TOYOTA RAV4 1997 Owners Manual

185
To prevent burning yourself, do not check the washer fluid level when
the engine is hot.CAUTION
!
NOTICE
After checking the washer fluid
level, make sure the dipstick is se-
curely reinserted. If it is loose, fluid may leak from the reservoir.
Do not check the washer fluid lev-el or add washer fluid when the en-gine is running or when it is hot.If the fluid is spilled over the hot
engine, a fire could result.
If you have added washer fluid un-til it is close to the top of the open-
ing for adding fluid, do not pullout the dipstick. Otherwise, thefluid will overflow.
Do not use engine antifreeze or
any other substitute because itmay damage your vehicle's paint.
The headlights have the beam angle
gauges to check:
1. Vertical movement
2. Horizontal movement
To obtain correct gauge readings, do
these before you check the headlightaims. Make sure the body around the head- light is not deformed.
Park the vehicle on a level spot.
Fill up the fuel tank.
Bounce the vehicle several times.
A passenger should sit on the driver's
seat while checking the headlight aims.Vertical movement gauges: The bubble
on the gauge should be within six marks
from center on both sides.
Checking headlight aims

186
Horizontal movement gauges: The red
mark on the gauge should be within two
marks from the center on both sides.
If a gauge reading is not within the accept-
able range, have the aiming adjusted by
your Toyota dealer.The following illustrations show how to
gain access to the bulbs. When replacing
a bulb, make sure the ignition switch and
light switch are off. Use bulbs with the wattage ratings given in the table.
Halogen bulbs have pressurized
gas inside and require special
handling. They can burst or shatter
if scratched or dropped. Hold a bulb
only by its plastic or metal case. Do
not touch the glass part of a bulb
with bare hands.
CAUTION
!
NOTICE
Only use a bulb of the listed type.
Light bulbsBulb
No.WType
HeadlightHB260/55A
Parking and front turn signal lights115727/8B
Front side marker lights1943.8C
Rear side marker lights1943.8C
Rear turn signal lights115627B
Stop and tail lights115727/8B
Back-up lights115627B
Licenses plate lightÐ5C
High mounted stop light92118C
Interior lightÐ10D
Personal lightÐ8B
A: HB1 halogen bulbs B: Single end bulbs
C: Wedge base bulbsD: Double end bulbs
Replacing light bulbsÐ

187
1. Open the hood. Unplug the con-nector. Turn the plastic cover coun-
terclockwise and remove it.
If the connector is tight, wiggle it.2. Remove the rubber cover.3. Release the bulb retaining spring and remove the bulb. Install a new
bulb and the bulb retaining spring.
To install a bulb, align the tabs of the bulb with the cutout of the mounting hole.
ÐHeadlights

188
4. Install the rubber cover andsnuggle on the boss.
Make sure the rubber cover fits snugly on
the connector and the headlight body.5. Install the plastic cover with the TOPº mark upward and turn it
clockwise. Insert the connector.
Aiming is not necessary after replacing
the bulb. When aiming adjustment is nec-
essary, contact your Toyota dealer.Use a Philips-head screwdriver.
ÐParking and front turn signal lights

189
ÐFront side marker lights lights

190
Use a Philips-head screwdriver.Use a Philips-head screwdriver.
ÐRear side marker lightsÐRear turn signal, stop and tail,
and back-up lights

191
a: Rear turn signal light b: Stop and tail light c: Back-up light
Remove and install the cover clips as shown in the following illustrations.Removing cover clips
Installing cover clips
ÐHigh mounted stoplight

192
ÐLicense plate lights

Part 8193
SPECIFICATIONS
Dimensions and weight
Engine
Fuel

Service specifications
Tires
Fuses

194
2-door models4-door models
215/70R16 tires235/60R16 tires215/70R16 tires235/60R16 tires
Overall length mm (in.)3740 (147.2)3755 (147.8)4150 (163.4)4165 (164.0)
Overall width mm (in.)1695 (66.7)1760 (69.3)1695 (66.7)1760 (69.3)
Overall height mm (in.)1655 (65.2)*1
1645 (64.8) *21636 (64.4)1660 (65.4)*1
1650 (65.0) *21640 (64.6
)
Wheelbase mm (in.)2200 (86.6)2200 (86.6)2410 (94.9)2410 (94.9)
Front tread mm (in.)1460 (57.5)1480 (58.3)1460 (57.5)1480 (58.3)
Rear tread mm (in.)1465 (57.7)*3
1470 (57.9) *41490 (58.7)1465 (57.7)*3
1470 (57.9) *41490 (58.7)
Vehicle capacity weight
(occupants + luggage) kg(lb)
720 (1588)
801 (1766)*3
794 (1751) *4

*1
:Unladen vehicle (four-wheel drive models)
*2
:Unladen vehicle (two-wheel drive models)
*3
:Four-wheel drive models
*4
:Two-wheel drive models
Dimensions and weight