
switch off. The status is confirmedby the light on the instrumentpanel.
Front fog lamps (1st for-wards turn of the ring)
The front fog lamps operate with theside lights and dipped headlamps. When the main beam headlamps are switched on, the front fog lamps are
switched off. They are switched onagain when the main beam head-
lamps are switched off. Front fog lamps andrear fog lamp (2nd for-wards turn of the ring)
Note: to switch off the rear fog lamp
and the front fog lamps, turn the ringtwice backwards.
Note: when the lights are switched
off automatically or when the dipped
headlamps are switched off manual-
ly, the front fog lamps, the rear foglamp and the side lights will remainon (turn the ring backwards to switch
off the front fog lamps. The side
lights will then be switched off). "Follow me home" lighting In poor light or at night, if you leave your vehicle, the side lights anddipped headlamps can be left on forapproximately one minute.
To do this:
Ð place the key in the STOPposi-
tion,
Ð place the lights stalk in the 0posi-
tion,
Ð flash the headlamps,Ð get out of the vehicle and lock it.
In good or rainy weather, both day and night, thefront fog lamps and therear fog lamp are daz-
zling and are prohibited. Do not forget to switch them off when they are no longer needed.

22-09-2003
YOUR 307 CC IN DETAIL
104
After the ignition has been switched off, if the stalk was in awipe position, you must reactivatethis function:
Ð move the stalk to any position,
Ð then move it back to the required
position.
Special position of the front windscreen wiper
In the minute following switching off of the ignition, any action on the stalkpositions the wipers in the centre ofthe windscreen. This action enables you to position the wiper blades for winter parking,cleaning or replacement (See sec-tion "Practical information -Changing a wiper blade").
To park the wipers after this has been done, switch on the ignitionand operate the stalk.
Windscreen wash Pull the wipers stalk towards you. The windscreen wash, then the windscreen wipers, operate for afixed period.
WINDSCREEN WIPER STALK
Front windscreen wiper with intermittent wipe 2 Fast wipe (heavy rain).
1 Normal wipe (moderate rain).
I Intermittent wipe.
0 Off.
Single wipe (press downwards).
In the Intermittent position, the wip-
ing speed is in proportion to the vehi-cle speed. Front windscreen wiper with automatic wipe
2 Fast wipe (heavy rain).
1 Normal wipe (moderate rain).
AUTO Automatic wipe.
0 Off.
Single wipe (press downwards).
In the AUTOposition, the wiping
speed is in proportion to the intensityof the rainfall.

22-09-2003
YOUR 307 CC IN DETAIL105
Automatic windscreen wipers In the
AUTOposition, the wind-
screen wipers operate automatically and adapt their speed to the inten-
sity of the rainfall.
Operating check ActivationWhen the function is activated, the message "Automatic wiping
active" appears on the multi-func-
tion display. Disarming In the event of malfunction , the dri-
ver is informed by an audible signal and the message "Auto wiper fault"
on the multi-function display. In the AUTOposition, the wind-
screen wiper will operate in intermit- tent mode.
Contact a PEUGEOT dealer to have the system checked. Do not cover the rain sen-sor located on the wind-screen behind the interior
mirror.
When using an automatic carwash, switch off the ignition orcheck that the wiper stalk is not inthe automatic position.
In winter, it is advisable to wait for the windscreen to completelyclear of ice before operating theautomatic wipe.