brake sensor VOLKSWAGEN JETTA 1998 Manual PDF

Downloaded from www.Manualslib.com manuals search engine 01-305


Switch to measuring range:
Resistance measurement (2 k )
Test
step V.A.G
1598
sockets Item tested Test
conditions
- Additional
operations Specification
Measures for
deviations from
specification
8 37 + 36 Resistance of
left rear ABS
wheel speed
sensor -G46-
Ignition
switched
off 1.0 - 1.3 k
Electrical Wiring
Diagrams,
Troubleshooting &
Component Locations
binder
If no malfunction can be
located in the wiring:
Repair Manual, Brake
System, Repair Group
45; Removing and
installing parts of ABS
system on front and rear
axles - Check wiring using
wiring diagram
- Wiggle wiring during
test
- Replace left rear ABS
wheel speed sensor -
G46-
Стр. 18из 38 Electrical check of Mark 60

Downloaded from www.Manualslib.com manuals search engine 01-326


Definitions
These explanations refer only to this assembly
group: ABS On Board Diagnostic (OBD). These
definitions are not necessarily generally valid.

ABS
Anti-locking brake system. Further information
on the ABS can be found in the relevant self-
study programs.

Display group number Read measured
value block

ASR
Traction Control System

Data bus
Transportation of data. To do this the electrical
signals are brought into a certain format (BUS).
Further information can be found in Self-study
programs. Also called CAN Bus.

Data bus low (high)
The voltage used to transport the data is low
(high). Further information can be found in Self-
study programs.

Speed sensor
Sends speed signals to control module.
Стр. 1из 6 Definitions

Downloaded from www.Manualslib.com manuals search engine 01-329



Short to positive
Current flows incorrectly to a live component
without supplying a consumer.

Brake pressure release solenoid -F84-
The trip switch is installed in the brake booster
and is required by the control module to
recognize the braking desired by the driver.

Magnetic coil for brake pressure, in brake
booster, -N247-
The brake pressure solenoid is installed in the
brake booster and ensures that a pre-pressure
of 10 bar is available for the ABS/ESP pump.

Read measured value block
The control module can transfer a considerable
amount of test data. This test data delivers
information on the operational condition of the
system and/or sensors connected to it. In many
cases the transferred test data supports
troubleshooting and malfunction repair. The
test data has been summarized into single
display groups because all the information
cannot be evaluated at the same time. The
information can be selected via display group
numbers.

EBC
Engine braking control
Стр. 4из 6 Definitions

Downloaded from www.Manualslib.com manuals search engine 01-330



Sensor for transverse acceleration -G200-
The lateral acceleration sensor is used to
register the speed through curves/bends on the
road and decides which side of the vehicle the
ESP is to brake.

Sender 1 for brake booster/Sensor -2- for
brake pressure -G201-/-G214-
Recognizes the pressure exerted by the driver
and is required to control the pressure of the
pre-pressure system.

Program card version
Always use the most up-to-date program card.
Further information can be found in the test unit
operating instructions.

Sporadic
Happens occasionally

Infinity
The resistance is infinite, open circuit.

= Ohm
Стр. 5из 6 Definitions