service reset Seat Leon 5D 2010 MEDIA SYSTEM 2.2

Introduction11
Adjusting the base volumeChanges to the volume are indicated by a “bar” on the screen. During this
time the unit cannot be operated.
At “0” the unit is muted (display:
) and the current media source is
stopped.
It is possible to preset certain volume settings and adjustments ⇒ page 87.
WARNING
Your attention may be distracted from the traffic if you use the radio and
navigation system while driving, resulting in accident.•You should always drive with due care and attention.•Select volume settings that allow you to easily hear signals from
outside the vehicle at all times (e.g. emergency service sirens).•If the volume is too high, you could damage your hearing. Even if the
volume is too loud for a short period only.Caution
If the volume is too high or the sound is distorted, the vehicle speakers may
be damaged.
Note
If the base volume has been turned up high to play an audio source (e.g. due
to very quiet audio output from an external audio source), lower the volume
again before switching audio source.Additional information and display optionsThe text displayed on the screen may vary depending on the settings and may
not match the illustrations shown here.
All displays appear only after the radio-navigation system has completed
start-up.
Depending on the vehicle, the changes to the air conditioning settings or the
texts relating to driver assistance systems fitted at the factory are displayed.
These displays disappear automatically when they are no longer required.
Function
Action
Increase the vol-
ume.
Turn the sound control knob
D ⇒ page 8, fig. 1 to the
right, or press the button on the multifunction steer-
ing wheel ⇒Booklet “Owner's Manual”.
Lower the vol-
ume.
Turn the volume control
D anti-clockwise
or press the button on the multifunction steering
wheel.

MediaSystem2.1_EN.book Seite 11 Donnerstag, 29. April 2010 4:18 16

Audio mode
20Function button: Result
: The TP function is switched on ⇒page 21.: Define the station selection for the arrow buttons and
.: All available stations on the selected frequency band can be
browsed with the arrow buttons ⇒page 15.: Using only the arrow keys, switch between the stored sta-
tions ⇒ page 19 (display:
­
⇒ page 19, fig. 13).
: Define the setting for automatic station tracking with RDS
⇒ page 21.: The unit always switches to the radio station's frequency
that currently offers the best reception. As a result, regional pro-
grammes may be interrupted.
: For as long as possible, the unit only switches to alternative fre-
quencies for the selected radio station that broadcast the same
regional service.: in units with a DAB radio receiver, this may affect other addi-
tional settings ⇒page 24.: Delete stations stored to station buttons.
: All stored stations will be deleted.: Tu rn the setting knob ⇒page 8, fig. 1 to display, one after
the other, all the stations stored on the station buttons, and press the
same button to delete the station displayed.
To cancel, press the unit button ⇒page 8, fig. 1 .’ Traffic news (TP)b Arrow buttons
ƒ
„
StationsPresets
bRDS Regional
AutomaticFixed
DAB settingsDelete preset list
AllOne
A10

A8
MediaSystem2.1_EN.book Seite 20 Donnerstag, 29. April 2010 4:18 16