Peugeot 407 Dag 2010 Workshop Manual

Page 51 of 249

3COMFORT
49
Special feature
To ensure maximum visibility
during manoeuvres, the mirror
lightens automatically when reverse
gear is engaged.
Manual interior mirror
The interior mirror has two positions:
- day (normal),
- night (anti-dazzle).
To change from one to the other, push
or pull the lever on the lower edge of
the mirror. MANUAL ADJUSTMENT OF STEERING WHEEL HEIGHT AND REACH
When the vehicle is stationary, unlock
the steering wheel adjustmment by
pushing the lever forwards.
Adjust the height and reach of the
steering wheel then lock the adjust-
ment by pulling the lever fully back.

Page 52 of 249

3COMFORT
50
FRONT SEATS
Manual mode
Longitudinal adjustment
Lift the control bar and slide the seat
forwards or backwards. Driver's seat cushion height and
angle adjustment
Pump up or down to the required
position. Seat back angle adjustment
Operate the lever for your comfort.

Page 53 of 249

3COMFORT
51
Electric mode
Longitudinal adjustment
Push the control forwards or back-
wards to slide the seat. Driver's seat cushion height and
angle adjustment

Height: tilt the rear of the control up
or down.

Tilt: tilt the front of the control up or
down. Seat back angle adjustment
Tilt the control forwards or backwards
for your comfort.
The electrical functions of the driver's seat are deactivated o ne minute after the ignition is switched off.
To reactivate them, open the door or switch on the ignitio n.

Page 54 of 249

3COMFORT
52
Head restraint height and angle
adjustment Front seat active head restraint
This system prevents "whiplash".
In the event of a rear impact, the action
of the body on the seat back moves
the head restraint forwards and up-
wards preventing the head from being
thrown back.
Front armrest
Driver's seat lumbar adjustment
Heated seats adjustment

0 : Off.

1 : Low.
2 : Medium.

3 : High. The adjustment is correct when
the top of the head restraint is
aligned with the top of the head
of the occupant of the seat.
Never drive with the head re-
straints removed and stored in
the vehicle. This is dangerous
and they may be thrown in the
event of sharp braking. They must be
in place and adjusted correctly. To change the position of the armrest:

 Lift the handle 1 .
The armrest folds forwards and up-
wards.
To return to the initial position, push
the armrest backwards and press it to
engage.
Operate the lever to obtain the correct
position.
To raise or lower the head restraint,
pull it forwards then slide it.
To tilt the head restraint, tilt the lower
part forwards or backwards.
To remove the head restraint, move it
almost to the highest position, lift the
tab using a coin and pull it forwards
and upwards at the same time.
To refi t the head restraint, engage the
stalks in the holes keeping in line with
the seat back.
With the engine running, turn the dial.
The temperature of the seat is regu-
lated automatically.

Page 55 of 249

3COMFORT
53
REAR SEATS (SALOON)

Note: the seat cushion 1 can be re-
moved with care to increase the vol-
ume of the load space.
Squeeze the seat cushion fi xings to
detach them from their fastenings.
When repositioning:

 fold up the seat back 2 and lock it
(the red marker of control 3 should
no longer be visible),

 fold up the seat 1 ,

 refi t the head restraints if they were
removed. Locking/unlocking the access
to the boot via the rear seats
Your vehicle's boot can be isolated
from the passenger compartment.
The red indicator on the control
3
should no longer be visible. If it is,
push the seat fully.
Insert the ignition key in the lock 4 .
Take care not to trap the seat
belt and to position the tongue
of each strap correctly in its
respective clasp before folding
down the seat back. This will enable
you to reposition the seat backs with
their seat belts and clasps ready to ac-
commodate your rear passengers.
To fold down the rear left seat or the
rear right seat, always start with the
seat cushion, never with the seat back
(risk of damage):

 move the front seat(s) forward if
necessary,

 place the head restraints in the low
position or remove them if neces-
sary,
Check that the seat belt strap is posi-
tioned correctly at the side of the seat
back,
Ensure that the outer seat belt tongues
are engaged in their claps (the centre
seat belt must not be fastened),

 lift the front of the seat cushion 1 ,

 tilt the seat cushion 1 against the
front seat(s),

 pull control 3 forwards to unlock
the seat back 2 ,

 fold down the seat back 2 .

Page 56 of 249

3COMFORT
54
REAR SEATS (407SW)

Note: the seat cushion 1 can be re-
moved with care to increase the vol-
ume of the load space.
Squeeze the seat cushion fi xings to
detach them from their fastenings.
When repositioning:

 fold up the seat back 2 and lock it
(the red marker of control 3 should
no longer be visible),

 fold up the seat 1 ,

 refi t the head restraints if they were
removed. Take care not to trap the seat
belt and to position the tongue
of each strap correctly in its
respective clasp before folding
down the seat back. This will enable
you to reposition the seat backs with
their seat belts and clasps ready to ac-
commodate your rear passengers.
To fold down the rear left seat or the
rear right seat, always start with the
seat cushion, never with the seat back
(risk of damage):

 move the front seat(s) forward if
necessary,

 place the head restraints in the low
position or remove them if neces-
sary,
Check that the seat belt strap is posi-
tioned correctly at the side of the seat
back,
Ensure that the outer seat belt tongues
are fastened in their clasp (the centre
seat belt must not be fastened),

 lift the front of the seat cushion 1 ,

 tilt the seat cushion 1 against the
front seat(s),

 pull control 3 forwards to unlock
the seat back 2 ,

 fold down the seat back 2 .

