buttons TOYOTA MR2 SPYDER 2001 Accessories, Audio & Navigation (in English)

REMOTE CONTROL INFORMATION
THE REMOTE CONTROLS PROVIDED WITH YOUR SYSTEM
The 3 button remotes included with your system have separate LOCK and UNLOCK buttons on the
frontand a PANICbutton on the back .
The RS3200 may be controlled by as many as 4 remote controls, so you may\
add two additional
remote controls to the two included with your system. Contact your Toyot\
a dealer for more details.

TOYOTARS3200 remote keyless Security system Page 3
Front Button
FLASHES WHEN
BUTTONS PRESSED
PUSH TO LOCK
DOORS AND ARM
SYSTEM
PUSH TO UNLOCK
DOORS AND DISARM
SYSTEM

 Back Button
HOLD TO ACTIVATE
PANIC MODE
OPERATION
NOTE: This equipment has been tested and found to comply with the limits
for a class B digital device, pursuant to part 15 of the FCC rules. Thes\
e
limits are designed to provide reasonable protection against harmful int\
er
ference in a residential installation. This equipment generates, uses, a\
nd
can radiate radio frequency energy and, if not installed and used in acc\
or
dance with the instruction manual, may cause harmful interference to
radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does caus\
e
harmful interference to radio or television reception, which can be dete\
r
mined by turning the equipment off and on, the user is encouraged to try\

and correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and the receiver
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help.

PROGRAMMING
DRIVER’S DOOR/ALL DOORS UNLOCK SELECTION (continued)
3. Select the Operating Mode and Complete the Programming Procedure.
Note: If the system locks the doors twice, start over.
TOYOTARS3200 remote keyless Security systemPage 17

a. Press and
release both
LOCK and
UNLOCK buttons
at the same time.
b. Press and release the
UNLOCK button
once for all doors
unlock.
or Press and release the
LOCK button
once for driver’s
door unlock.

e. Open the driver’s
door;
programming is
now complete.i.The tail and marker lights flash 1time, the
buzzer chirps 1 time, and the doors lock and
unlock 1time.