radiator RENAULT KANGOO 1997 KC / 1.G Sheet Metal Work Workshop Manual

GENERAL
Repair Bench
40
12668R1
The bracket helps with the fitting of the cross
member and rests vertically against the front end
cross member, then it is centred by a centring bolt
at (K).
1 - Front mechanical units removed
It is used for replacing the front end cross mem-
ber, with or without mechanical units.
NOTE : The operation for replacing the front end
cross member can be carried out without the re-
moval of the engine and transmission assembly,
but requires the removal of the radiator.
2 - Front mechanical units in place
The bracket helps with fault finding on the front
cross member.
III - REFERENCE POINTS FOR POSITIONING REPLACED PARTS (cont)
L - REAR END CROSS MEMBER (REAR END)
12667R1
The bracket helps with the fitting of the cross
member and rests vertically against the rear end
cross member, then centres itself in the mounting
hole of the absorber mounting.
It is used for replacing the whole rear end, with or
without mechanical units.
K - FRONT END CROSS MEMBER
40-34