bulb SUZUKI NEXA 2015 1.G Owners Manual

Downloaded from www.Manualslib.com manuals search engine 0-5
WARRANTY POLICYMaruti Suzuki India Limited (hereinafter called “Maruti Suzuki”),
warrants that each new Maruti Suzuki vehicle distributed in India
by Maruti Suzuki and sold by an authorised Maruti Suzuki
N%8!dealer will be free, under normal use and service,
from anydefects in material and workmanship at the time of
manufactureSUBJECT TO THE FOLLOWING TERMS AND
CONDITIONS:
TheMarutiSuzuki vehicle must be delivered byan authorised
MarutiSuzuki N%8! dealer and serviced by DXWKRULVHG 0DUXWL
6X]XNLZRUNVKRS(2) Term:The term of the warranty shall be twenty-four (24) months or
40,000 kilometers (whichever occurs first) from the date of
delivery to the first owner.(3) Maruti Suzuki Warranty Obligation:If any defect(s) should be found in the vehicle within the term stip-
ulated above, Maruti Suzuki’s only obligation is to repair or replace
at its sole discretion any part shown to be defective, with a new
part or the equivalent at no cost to the owner for parts or labour,
when Maruti Suzuki acknowledges that such a defect is attribut-
able to faulty material or workmanship at the time of manufacture.
The owner is responsible for any repair or replacements which are
not covered by this warranty.
(4) Limitation:This warranty shall not apply to:
(a) Normal maintenance service required other than the three
free services, including without limitation, oil and fluid
changes, headlight aiming, fastener retightening, wheel bal-
ancing, wheel alignment and tyre rotation, cleaning of injec-
tors, adjustment of clutch and valve clearance.
(b) The replacement of normal wear parts including without lim-
itation, bulbs, tyres and tubes, spark plugs, belts, hoses, fil-
ters, wiper blades, brushes, contact points, fuses, clutch
disc, brake shoes, brake pads, cable and all rubber parts
(except oil seal and glass run).
(c) Any vehicle which has been used for competition or racing.
(d) Any repairs or replacement required as a result of accidents
or collision.
(e) Any defects caused by misuse, negligence, abnormal use or
insufficient care.
(f) Any vehicle which has been modified or altered, including
without limitation, the installation of performance accesso-
ries.
(g) Any vehicle on which parts or accessories not approved by
Maruti Suzuki have been used.
(h) Any vehicle which has not been operated in accordance with
the operating instructions in this Owner’s Manual and Ser-
vice Booklet.
(i) Any vehicle which has not received, during the warranty term,
the service inspections prescribed in this Owner’s Manual
and Service Booklet.
(j) Any vehicle which has been assembled, disassembled,
adjusted or repaired by other than authorised Maruti Suzuki
workshop.
(k) Any vehicle which has been usedfor purposes otherthan
what it was designed for.
(l) Any damage or deterioration caused by industrial pollution
and bird droppings.
(1) Qualification:To qualify for thiswarranty:

Downloaded from www.Manualslib.com manuals search engine 
,163(&7,21$1'0$,17(1$1&(
06(
+HDGOLJKW$LPLQJSince special procedures are required, we
recommend you take your vehicle to your
DXWKRULVHG 0DUXWL 6X]XNL ZRUNVKRSfor
headlight alignment.
%XOE5HSODFHPHQW
+HDGOLJKWV'LVFKDUJHKHDGOLJKWVSince special procedures are required, we
recommend you take your vehicle to your
DXWKRULVHG 0DUXWL 6X]XNL ZRUNVKRSfor
bulb replacement.
61MM0A031
&$87,21

Downloaded from www.Manualslib.com manuals search engine ,163(&7,21$1'0$,17(1$1&(
06(
+DORJHQKHDGOLJKWV
61MM0B073
61MM0B074
1) Open the engine hood. Disconnect the
coupler (2). Remove the sealing rubber
(3).
64MS161
2) Push the retaining spring (4) forward
and unhook it. Then remove the bulb
(5). Install a new bulb in the reverse
order of removal.
64MS162
NOTE:
You can see the position of retaining spring
from the hole of headlight.
(1)
(3)(2)
(4)
(5)
(;$03/(

Downloaded from www.Manualslib.com manuals search engine 
,163(&7,21$1'0$,17(1$1&(
06(
6LGH7XUQ6LJQDO/LJKWLIHTXLSSHG
76MH0A006
1) Remove the light housing (1) by sliding
to left with your finger.
76MH0A007
2) Turn the bulb holder (2) clockwise and
pull it out from the light housing.
76MH0A008
(4) Removal
(5) Install
3) To remove and install the bulb of the
turn signal light (3), simply pull out or
push in the bulb.
)URQW7XUQ6LJQDO/LJKW
)URQW3RVLWLRQ/LJKW(Vehicle with the halogen headlights)
61MM0A030
(1)
(2)
(3)
(4)
(5)
(2)
(1)