Page 57 of 249

3COMFORT
55
CHILD SEAT IN THE FRONT GENERAL POINTS RELATING TO CHILD SEATS
* The rules for carrying children are specifi c to each country. Refer to the
current legislation in your country. When a "rearwards-facing"
child seat is installed on the

front passenger seat , it is
essential that the passenger
airbag is deactivated. Otherwise, the
child would risk being seriously in-
jured or killed if the airbag were to
infl ate .
"Rearwards-facing"
Although one of PEUGEOT's main cri-
teria when designing your vehicle, the
safety of your children also depends
on you.
For maximum safety, please
observe the following recom-
mendations:
- in accordance with European reg- ulations, all children under the
age of 12 or less than one and
a half metres tall must travel in
approved child seats suited to
their weight , on seats fi tted with a
seat belt or ISOFIX mountings * ,
- statistically, the safest seats in
your vehicle for carrying chil-
dren are the rear seats,
- a child weighing less than 9 kg
must travel in the "rearwards-
facing" position both in the front
and in the rear.

PEUGEOT recommends that chil-
dren should travel in the rear seats of
your vehicle:
- "rearwards-facing" up to the age
of 2,
- "forwards-facing" over the age
of 2.
Intermediate longitudinal position
When a "forwards-facing" child seat
is installed on the
front passenger
seat , adjust the vehicle's seat to the
intermediate longitudinal position with
the seat back upright and leave the
passenger airbag activated.
"Forwards-facing"

Page 58 of 249

3COMFORT
56

Group 0: from birth to 10 kg

Group 0+: from birth to 13 kg
Groups 1, 2 and 3: from 9 to 36 kg


L1
"RÖMER Baby- Safe Plus"
Installed in the
rearwards-facing position.


L2
"KIDDY Life"
The use of the
restraining cushion is
compulsory for carrying young children
(from 9 to 18 kg).

Groups 2 and 3: from 15 to 36 kg

L3
"RECARO Start''

L4
"KLIPPAN Optima"
From the age of 6 years
(approximately 22 kg), the booster is used on its own.


L5
"RÖMER KIDFIX"
Can be fi tted to the vehicle's ISOFIX mountings.
The child is restrained by the seat belt.
CHILD SEATS RECOMMENDED BY PEUGEOT
PEUGEOT offers a complete range of recommended child seats which a re
secured using a three point seat belt :
Passenger air bag OFF

Page 59 of 249

3COMFORT
57
LOCATIONS FOR CHILD SEATS SECURED USING THE SEAT BELT
In accordance with European regulations, this table indicates the options for the installation of child seats secured using the
seat belt and universally approved (a) depending on the weig ht of the child and the seat in the vehicle:

Weight of the child/ indicative age

Seat
Below 13 kg
(groups 0 (b) and 0+)
Up to approx 1 year
9 to 18 kg
(group 1)
De 1 to 3 years approx
15 to 25 kg
(group 2)
De 3 to 6 years
22 to 36 kg
(group 3)
De 6 to 10 years approx
Front passenger
seat (c)
- fi xed
U U U U
- height adjustable U(R) U(R) U(R) U(R)
Outer rear seats U U U U
Centre rear seat X X X X

a : Universal child seat: child seat which can be installed in all vehicles using the seat belt.

b : Group 0: from birth to 10 kg.

c : Consult the current legislation in your country before insta lling your child on this seat.

U : seat suitable for the installation of a child seat secure d using the seat belt and universally approved, "rear facing" an d/or
"forwards facing".

U (R) : identical to U , but the vehicle seat must be adjusted to the highest po sition.

X : seat which is not suitable for the installation of a ch ild seat.

Page 60 of 249

3COMFORT
These are two rings located between
the seat back and the seat cushion.
"ISOFIX" MOUNTINGS
These seats are fi tted with ISOFIX
mountings. The incorrect installation of a
child seat in a vehicle compro-
mises the child's protection in
the event of a collision.
407 SALOON
407SW
This ISOFIX mounting system guaran-
tees reliable, safe and fast fi tting of the
child seat in your vehicle.
The
ISOFIX child seats are fi tted with
two locks which are secured easily on
these lower rings A .

Page:   < prev 1-10 ... 11-20 21-30 31-40 41-50 51-60 61-70 71-80 81-90 91-100 ... 250 next >