steering SSANGYONG MUSSO 1998 Workshop Manual PDF
Page 1322 of 1463
8B-18 SUPPLEMENTAL RESTRAINT SYSTEM(SRS)
MAINTENANCE AND REPAIR
ON-VEHICLE SERVICE
AIR BAG MODULE
Removal & Installation Procedure
1. Remove the steering wheel rid (LH,RH) with a screwdriver.
Installation Notice
Each position mark (LH,RH) is stamped on the inner surface
of the rids.
Tightening Torque 7 - 11 Nm
3. Disconnect the connectors and remove the air bag module.
4. Installation should follow the removal procedure in the
reverse order. 2. Unscrew the bolts from both sides.
Installation Notice
Page 1324 of 1463
8B-20 SUPPLEMENTAL RESTRAINT SYSTEM(SRS)
Removal & Installation Procedure
preceding work : removal of steering wheel
1. Turn the ignition switch to “OFF” position and disconnect
the battery negative cable. Start the procedure after waiting
over 3oseconds.
2. Unscrew 3 screws from lower cover on steering column shaft
and remove the lower cover.
3. Unscrew 4 screws from clock spring and remove the clock
spring
Installation Notice
lDon’t try to repair and modify the clock spring.
lWhen aligning the neutral position, turn to clockwise until it
stops, and turn to counter clockwise until the marks are
aligned