Peugeot 307 SW 2007.5 Owner's Manual

Page 121 of 199

DRIVING
Reactivating the cruise control
After cancellation of the cruise con-
trol, press button 4 . Your vehicle will
return to the last memorised speed.
The display indicates (e.g. at 70 mph
(110 km/h)):
Cancelling the memorised
reference speed

 When the vehicle is stationary,
after the ignition has been
switched off, the system no longer
stores any speed.
Changing the memorised
reference speed
To memorise a speed higher than the
previous one, there are two options:
Without using the accelerator:

 press button 3 ;
A brief press increases by 1 mph
(1 km/h).
An extended press increases by
5 mph (5 km/h).
A maintained press increases in
steps of 5 mph (5 km/h).
Using the accelerator:

 exceed the memorised speed until
the required speed is reached,

 press button 2 or 3 . Switching the function off

 Place dial 1 in the OFF position to
switch the system off.
Operating fault
In the event of a cruise control mal-
function, the memorised speed is
erased, the dashes l ash for a few
seconds: When changing the memo-
rised reference speed by
means of a maintained press,
pay attention as the speed
can increase or decrease rapidly.
Do not use the cruise control on slip-
pery roads or in heavy trafi c.
In the event of a steep slope, the
cruise control cannot prevent the
vehicle from exceeding the pro-
grammed speed.
In any event, the cruise control can-
not replace the need to observe the
speed limits, nor can it replace the
need for vigilance and responsibility
on the part of the driver.
To avoid any risk of jamming of the
pedals:
- ensure that the mat is positioned correctly.
- never i t one mat on top of another.
To memorise a speed lower than the
previous one:

 press button 2 ;
A brief press decreases by 1 mph
(1 km/h).
An extended press decreases by
5 mph(5 km/h).
A maintained press decreases in
steps of 5 mph (5 km/h).
Contact a PEUGEOT dealer to have
the system checked.

Page 122 of 199

106
DRIVING
VISUAL AND AUDIBLE REAR
PARKING ASSISTANCE
This system consists of four proxim-
ity sensors, located in the rear bum-
per.
This detects any obstacle (person,
vehicle, tree, gate, etc.) behind the
vehicle. Nevertheless, it cannot de-
tect obstacles located just below the
bumper.
An object, such as a stake, a road-
works cone or any other similar ob-
ject may be detected at the begin-
ning of the manoeuvre, but may no
longer be detected when the vehicle
comes close to it.

Note: this function will be disarmed
automatically when the vehicle is
towing a trailer or when a bicycle car-
rier is i tted (vehicle i tted with towing
attachment or bicycle carrier recom-
mended by PEUGEOT).
In bad or wintry weather, ensure that
the sensors are not covered with
mud, frost or snow. When reverse
gear is engaged, an audible signal
(long bleep) indicates that the sen-
sors may be dirty. The proximity information is given
by:
- an audible signal, which becomes
more rapid as the vehicle
approaches the obstacle,
- a graphic on the multifunction display, with blocks which become
progressively closer to the vehicle.
Depending on the multifunction dis-
play, the audible signal is transmitted
by a buzzer or by the rear speakers
which transmit:
- on the right if an obstacle is detected on the right,
- on the left if an obstacle is detected on the left,
- on the right and on the left if an obstacle is detected in the centre.
When the distance between the rear
of the vehicle and the obstacle is
less than approximately thirty centi-
metres, the audible signal becomes
continuous and the "Danger" symbol
appears depending on the multifunc-
tion display.
 Change to neutral, the system is
again inactive.
If there is an operating fault,
when reverse gear is en-
gaged, the service warning
light comes on, accompanied
by an audible signal (short bleep)
and a message on the multifunction
display.
Contact a PEUGEOT dealer.
Activation/Deactivation
Activation
The system is activated as soon as
reverse gear is engaged.
This is accompanied by an audible sig-
nal and displaying of the vehicle, de-
pending on the multifunction display. The system can be activated
or deactivated from the multi-
function display coni guration
menu.
The activation and deacti-
vation of the system are memorised
when the engine is switched off.
Switching the system off

