belt TOYOTA 4RUNNER 1998 Owners Manual

4RUNNER (1998)
Indicator symbols on the instrument panel
Automatic transmission fluid temperatu
light*
1
SRS airbag warning light *
1
Unengaged ºParkº warning light *
1
Anti-lock brake system warning light *
1
Seat belt reminder light
*
1
Open door warning light *
1
(type A)
(type B)
Low oil pressure warning light *
1

Low fuel level warning light *
1
Brake system warning light
*
1
Discharge warning light *
1
Malfunction indicator lamp *
1
Low windshield washer fluid level warn
Headlight high beam indicator light
Overdrive- off indicator light
Turn signal indicator lights

4RUNNER (1998)
All the doors lock or unlock simulta-
neously.
REAR DOOR CHILD- PROTECTORS
Move the lock lever to the ºLOCKº
position as shown on the label.
This feature allows you to lock a rear
door so it can be opened from the
outside only, not from inside. We rec-
ommend using this feature whenever
small children are in the vehicle.
CAUTION
Before driving, be sure that the
doors are closed and locked, es-
pecially when small children are
in the vehicle. Along with the
proper use of seat belts, locking
the doors helps prevent the driv-
er and passengers from being
thrown out from the vehicle dur-
ing an accident. It also helps pre-
vent the doors from being
opened unintentionally.
Power windows

4RUNNER (1998)
Part 1
OPERATION OF
INSTRUMENTS
AND CONTROLSÐ
Chapter 1- 3
Seats, Seat belts,
Steering wheel
and Mirrors
Seat
Front seats
Fold- down rear seats
Head restraints
Seat belts
SRS driver and front
passenger airbags
Child restraint
Tilt steering wheel
Outside rear view mirrors
Anti- glare inside rear view
mirror
Sun visors
Seats
While the vehicle is being driven, all
vehicle occupants should have the
seatback upright, sit well back in the
seat and properly wear the seat belts
provided.
CAUTION
Do not drive the vehicle unless
the occupants are not properly
seated. Do not allow sitting on
top of a folded- down seatback,
or in the luggage compartment.
Persons not properly seated
and not properly restrained by
seat belts can be severely in-
jured in the event of emergency
braking or a collision.
During driving, do not allow
passengers to stand up or
move around between seats. Se-
vere injuries can occur in the
event of emergency braking or
a collision.

4RUNNER (1998)
1. SEAT POSITION ADJUSTING LE- VER
Pull the lever up. Then slide the
seat to the desired position with
slight body pressure and release
the lever.
2. SEATBACK ANGLE ADJUSTING LEVER
Lean forward and pull the lever up.
Then lean back to the desired angle
and release the lever.
CAUTION
To reduce the risk of sliding un-
der the lap belt during a collision,
avoid reclining the seatback any
more than needed. The seat belts
provide maximum protection in a
frontal or rear collision when the
driver and the passenger are sit-
ting up straight and well back in
the seats. If you are reclined, the
lap belt may slide past your hips
and apply restraint forces directly
to the abdomen. Therefore, in the
event of a frontal co llision, the
risk of personal injury may in-
crease with increasing recline of
the seatback.
3. SEAT CUSHION ANGLE ADJUST- ING KNOB
Turn the knob either way.
4. SEAT LUMBAR SUPPORT AD- JUSTING LEVER
Pull the lever forward or backward. ÐAdjusting front seats
(power seat)

4RUNNER (1998)
1. SEAT POSITION AND SEAT CUSHION ANGLE ADJUSTING
SWITCH
Move the control switch in the de-
sired direction.
Releasing the switch will stop the seat
at that position.
Do not place anything under the front
seats. It might interfere with the seat-
lock mechanism.
2. SEATBACK ANGLE ADJUSTING SWITCH
Move the control switch in the de-
sired direction.
Releasing the switch will stop the
seatback at that position.
CAUTION
To reduce the risk of sliding un-
der the lap belt during a collision,
avoid reclining the seatback any
more than needed. The seat belts
provide maximum protection when
the driver and the passenger are
sitting up straight and well back
in the seats. If you are reclined,
the lap belt may slide past your
hips and apply restraint forces di-
rectly to the abdomen. Therefore,
in the event of a formal collision,
the risk of personal injury may
increase with increasing recline of
the seatback.
3. SEAT LUMBAR SUPPORT AD- JUSTING SWITCH
Push the control switch in the de-
sired direction.
Releasing the switch will stop the
seatback at that position. Fold- down rear seats

4RUNNER (1998)
BEFORE FOLD- DOWN REAR SEAT
Stow the rear seat belts as shown
in the illustration.
This prevents the belts from falling
out when you fold the seatback.
NOTICE
The seat belts must be stowed
before you fold the seatback.