Downloaded from www.Manualslib.com manuals search engine ,163(&7,21$1'0$,17(1$1&(
06(
61MM0B077
1) Open the engine hood. To remove the
bulb holder of the front turn signal light
(1) or the front position light (2) from the
light housing, turn the holder counter-
clockwise and pull it out.
61MM0B078
(3) Removal
(4) Install
2) To remove the bulb of the front turn sig-
nal light (1) from the bulb holder, push in
the bulb and turn it counterclockwise. To
install a new bulb, push it in and turn it
clockwise.
To remove and install the bulb of the
front position light (2), simply pull out or
push in the bulb.
9HKLFOHZLWKWKHGLVFKDUJHKHDGOLJKWV
61MM0A091
To replace the bulb of the front turn signal
light (1), follow the procedure for the front
turn signal light bulb replacement of the
vehicle with the halogen headlights.NOTE:
Position function in discharge headlamp is
LED type, which is non replaceable.
(2)(1)
(2)
(1) (3)
(4)
(;$03/(
(1)

Downloaded from www.Manualslib.com manuals search engine 
,163(&7,21$1'0$,17(1$1&(
06(
)URQW)RJ/LJKWLIHTXLSSHG1) Start the engine. Turn the steering wheel
to rotate the tires to the opposite side of
the fog light that requires replacement.
Then turn off the engine.
61MM0B079
2) Remove the screws (1).
61MM0B080
3) Remove the clips (2) by prying it off with
a flat blade screwdriver as shown in the
illustration.
61MM0B081
4) Open the end of the cover inside the
fender.
80JM071
5) Disconnect the coupler by pushing the
lock release. Turn the bulb holder coun-
terclockwise and remove it.
(1)
(;$03/(
(2)
(;$03/((;$03/(
(;$03/(

Downloaded from www.Manualslib.com manuals search engine ,163(&7,21$1'0$,17(1$1&(
06(
5HDU&RPELQDWLRQ/LJKW
61MM0B082
1) Remove the bolts (1) and pull the light
housing (2) straight.
61MM0B083
2) To remove the bulb holder of the rear
turn signal light (3) or the tail/brake light
(4) from the light housing, turn the
holder counterclockwise and pull it out.
61MM0B084
(5) Removal
(6) Install3) To remove the bulb of the rear turn sig-
nal light (3) or the tail/brake light (4) from
bulb holder, push in the bulb and turn it
counterclockwise. To install a new bulb,
push it in and turn it clockwise.
(2)(1)
(3)(4)
(3) / (4)
(5)
(6)
(;$03/(

Downloaded from www.Manualslib.com manuals search engine 
,163(&7,21$1'0$,17(1$1&(
06(
61MM0B085
NOTE:
When reinstalling the light housing, make
sure the clips are properly attached.
5HYHUVLQJ/LJKW
61MM0B088
1) Open the tailgate. Remove the clips (1)
by prying it off with a flat blade screw-
driver as shown in the illustration. Then,
pull out the trim (2).
61MM0B089
2) Disconnect the coupler (3) by pushing
the lock release. Turn the bulb holder ofthe reversing light (4) counterclockwise
and remove it.
61MM0B090
(5) Removal
(6) Install3) To remove and install the bulb of the
reversing light (4), simply pull out or
push in the bulb.
(2)
(1)
(3)
(4)
(4)
(5)
(6)
(;$03/(

Downloaded from www.Manualslib.com manuals search engine ,163(&7,21$1'0$,17(1$1&(
06(
/LFHQVH3ODWH/LJKW
61MM0B086
1) Turn the cover (1) counterclockwise to
remove it.
61MM0B087
2) To remove and install the bulb of the
license plate light (2), simply pull out or
push in the bulb.
+LJKPRXQW6WRS/LJKW
80J100
1) Open the tailgate, and remove the nuts
(1) as shown in the illustration.
(1)
(2)
(1)
(;$03/(

Downloaded from www.Manualslib.com manuals search engine 
,163(&7,21$1'0$,17(1$1&(
06(
63J127
2) Close the tailgate. Remove the high-
mount stop light housing (2) from the
tailgate.
68KS063
3) Remove the bulb holder as shown in
the illustration.
76MH0A128
(4) Removal
(5) Install
4) To remove and install the bulb of the
high-mount stop light (3), simply pull out
or push in the bulb.
(2)(;$03/(
(;$03/(
(3)
(4)
(5)
(;$03/(