YAMAHA T105 2002 User Guide

Fuel gauge Instrument panel
11
&
q we
1. Speedometer 2. Odometer
3. Fuel gauge
Description Function
Speedometer
OdometerShows riding speed.
Shows accumulat-
ed mileage.
Shows the fuel level
in the fuel tank.
Remaining fuel is
about 1.0 L at “E”
position.
5SD O/M-1 9/4/01 2:49 PM Page 11 (1,1)

Position Function Handlebar switches
Dimmer switch
Turn signal switch
12
q
1. Dimmer switch
w
2. Turn signal switch
Position Function
&(HI)
% (LO)Turns on the headlight high
beam.
Turns on the headlight low
beam.4
6
OFFTurns on the left flasher.
Turns on the right flasher.
Turns off the flasher.
Push the switch in after it has
returned to center position.
∇
5SD O/M-1 9/4/01 2:49 PM Page 12 (1,1)

Horn switch
Lights switch
Start switch
13
e
3. Horn switch
r
4. Lights switch
t
5. Start switch
Position Function
*
(HORN)The horn sounds when push-
ing the switch.Position Function
STARTThe starter motor cranks the
engine when pushing the
switch.Position Function
ON
OFF
Headlight, taillight and meter lights
comes on when engine is running.
Headlight, taillight and meter lights
does not come on.
5SD O/M-1 9/4/01 2:49 PM Page 13 (1,1)

EAB80001Shift pedal
This motorcycle is equipped with a con-
stant-mesh 4-speed transmission. The shift
pedal is located on the left side of the en-
gine.EAB90001Front brake lever
The front brake lever is located on the right
handlebar. Pull it toward the handlebar to
apply the front brake.
14
q
1. Shift pedal N. Neutral
q
1. Front brake lever
5SD O/M-1 9/4/01 2:49 PM Page 14 (1,1)

EAB90101Rear brake pedal
The rear brake pedal is on the right side of
the motorcycle. Press down on the brake
pedal to apply the rear brake.EAC01300*Fuel tank cap
To add fuel, open the seat. Then remove
the fuel tank cap by turning it counterclock-
wise.
(See page 18 to open the seat.)
15
q
1. Rear brake pedal
q
1. Fuel tank cap
5SD O/M-1 9/4/01 2:49 PM Page 15 (1,1)

EAC20100Starter lever 1
The starter lever is located on the left han-
dlebar. Starting a cold engine requires a
richer fuel mixture. In such a case, turn the
starter lever to the left. After the engine is
warm, turn the lever to its original position.EAC60700Kick starter
Rotate the kick starter away from the en-
gine. Push the starter down lightly with
your foot until the gears engage, then kick
smoothly and forcefully to start the engine.
16
q
1. Starter lever
q
1. Kick starter
5SD O/M-1 9/4/01 2:49 PM Page 16 (1,1)

EAC30401Steering lock
The steering is locked when the main
switch is turned to “LOCK”. To lock the
steering, turn the handlebars all the way to
the left. With the key at “OFF”, push it into
the main switch and release it, turn it coun-
terclockwise to “LOCK”, and remove it. To
release the lock, turn the key to “OFF”.
17
12
3
1. Push 2. Release
3. Turn
5SD O/M-1 9/4/01 2:49 PM Page 17 (1,1)

EAC42301Seat
To open the seat:
1. Insert the key in the lock and turn it as
shown.
2. Lift the end of the seat up to open.
To lock the seat:
1. Replace the seat in the original posi-
tion.
2. Slightly push the end of the seat down
to lock.EUU01700NOTE:
Make sure that the seat is securely fitted.
18
5SD O/M-1 9/4/01 2:49 PM Page 18 (1,1)

EAU00262*Helmet holder
The helmet holder is located under the
seat.
To secure a helmet :
1. Open the seat. (See page 18 for open-
ing procedures.)
2. Attach the helmet to the helmet hold-
er, and then securely close the seat.EW000030wNever ride with a helmet attached to the
helmet holder, since the helmet may hit
objects, causing loss of control and possi-
bly an accident.To release the helmet;
Open the seat, remove the helmet from the
helmet holder, and then close the seat.
19
q
1. Helmet holder
5SD O/M-1 9/4/01 2:49 PM Page 19 (1,1)

20
PRE-OPERATION CHECKS
Before using this motorcycle, check the following points:
Item Routine Page
Fuel9Check fuel level/top up as required. 22Engine oil9Check oil level/add oil as required. 23, 42–44Front brake9Check operation and lever free play. Adjust if necessary.
9Check fluid level and fluid leakage Fill with DOT3 or 51–52, 54–57
DOT4 brake fluid if necessary.Rear brake9Check operation and pedal free play. Adjust if necessary. 53, 55Throttle grip/Housing9Check for smooth operation. Lubricate/Adjust if necessary. —Drive chain9Check chain slack and condition. Adjust if necessary. 58–61Wheels/Tires9Check tire pressure, wear, damage and spoke tightness. 24–25Control/Meter cable9Check for smooth operation. Lubricate if necessary. —Brake and shift pedal shafts9Check for smooth operation. Lubricate if necessary. 62Brake lever pivot9Check for smooth operation. Lubricate if necessary. 62Center and sidestand pivots9Check for smooth operation. Lubricate if necessary. 62Fittings/fasteners9Check all chassis fittings and fasteners.
—
9Tighten/Adjust, if necessary.Lights and signals9Check for proper operation. —Switches9Check for proper operation. —Battery9Check fluid level, fill with distilled water if necessary. 64–66
5SD O/M-1 9/4/01 2:49 PM Page 20 (1,1)