TOYOTA SUPRA 1995 Service Repair Manual

SEAT BELT
COMPONENTS
BO±56± BODYSEAT BELT

SEAT BELT INSPECTION
Emergency Locking Retractor (ELR) and
Automatic Locking Retractor (ALR) type
1. RUNNING TEST (IN SAFE AREA)
for all seats:
(a) Fasten the front seat belts.
(b) Drive the car at 10 mph (16 km/h) and make a very hard stop.
(c) Check that the belt is locked and cannot be extended at this
time.
HINT: Conduct this test in a safe area. If the belt does not lock,
remove the belt mechanism assembly and conduct the fol-
lowing static check. Also, whenever installing a new belt as-
sembly, verify the proper operation before installation.
2. STATIC TEST
for all seats:
(a) Verify that the belt locks when pulled out quickly.
(b) Remove the locking retractor assembly.
(c) Tilt the retractor slowly.
(d) Verify that the belt can be pulled out at a tilt of 15 degrees or
less, and cannot be pulled out at over 45 degrees of tilt.
If a problem is found, replace the assembly.
except for driver's seat:
(e) Pull out the whole belt, release it slightly and then pull it out
again.
(f) Verify that the belt cannot be extended further.
If a problem is found, replace the assembly.
± BODYSEAT BELTBO±57

ROOF HEADLINING
COMPONENTS
BO±58± BODYROOF HEADLINING

ROOF HEADLINING REMOVAL
1. REMOVE THESE PARTS:
(a) Tonneau cover
(b) Luggage compartment mat
(c) Spare wheel cover
(d) Rear seat cushion
(e) Rear seatback
Torque: 25 NVm (260 kgfVcm, 19 ftVlbf)
(f) Removable roof stay RH and LH (Sport roof)
(g) Deck trim rear cover
(h) Removable roof holder RH and LH (Sport roof)
(i) Quarter wheel house cover
(j) Deck trim side board
(k) Front door scuff inside plate
(l) Speaker grille
(m) Rear quarter trim board
(n) Front seat outer belt
(o) Rear seat outer belt
± BODYROOF HEADLININGBO±59

(p) Deck trim side service hole cover
(q) Roof side inner garnish
(r) Removable roof (Sport roof)
(s) Assist grip
(t) Front pillar garnish
(u) Interior light
(v) Sunvisor and holder BO±60
± BODYROOF HEADLINING

2. REMOVE ROOF HEADLINING
(a) Using a clip remover, remove the 2 clips.
(b) Normal roof±Remove the roof headlining.
3. SPORT ROOF:
REMOVE ROOF HEADLINING
(a) Remove the rear roof headlining.
(b) Remove the front roof headlining.
(c) Remove removable roof headlining
(See page BO±41)
± BODYROOF HEADLININGBO±61

ROOF HEADLINING INSTALLATION
Installation is in the reverse order of removal.
HINT: Torque these parts:
(a) Front seat belt shoulder anchor bolt
Torque: 43 NVm (440 kgfVcm, 32 ftVlbf)
(b) Front seat belt floor anchor bolt
Torque: 43 NVm (440 kgfVcm, 32 ftVlbf)
(c) Rear seat outer belt floor anchor bolt
Torque: 43 NVm (440 kgfVcm, 32 ftVlbf)
BO±62± BODYROOF HEADLINING

SERVICE SPECIFICATIONS
TORQUE SPECIFICATIONS
 Part tightened NVm kgfVcm ftVlbf
 FRONT BUMPER ±± ±± ±±
  Reinforcement x Body 5.9 60 52 in.Vlbf
  Front bumper cover x Body 5.9 60 52 in.Vlbf REAR BUMPER ±± ±± ±± 
  Reinforcement x Body
 
 42
 
 430
 
 31
  Rear bumper cover x Body 5.9 60 52 in.Vlbf
 HOOD ±± ±± ±±
  Hood hinge x Hood 13 130 9.4
  Hood lock x Body 8.8 90 78 in.Vlbf
 FRONT DOOR ±± ±± ±±  Door hinge x Body 52 530 38 
  Door hinge x Door panel
 
 25
 
 260
 
 19
  Door lock x Door panel 5.4 55 48 in.Vlbf
  Window regulator x Door panel 7.8 80 69 in.Vlbf
  Window guide lower plate x Door panel 5.9 60 52 in.Vlbf
  Door window upper stop x Door panel 13 130 9.4
 BACK DOOR ±± ±± ±±  Back door hinge x Body 21 210 15 
  Back door hinge x Back door
 
 13
 
 130
 
 9.4
  Door lock x Body 19 195 14
  Door lock striker x Body 13 130 9.4
  Back door damper stay x Body 5.9 60 52 in.Vlbf
  Back door damper stay x Back door 7.8 80 69 in.Vlbf
 WIPER AND WASHER ±± ±± ±± Front Wiper ±± ±± ±± 
  Wiper arm x Wiper link
 
 22
 
 225
 
 16
 Rear Wiper ±± ±± ±±
  Wiper arm x Wiper motor 11 11 0 8.0
 INSTRUMENT PANEL ±± ±± ±±
  Steering column x Instrument panel reinforcement 25 260 19
  Front passenger airbag assembly x Instrument panel reinforcement 21 210 15  Front passenger airbag assembly x Instrument panel 8.8 90 78 in.Vlbf 
  Steering wheel x Steering column 
 35 
 360 
 26
  Steering wheel pad x Steering wheel 7.1 72 62 in.Vlbf
± BODYSERVICE SPECIFICATIONSBO±63

TORQUE SPECIFICATIONS (Cont'd)
 Part tightened NVm kgfVcm ftVlbf 
 FRONT SEAT
 
 ±
 
 ±
 
 ±
  Seat adjuster x Body 37 375 27
  Seat adjuster x Seatback 18 185 13
  Seat adjuster x Seat cushion 18 185 13
 REAR SEAT ± ± ±
  Seatback x Body 25 260 19  Reclining adjuster x Seatback 18 185 13 
 SEAT BELT
 
 ±
 
 ±
 
 ±
 Front Seat Belt ± ± ±
  Shoulder anchor x Body 43 440 32
  Outer belt anchor x Body 43 440 32
  Retractor x Body (Upper Side) 7.8 80 69 in.Vlbf
  Retractor x Body (Lower Side) 43 440 32  Inner belt x Seat 43 440 32 
 Rear Seat Belt
 
 ±
 
 ±
 
 ±
  Shoulder anchor x Body 43 440 32
  Outer belt anchor x Body 43 440 32
  Retractor x Body 43 440 32
  Inner belt x Body 43 440 32
BO±64± BODYSERVICE SPECIFICATIONS

BRAKE SYSTEM
BR±1