belt RENAULT KANGOO 1997 KC / 1.G Sheet Metal Work Workshop Manual
[x] Cancel search | Manufacturer: RENAULT, Model Year: 1997, Model line: KANGOO, Model: RENAULT KANGOO 1997 KC / 1.GPages: 255
Page 7 of 255
GENERAL
Engine and equipment
40
SPECIFIC BODYWORK FEATURES
Driver’s airbag
Passenger’s and driver’s airbag
Height adjustable front head restraint
Height adjustable and tiltable front head restraint
Rear parcel shelf
Luggage compartment net
Electric one touch windows
Heated electric rear view mirrors
Heated screen + timed windscreen wiper
Heated front seats
Front seat driver emergency exit
Rear bench seat 1/1
Rear bench seat 1/3 - 2/3
Cabin rack without stop
Headlining
Boot carpet
Parcel shelf luggage cover
Two front fog lights in bumper
(excluding F8 AC PAS)Pay load 600 kg
Pay load 625 to 710 kg depending on
engine/equipment
Pay load 800 kg
Glazed, sliding side door and rear opening doors
or glazed tailgate
Sliding side door (reflective glass)
Sliding side door (panel)
Rear door, panel
Rear door, glazed
Opening doors, panels
Opening doors, glazed
Tailgate
Opaque roof flap (excluding tailgate)
Glazed roof flap (excluding tailgate)
Fixed side window (meaning glazed side door)
Sliding side window
Fixed rear quarter panel (meaning the glazed
sliding side door )
Heat insulating windscreen (with air conditioning)
2 point rear centre seat belt
3 point rear centre seat belt
40-3
Page 173 of 255
UPPER SIDE STRUCTURE
Centre pillar lower reinforcement / door pillar
43E
PRB4315
INTRODUCTION
The replacement of this part is a complementary
operation to the replacement of the centre pillar
for a front side impact.
In the operation described below there are only
descriptions of the joints specific to the part
concerned.
Information concerning other parts will be dealt
with in the respective section.
On the part supplied by the Parts Department,
the pillar upper reinforcement will need to be un-
picked.
COMPOSITION OF THE PART FROM THE PARTS
DEPARTMENT
Part assembled with seat belt mounting nut.
CAA11538-1R4
A
12
CAB11539R6
B
12
43-19
Page 182 of 255
UPPER REAR STRUCTURE
Rear wing panel
44A
PRB4413
INTRODUCTION
The replacement of this part is a basic operation
for a rear side impact.
In the operation described below there are only
descriptions of the joints specific to the part
concerned.
Information concerning the other parts will be
dealt with in the respective section.
For the panel version, this part may be replaced in
two ways (see cuts marked on the diagram be-
low) :
1 - complete replacement with cut A.A
2 - partial replacement with cut B.B
At the end of the section there are special details
for the glazed version and for the version with
roof flap.
COMPOSITION OF THE PART FROM THE PARTS
DEPARTMENT
Part assembled with sliding door rail units and
striker plate mounting.
JOINTS WITH :
Lights mounting side panel rain channel
Body side lining
Centre pillar reinforcement
PARTS CONCERNED (thickness in mm):
1Rear wing panel (right hand side) 0.8
2Rear wing panel lining
(right hand side) 0.7
3Lights mounting side panel rain
channel 1.2
4Rear wing panel extension 1
5Side panel rain channel
upper reinforcement 1.2
6Centre rail mounting 1
7Stretcher lining 0.7
8Roof 0.7
9Centre pillar upper reinforcement 1.2
10Centre pillar reinforcement 1.2
11Sill panel rear closure panel 1.5
12Seat belt mounting reinforcement 1.2
13Roof flap rain channel 0.7
44-1