Page 123 of 199

108
CHECKS
Tilt the handle on the left-hand side
under the fascia to the right.
Lift the catch and raise the bonnet.
Bonnet strut
RUNNING OUT OF FUEL
(DIESEL)
If you should run out of fuel, it is nec-
essary to re-prime the circuit.
The repriming pump, the degas
screw and the transparent pipe are
located under the bonnet (see corre-
sponding drawing):
1.6 litre HDI 16V engine
- i ll the fuel tank with at least i ve litres of diesel,
- unclip the style cover to access the repriming pump,
- squeeze and release the manual repriming pump until fuel appears
in the transparent pipe with the
green connector,
- operate the starter until the engine starts.
2 litre HDI 16V engine
- i ll the fuel tank with at least i ve litres of diesel,
- unclip the style cover to access the repriming pump,
- unscrew the degas screw,
- squeeze and release the manual repriming pump until diesel is
seen escaping via the degas
screw,
- retighten the degas screw,
- operate the starter until the engine starts.
OPENING THE BONNET
From outside Secure the strut
to hold the bonnet
open.
Before closing the
bonnet, replace
the strut in its
housing.
To close
Lower the bonnet and release it at
the end of its travel.
Check that the bonnet is properly
locked.
From inside

Page 124 of 199

109
CHECKS

1. Power steering reservoir.

2. Windscreen/headlamp wash
reservoir.

3. Coolant reservoir.
4. Brake l uid reservoir.

5. Battery.

6. Fuse box.
7. Air i lter.

8. Dipstick.

9. Engine oil reservoir.
1.6 LITRE 16V PETROL AND 1.6 LITRE 16V BIOFLEX ENGINE

Page 125 of 199

110
CHECKS

1. Power steering reservoir.

2. Windscreen/headlamp wash
reservoir.

3. Coolant reservoir.
4. Brake l uid reservoir.

5. Brake l uid reservoir.

6. Fuse box.
7. Air i lter.

8. Dipstick.

9. Engine oil reservoir.
2 LITRE 16V PETROL ENGINE

Page 126 of 199

111
CHECKS

1. Power steering reservoir.

2. Windscreen /headlamp wash
reservoir.

3. Coolant reservoir.
4. Brake l uid reservoir.

5. Battery.

6. Fuse box.
7. Dipstick.

8. Engine oil reservoir.

9. Priming pump.
1.6 LITRE 16V TURBO DIESEL HDI ENGINE (90 BHP/110 BHP)

Page 127 of 199

112
CHECKS

1. Power steering reservoir.

2. Windscreen/headlamp wash
reservoir.

3. Coolant reservoir.
4. Brake l uid reservoir.

5. Battery.

6. Fuse box.

7. Air i lter.
8. Engine oil reservoir.

9. Dipstick.

10. Priming pump.

11. Degas screw.
2 LITRE 16V TURBO DIESEL HDI ENGINE (136 BHP)

Page 128 of 199

113
CHECKS
CHECKING THE LEVELS
There are two marks on
the dipstick:

A = maximum
Never i ll past this mark.

B = minimum
To maintain the reliability of
engines and emission control
systems, the use of additives
in engine oil is prohibited.
Viscosity selection
In all cases, the oil selected must
meet the manufacturer’s require-
ments.
Note: the coolant does not need to
be changed.
Dipstick
Cooling system
Use the l uid recommended by the
manufacturer.
When the engine is warm, the tem-
perature of the coolant is controlled
by the engine fan. This fan can oper-
ate with the ignition off.

In the case of vehicles i tted with
a particle emission i lter, the fan
can operate after the vehicle has
stopped, even when the engine is
cold.
In addition, as the cooling system is
pressurised, wait for at least one hour
after the engine has stopped before
carrying out any work.
Slacken the cap by two turns to re-
lease the pressure to prevent any
risk of scalding. When the pressure
has dropped, remove the cap and
top up the level.
Windscreen and headlamp
wash level
Diesel additive level (Diesel
with particle emission filter)
If the service warning light comes on,
accompanied by a message and an
audible signal, this indicates a low
diesel additive level.
This additive must be topped up.
Contact a PEUGEOT dealer as soon
as possible.
Brake fluid level
Oil level
Oil change
According to the information given in
the servicing booklet. The level should always be
above the MIN mark and
close to the MAX mark.
Power steering reservoir
Remove the style trim * (see §
"Changing a bulb - Front lights").
Open the reservoir, with the engine
at ambient temperature. The level
should always be above the MIN.
mark and close to the MAX. mark.
For best quality cleaning and
for your safety, we would
advise that you use products
recommended by PEUGEOT.
Replacement must be car-
ried out according to the
manufacturer’s servicing
schedule.
Use l uids recommended by
the manufacturer, which fuli l DOT4
standards.
Check the level regularly
and top up between chang-
es. The maximum consump-
tion is 0.5 l per 600 miles
(1 000 km).
Check the level with the vehicle level,
engine cold, using the oil level gauge
on the instrument panel or the dip-
stick.
* According to engine.

