Peugeot 508 Hybrid 2016 Owner's Manual

35
7
Practical information
508HY-comp _en_Chap07_info-pratiques_ed01-2016
Car washing machine or tunnel
With the HYbrid4 system active, RE ADY lamp on, parking brake RE ADY lamp on, parking brake RE ADYreleased:  Place the gear selector in position N .  Switch off the engine (press the START/STOP button or with the vehicle's key if it does not have Keyless Entry and Starting). The parking brake is applied automatically and the RE ADY lamp goes off in the instrument panel. RE ADY lamp goes off in the instrument panel. RE ADY Switch on the ignition again (press the START/STOP button
or with the key in the intermediate position) without your foot on the brake pedal. The RE ADY lamp remains off. RE ADY lamp remains off. RE ADY Release the parking brake using the manual control on the centre console, while keeping your foot on the brake pedal.  Switch off the ignition (press the START/STOP button without your foot on the brake pedal, or using the key) after checking that the parking brake remains released.
With the HYbrid4 system active, RE ADY lamp on, parking brake RE ADY lamp on, parking brake RE ADYreleased:  Place the gear selector in position N ( AUTO m o d e).  Press the brake pedal then the ECO OFF button.
If the HDI Diesel engine was on standby, it then restarts. If the HDi Diesel engine is running, its operation is maintained without time limit.
Car washing machines or tunnels in which the HDi Diesel engine must be switched off. Car washing machines or tunnels in which the HDi Diesel engine must not be switched off.
Some car washing machines or tunnels (where the vehicle is moved for wards on a travelling track) require that the parking brake be "released" during the wash. If possible on your vehicle, deactivate the automatic operation of the electric parking brake via the vehicle equipment configuration menu.

36
Practical information
508HY-comp _en_Chap07_info-pratiques_ed01-2016
Snow chains
Recommendations
The use of snow chains is only authorised on the front wheels. The mode selector must be in the 4WD position.
For information on the sizes compatible with the tyres on your vehicle and advice on use, refer to the corresponding section in the handbook for the vehicle.

37
8
In the event of a breakdown
508HY-comp _en_Chap08_en-cas-de-pannes_ed01-2016
Temporary puncture repair kit
This kit comprises a compressor and a sealant cartridge. It allows you to carry out a temporary repair to a tyre. temporary repair to a tyre. temporary repair This makes it possible to continue to the nearest garage.
This kit is stowed in the storage well behind the rear seats.  Fold the 2/3 part of the rear seat for access to it.  Raise the cover of the storage well.
It can be used for repairing most punctures on the tread or shoulder of the tyre. The compressor can be used to check and adjust a tyre pressure.
For more information on the use of this temporary puncture repair kit, refer to the corresponding section in the handbook for the vehicle.
Access to the kit

38
In the event of a breakdown
508HY-comp _en_Chap08_en-cas-de-pannes_ed01-2016
Recovery of the vehicle on a fl at-bed
Never recover the vehicle by towing it with two or four wheels on the ground, as there is a risk of damage to the transmission. However, if necessary because access to the vehicle is difficult, the vehicle can be moved a few dozen metres, at a speed of less than 6 mph (10 km/h). Before doing any work, with the ignition on, press the brake pedal and place the gear selector at position N , then switch off the HYbrid4 system ( RE ADY lamp off). RE ADY lamp off). RE ADY Always call on professionals for recovery of the vehicle on a flat-bed lorry or trailer.
Use the towing eye only to pull the vehicle out or to lash it for recovery on a flat-bed lorry or t r a i l e r.
The towing eye is stowed in the storage well behind the rear seats.  Fold the 2/3 part of the rear seat for access to it.  Raise the cover of the storage well.
Access to the tools

39
8
In the event of a breakdown
508HY-comp _en_Chap08_en-cas-de-pannes_ed01-2016
Removing / Refi tting the 12 V battery
This procedure allows you to safely remove the 12 V battery, when needed to change a left hand headlamp bulb.
You can contact a PEUGEOT dealer or a qualified workshop to have this done.
Before removing
 Place the vehicle in a ventilated area, with free access and preferably on level ground.  Apply the parking brake.  Place the gear selector in position N .  If the vehicle has an alarm, leave the bonnet open to avoid triggering the alarm.  Leave at least one window open if parking in a secure area, other wise lock all doors and the boot.  If your vehicle has a motorised tailgate, it will not be possible to open it after disconnecting the battery.  Switch of the ignition and remove the key.  If your vehicle has Keyless Entry and Starting, place the remote control at least 3 metres away.  Wait around 6 minutes before disconnecting the battery.
R e m o v i n g
 Disconnect the positive ( + ) terminal of the + ) terminal of the +battery.