4RUNNER (1998)
1. Remove the head restraint, and
swing the bottom cushion up by
pulling the lock rel ease strap. Be
certain to replace the head re-
straint.
It is hinged at the front edge, so just
lift it up.
CAUTION
When returning the bottom cush-
ion to its place: Do not forget to pull out the
buckle of the side seatbelts and
center seatbelt and arranged
them in their proper position
for ready use.
Make sure the bottom cushion
is securely locked by trying to
pull up the edge of the cushion
near the lock release straps.

4RUNNER (1998)
2. Unlock the seatback and fold it
down.
This will enlarge the luggage compart-
ment as far as the raised seat cush-
ion. See ºLuggage stowage precau-
tionsº in Part 2 for precautions to
observe in loading luggage.
If desired, each seatback may be
folded separately.
CAUTION
When returning the seatback to
the upright position: Make sure the seat belts are
not twisted or caught in the
seatback and are arranged in
their proper position for readyuse.
Make sure the seatback is se-
curely locked by pushing for-
ward and rearward on the top
of the seatback. Be certain to
replace the head restraints.
Head restraints

4RUNNER (1998)
The head restraint is most effective
when it is close to your head. There-
fore, using a cushion on the seatback
is not recommended.
CAUTION
Adjust the top of the head re-
straint so that it is closet to
the top of your ears.
After adjusting the head re-
straint, make sure it is locked
in position.
Do not drive with the head re-
straints removed.
Toyota strongly urges that the driver
and passengers in the vehicle be
properly restrained at all times with
the seat belts provided. Failure to do
so could increase the chance of injury
and/or the severity of injury in acci-
dents.
Child. Use a child restraint system
appropriate for the child until the child
becomes large enough to properly
wear the vehicle's seat belts. See
ºChild restraintº for details.
If a child is too large for a child re-
straint system, the child should sit in
the rear seat and must be restrained
using the vehicle's seat belt. Accord-
ing to accident statistics, the child is
safer when properly restrained in the
rear seat than in the front seat.
If a child must sit in the front seat,
the seat belts should be worn proper-
ly. If an accident occurs and the seat
belts are not worn properly, the force
of the rapid inflation of the airbag may
cause death or serious injury to the
child. Do not allow the child to stand up or
kneel on either rear or front seats. An
unrestrained child could suffer serious
injury or death during emergency brak-
ing or a collision. Also do not let the
child sit on your lap. It does not pro-
vide sufficient restraint.
Pregnant woman.
Toyota recommends
the use of a seat belt. Ask your doctor
for specific recommendations. The lap
belt should be worn securely and as
low as possible over the hips and not
on the waist.
Injured person. Toyota recommends
the use of a seat belt. Depending on
the injury, first check with your doctor
for specific recommendation.
Seat beltsÐ
ÐSeat belt precautions

4RUNNER (1998)
CAUTION
Persons should ride in their seats
properly wearing their seat belts
whenever the vehicle is moving.
Otherwise, they are much more
likely to suffer serious bodily inju-
ry or death in the event of sudden
braking or a collision.
When using the seat belts, ob-
serve the following: Use the belt for only one per-
son at a time. Do not use a
single belt for two or more
peopleÐeven children.Avoid reclining the seatbacks
too much. The seat belts pro-
vide maximum protection when
the seatbacks are in the upright
position. (Refer to the seat ad-
justment instructions.)
Be careful not to damage the
belt webbing or hardware. Take
care that they do not get
caught or pinched in the seat
or side doors.
Inspect the belt system periodi-
cally. Check for cuts, fraying,
and loose parts. Damaged parts
should be replaced. Do not dis-
assemble or modify the system.
Keep the belts clean and dry. If
they need cleaning, use a mild
soap solution or lukewarm wa-
ter. Never use bleach, dye, or
abrasive cleanersÐthey may se-
verely weaken the belts.
Replace the belt assembly (in-
cluding bolts) if it has been
used in a severe impact. The
entire assembly should be re-
placed even if damage is not
obvious.