Page 129 of 199

114
CHECKS
CHECKS
Where the handbrake travel
is too great or there is a re-
duction in the performance
of the system, the hand-
brake should be adjusted,
even between services.

Have the system checked by a PEUGEOT
dealer.
Air filter and passenger
compartment filter
Particle emission filter (Diesel)
It is imperative that the particle emis-
sion i lter is maintained in accordance
with the manufacturer’s servicing
schedule, by a PEUGEOT dealer. Brake pad wear depends
on the style of driving, in
particular for vehicles which
are used in town, over short
distances.
Disc and drum wear status
For any information relating to the wear
status of the surfaces of the discs and
drums, contact a PEUGEOT dealer.
Only use products recom-
mended by PEUGEOT or
products of equivalent qual-
ity and characteristics.
To ensure best performance from
components as important as the
power steering and the braking sys-
tem, PEUGEOT selects and offers
quite specii c products.
To prevent damage to the electrical
units, high pressure washing to clean
the engine compartment is strictly

prohibited .
Oil filter
Used products
Avoid all prolonged contact of the
used oil with the skin.
Brake l uid is harmful to health and
very corrosive.
Note: following prolonged operation
of the vehicle at very low speed or at
idle, you may, in exceptional cases,
notice discharges of water vapour
at the exhaust on acceleration. This
has no effect on the behaviour of the
vehicle or on the environment.
Do not dispose of used oil,
brake l uid or coolant into
drains or onto the ground.
Empty the used oil into the
containers provided for this purpose
in the PEUGEOT network.
Battery
At the start of winter, have
your battery checked by a
PEUGEOT dealer.
Have the i lter elements
replaced regularly. If you
drive in dusty conditions,
change them twice as of-
ten.
Brake pads
It may be necessary to
check the thickness of the
pads, even between ser-
vices.
Handbrake
Change the i lter regularly,
in accordance with the ser-
vicing schedule.
Manual gearbox

To check the main levels
and certain components,
in accordance with the
manufacturer’s servic-
ing schedule, refer to the
pages of the servicing booklet
which correspond to your vehi-
cle’s engine.
This does not require an oil
change. Have the level checked
in accordance with the manu-
facturer’s servicing schedule.

Page 130 of 199

114
CHECKS
CHECKS
Where the handbrake travel
is too great or there is a re-
duction in the performance
of the system, the hand-
brake should be adjusted,
even between services.

Have the system checked by a PEUGEOT
dealer.
Air filter and passenger
compartment filter
Particle emission filter (Diesel)
It is imperative that the particle emis-
sion i lter is maintained in accordance
with the manufacturer’s servicing
schedule, by a PEUGEOT dealer. Brake pad wear depends
on the style of driving, in
particular for vehicles which
are used in town, over short
distances.
Disc and drum wear status
For any information relating to the wear
status of the surfaces of the discs and
drums, contact a PEUGEOT dealer.
Only use products recom-
mended by PEUGEOT or
products of equivalent qual-
ity and characteristics.
To ensure best performance from
components as important as the
power steering and the braking sys-
tem, PEUGEOT selects and offers
quite specii c products.
To prevent damage to the electrical
units, high pressure washing to clean
the engine compartment is strictly

prohibited .
Oil filter
Used products
Avoid all prolonged contact of the
used oil with the skin.
Brake l uid is harmful to health and
very corrosive.
Note: following prolonged operation
of the vehicle at very low speed or at
idle, you may, in exceptional cases,
notice discharges of water vapour
at the exhaust on acceleration. This
has no effect on the behaviour of the
vehicle or on the environment.
Do not dispose of used oil,
brake l uid or coolant into
drains or onto the ground.
Empty the used oil into the
containers provided for this purpose
in the PEUGEOT network.
Battery
At the start of winter, have
your battery checked by a
PEUGEOT dealer.
Have the i lter elements
replaced regularly. If you
drive in dusty conditions,
change them twice as of-
ten.
Brake pads
It may be necessary to
check the thickness of the
pads, even between ser-
vices.
Handbrake
Change the i lter regularly,
in accordance with the ser-
vicing schedule.
Manual gearbox

To check the main levels
and certain components,
in accordance with the
manufacturer’s servic-
ing schedule, refer to the
pages of the servicing booklet
which correspond to your vehi-
cle’s engine.
This does not require an oil
change. Have the level checked
in accordance with the manu-
facturer’s servicing schedule.

Page:   < prev 1-10 ... 81-90 91-100 101-110 111-120 121-130 131-140 141-150 151-160 161-170 ... 200 next >