charging RENAULT SCENIC 2008 J84 / 2.G Parking Distance Control Workshop Manual

PARKING DISTANCE CONTROL
Fault finding - Conformity check
87F
87F - 28V4 MR-372-J84-87F000$528_eng.mif
Vdiag No: 04-08PARKING DISTANCE CONTROL
Fault finding - Conformity check
NOTESOnly perform this conformity check after a thorough check with the diagnostic tool.
Conditions for applying the fault finding procedure: ignition on.
Order FunctionParameter or Status
checked or ActionDisplay and Notes Fault finding
1Parking
distance control
system statusET003:Parking
distance
control
functionREADY (system
operating and ready to
detect)
For further information or,
if there is a fault, consult
the interpretation of status
ET003. DETECTING (if the
system is detecting)
SUSPENDED (if the
system is temporarily
switched off)
OFF (if the system is
completely switched off)
2Parking
distance control
deactivation
switch.ET004:Parking
distance
control switchPRESS DETECTED
when the switch is
pressed, RELEASED
when released.In the event of a fault,
consult the interpretation
of status ET004.
3FeedsPR006:Sensor feed
voltage10.5 V < X < 14.4 VIn the event of a fault,
apply the fault finding
procedure for DF007
Sensor supply voltage.
PR020:Computer
feed voltage10.5 V < X < 14.4 VIf there is a fault with this
parameter, check the
insulation, continuity
and the absence of
interference resistance
on the computer power
feed and earth (see wiring
diagram). If the fault is still
present, carry out fault
finding on the charging
circuit.
4Reverse gear
selectionET001:Reverse gear
engagedYES or NOIf there is a fault, refer to
the interpretation of status
ET001.
AAP_V04_CCONF/AAP_V08_CCONF
MR-372-J84-87F000$528_eng.mif