40
In the event of a breakdown
508HY-comp _en_Chap08_en-cas-de-pannes_ed01-2016
 Remove the deflector 1 .  Uncouple the hose 2 .  Remove the assembly of air flow meter and air filter 3 .  If present, move aside the coolant hose 4 .  Remove the battery cover 5 .
 Slacken 6 then disconnect the negative ( - ) - ) -terminal of the battery.  Unclip the wiring harnesses 7 . 7 . 7 Unclip and move aside the wiring harness 8 .  Remove the bolt from the maxi-fuse box 9 .  Remove the nut 10 from the positive ( + ) + ) +cable.  Move aside the wiring harness 11 .

41
8
In the event of a breakdown
508HY-comp _en_Chap08_en-cas-de-pannes_ed01-2016
 Using a screwdriver, unclip the clips 12and 13 .  Turn the power shut-off unit 14 upwards.  Move the unit for wards.
 Unclip the clips.  Remove the battery cover 15 . Using a screwdriver, lever the fixing 16aside and remove the battery.

42
In the event of a breakdown
508HY-comp _en_Chap08_en-cas-de-pannes_ed01-2016
R e f i t t i n g
To refit the battery, carry out the removal operations in reverse order and connect the positive (+) terminal last.
After refitting
 Check that the battery terminals are secure.  Switch on the ignition, without starting the engine.  Check that there are no error messages or warning lamps on. If there is any problem, contact a PEUGEOT dealer or a qualified
workshop to have the system reset.  Check the correct operation of all openings: doors, boot and windows.  After refitting, wait for about 2 minutes.  Start the engine.
 Check the correct operation of the anti-pinch systems: electric windows and panoramic sunroof.  Check the correct operation of the electric parking brake by releasing and applying it again.  Switch off the ignition.  Get out of the vehicle and check the operation of the remote control.  Set: the time, the radio preset stations and the audio settings.
After reconnecting the battery, certain functions may be temporarily
unavailable: air conditioning, navigation.
In all cases, if there is a problem, contact a PEUGEOT dealer or a
qualified workshop.

43
9
Technical data
508HY-comp _en_Chap09_caracteristiques-techniques_ed01-2016
Electric motor-
Technology Synchronous with permanent magnets
Max. power: EU standard (kW) * 27
Max. power speed (rpm) 2 000 to 7 500
Max. torque: EU standard (Nm) 200
Max. torque speed (rpm) 800 to 1 290
Efficiency (%) 80 to 90
High voltage batter yNi-MH (Nickel Metal Hydride)
Voltage (V~) 200
Energy capacity (kWh / Ah) 1.1 / 5.5
Range (miles (km)) 1.2 (2) (approximately)
Electric motor and battery
* The maximum power corresponds to the value type approved on a test bed, under conditions defined by European legislation (directive 1999/99/EC).
Range varies according to the ambient climatic conditions, the driving style and conditions, the use of vehicle systems and ageing of the battery.

44
Technical data
508HY-comp _en_Chap09_caracteristiques-techniques_ed01-2016
* The maximum power corresponds to the value type approved on an engine test bed, under conditions defined by European legislation (directive 1999/99/EC).

Diesel engine and gearbox
Diesel engine2.0 litre HDi 163 hp
Gearbox E T G 6 e l e c t r o n i c ( 6 - s p e e d )
Cubic capacity (cc) 1 9 9 7
Bore x stroke (mm) 85 x 88
Max power: EU standard (kW) * 120
Max power engine speed (rpm) 3 850
Max torque: EU standard (Nm) 300
Max torque engine speed (rpm) 1 750
Fuel Diesel
Catalytic converter Ye s
Particle filter Ye s
Engine oil capacity in litres (with filter replacement) 5.0