sensor Peugeot 607 Dag 2009 User Guide

Page 117 of 182

1010
101
Fitting a wheel
 Put the tool holder back in position.
This helps to keep the boot fl oor in its
correct position, to prevent any defor-
mation of the fl oor when loaded.

 Tighten the spare wheel securing
strap to prevent noise and for your
safety in the event of impact. After changing the wheel:
- have the tightening of the bolts and
the tyre pressure checked by a
PEUGEOT dealer as soon as pos-
sible,
- have the punctured wheel repaired and refi t it to the vehicle as soon as
possible,
- the steel spare wheel must only be used for a very short time.

 Position the wheel using the cen-
tralising tool 2 to assist you.

 Tighten the bolts by hand and re-
move the centralising tool.

 Partly tighten the bolts using the
wheelbrace 1 .

 Fold the jack 4 and remove it.

 Fully tighten the bolts using the
wheelbrace.

 Replace the wheel trim.

 For the alloy trims, position the re-
moval hole opposite the valve. Tyres fi tted with the Tyre
Under-Infl ation Detection System.
These wheels have a pressure sensor.
Have them repaired by a PEUGEOT
dealer.

Page 125 of 182

1010
107

Fuse N° Rating
Functions

F1 15 A Front wash-wipe pump and wash-wipe fl uid level sensor.

F2 30 A Locking and deadlocking earth.

F3 5 A Air bags.

F4 10 A Clutch switch, brake dual-function switch, diagnostic connector
, ESP sensor,
electrochromatic mirror.

F5 30 A Front electric windows and sunroof supply.

F6 30 A Rear electric windows supply.

F7 5 A Glove box switch, courtesy lights, map reading lights, courtesy mirrors.

F8 20 A Multifunction display supply, steering wheel control, alarm si
ren, trailer fusebox supply,
PC Com, electric mirror and front and rear electric window controls.

F9 30 A Front and rear lighters (100 W max.).

F10 15 A Additive reservoir control unit supply.

F11 15 A Automatic gearbox control unit, automatic gearbo x positions selection switch, ignition switch.

F12 15 A Trailer fusebox supply, hands-free kit, seats relay, seat memory un
it, rain and brightness
sensor.

F13 5 A Engine fusebox supply.

F14 15 A Parking assistance control unit supply, instrument panel, air co
nditioning, air bags and
pre-tensioners unit.

F15 30 A Locking and deadlocking supply.

F17 40 A Hi-Fi amplifi er, heated mirrors.

Page 126 of 182

1010
108
Engine compartment fuses

Fuse N° Rating
Functions

F1 20 A Engine management control unit.

F2 15 A Horn.

F3 10 A Rear electric blind.

F4 20 A Headlamp wash.

F5 15 A Fuel pump (except 2 litre HDI 16V), diesel heater (2 litre HD
I 16V), turbocharger and diesel
pre-heat unit (2.7 litre HDI 24V).

F6 10 A Power steering, suspension control unit, automatic gearbox, aut
omatic headlamp
adjustment unit.

F7 10 A ESP control unit.

F8 25 A Starter coil.

F9 10 A Coolant level sensor, passenger compartment heating (HDI), S TOP switch.

F10 30 A Engine management actuators (injectors, ignition coil, solen oid valves, oxygen sensors).
To access the fuses located in the en-
gine compartment, remove the cover
and unclip the fuse box lid.
When you have fi nished, close the lid
carefully to guarantee the sealing of
the fuse box and refi t the cover.

Page 127 of 182

1010
109
The electrical system of your vehicle is designed to operate with standard or optional equipment.
Before installing other electrical equipment or accessories on yo ur vehicle, contact a PEUGEOT dealer.

Fuse N° Rating
Functions

F11 40 A Air conditioning blower relay.

F12 30 A Wipers relay.

F13 40 A Built-in systems interface supply (ignition positive).

F14 30 A Air pump.

F15 10 A Right-hand main beam headlamp.

F16 10 A Left-hand main beam headlamp.

F17 15 A Left-hand dipped headlamp.

F18 15 A Right-hand dipped headlamp.

F19 15 A Oil vapour heater (2 litre HDI 16V), inlet air heating sole
noid valve (2 litre HDI 16V), air fl ow
sensor (2 litre HDI 16V and 2.7 litre V6 HDI 24V), oxygen sensor .

F20 10 A Water in diesel sensor (2 litre HDI 16V) injection pump (2.7 l
itre V6 HDI 24V), turbo
regulation solenoid valve (2 litre HDI 16V).

F21 10 A Fan assembly relay control, additional fan assembly (2.7 litre V6 HDI 24V).
PEUGEOT will not accept responsibility for the cost incurred in re pairing your vehicle or for rectifying the malfunctions resulting
from the installation of accessories not supplied a nd not recommended by PEUGEOT and not installed in accordance with its
instructions, in particular when the combined consu mption of all of the additional equipment connected exceeds 10 milliamperes.

Page:   < prev 1-10 11-20