Wiper ASTON MARTIN DB AR1 Q 2003 Owners Guide

A - Before Driving
1-A-7
Rain Cover
To protect the interior of your DB AR1 during periods of inclement weather
a rain cover is provided.
WARNING. Aston Martin recommend that your DB AR1 is not to be driven while
the rain cover is installed.
If it is essential that your DB AR1 is to be moved with the rain cover installed, i.e.
to move to a safe parking area or into a covered area, do not exceed 5 m.p.h. and
only drive a very short distance. The front of the rain cover, over the windscreen,
can be rolled up, allowing the driver to have vision.
To Fit the Rain Cover
Before fitting the rain cover raise both door windows fully and remove the
ignition key from the ignition lock.
1. Remove the rain cover from its storage bag.
Place the rain cover over the windscreen,
black side up, with the two sucker
attachments towards the front of the vehicle.
Attach the suckers to the windscreen (one
in each bottom corner of the windscreen).
Note: Place the sucker attachments close to the
corners, this will enable the windscreen wipers to operate if required.

B - Controls
1-B-14
Steering Column Controls - Right Hand Stalk
The right column stalk controls the following functions:
Windscreen Wiper Control
Upwards movement of the stalk from its lowest Off position switches the
wipers through the range Intermittent Wipe - Normal Speed Wipe - Fast
Wipe.
Windscreen Wiper Delay Control
When in the intermittent wipe position, the wiper delay interval may be
adjusted using the collar on the right stalk. The wiper delay increases by two
seconds for each of the five collar positions, Maximum rotation of the collar
away from the driver gives the shortest delay between wipes.

B - Controls
1-B-15
Windscreen Washer Control
The windscreen washers are switched on by pressing the button on the end
of the right column stalk. The washers and wipers operate whilst the button
is pressed. On releasing the button, the washers stop immediately but the
wipers continue for a few strokes to clear any residual washer fluid from the
screen.
If the washer button is used during normal wiper operation, the washers
operate whilst the button is pressed and the wipers operate continually
irrespective of the washer operation.
Steering Wheel
Horn Push
The horn is sounded by pressing either of the
horn buttons above the steering wheel pad.
An alternative three spoke sports wheel is
fitted to cars with the Touchtronic transmission
option.
Two buttons marked '+' and
'-' are fitted to
the steering wheel horizontal spokes. These
buttons are used for gearchanging when in
Touchtronic mode.

F - Owner Maintenance
1-F-4
Servicing Precautions
To avoid personal injury, the following safety precautions must be observed
when the bonnet is open and the engine is running or the ignition is switched
on.
WARNINGS:
Keep hands, hair, tools, items of clothing and jewellery clear of all drive belts,
pulleys and operating mechanisms. The cooling fans may operate even though
the engine is not running. The windscreen wiper mechanism is fitted with an
intermittent delay facility and may operate unexpectedly if left switched on.
Carbon monoxide is a dangerous gas and can cause unconsciousness and may be
fatal. Do not breathe exhaust gas as it contains carbon monoxide which by itself
has no colour or odour. Never start or leave the engine running in an enclosed,
unventilated area.
Avoid skin contact with all exhaust system and engine components, engine fluids
and escaping steam. They may be hot and will burn you.
Whenever possible work in the engine compartment with the engine cool, the
ignition switched off and the battery disconnected.
Do not work beneath the car with the vehicle lifting jack as the only support.
Place suitable stands under the car.
Keep children and pets clear of the car. Do not allow anyone inside the car unless
specifically working to your instructions.

F - Owner Maintenance
1-F-13
Windscreen Washer Jets
A washer jet housing is located on each of the
two windscreen wiper arms. Each housing
contains six washer jets.
Adjust the angle of the jets if necessary using
a fine needle so that fluid covers the full length
of both sides of the wiper blades and all spray
stays on the windscreen.
Wheels and Tyres
The tyres detailed in the specification section of this Owner's Guide are the
only tyres approved for use on this vehicle.
To maintain the high performance capability of the car, specified tyres
should be fitted when replacement becomes necessary. The recommended
tyres for DB AR1 are not unidirectional. Tyre sizes are different on the front
and rear axles. Therefore, complete wheels cannot be swapped between
axles, but may be swapped from one side of the vehicle to the other.
It is a characteristic of high performance tyres that temporary 'flat spots' may
develop if the vehicle is left standing in high or low ambient temperatures
for any length of time. These 'flat spots will manifest themselves as minor
vibrations when the car is first driven from cold. As the tyres warm up to
operating temperature, the normal tyre shape should be restored and the
vibrations cease. If vibrations persist, consult your Aston Martin dealer.

F - Owner Maintenance
1-F-39
Fuse Lists
Passenger Footwell Fusebox - Right Hand
F1 5A Passive Anti-Theft Module
F2 20A Cigar Lighter
F3 10A Diagnostic Sockets, Radio, Air Conditioning, Driver's
Door Mirror and Window
F4 5A Seat Switches and Heaters
F5 10A Indicator Flasher
F6 10A Ignition Coils 1-6
F7 10A Interior Lamp Cluster
F8 10A Ignition Coils 7-12
F9 20A RHS Seat Heater Relay, RHS Seat Module
F10 10A Dimmer, Passive Anti-Theft Module, Radio
F11 10A Door Mirrors
F12 5A Diagnostic Sockets
F13 25A Not used
F14 10A Hazard Flasher Unit
F15 20A Wiper Logic Module and Wiper Stalk
F16 30A ABS Control Unit
F17 20A Wiper Motor, Logic Module and Wiper Stalk
F18 30A ABS Control Unit
F19 10A Air Conditioning LH Blower Motor
F20 5A Gearshift Interlock Module, Traction Control Switch,
Interior, Map & Courtesy Lamps
F21 10A Air Conditioning RH Blower Motor
F22 10A Powertrain and Transmission control Modules - Keep
Alive Memory

F - Owner Maintenance
1-F-55 Aston Martin recommends the use of 'AUTOGLYM' car care products or
preparations of similar reputable manufacture for adding to the washing
water. The use of mild 'detergents' as directed by the manufacturers will also
help. When dust and mud have been removed with a hose brush and water,
finally dry with a chamois leather, which should be rinsed regularly in clean
water.
WARNING: Washing and polishing agents containing silicone should not be
applied to glass. This will reduce the efficiency of the windscreen wipers, causing
smears which will reduce visibility, particularly during darkness and in the rain.
During the winter months, it is advisable to wash the car more frequently,
paying particular attention to the underside to combat the detrimental
effects of any salt and sand contamination picked up from treated roads.
Polishing
Approximately twice a year, a good quality polish should be applied and
then buffed, using a soft lint-free cloth.
Alloy wheel rims should be treated with a cleaner which is specifically
manufactured for this purpose.

A - Service Schedules
2-A-4
Service Schedules Summary
Your DB AR1 should be serviced every 12,000 km (7,500 miles) or 6 months,
whichever occurs first. The service schedules cover:
Pre-delivery Inspection (PDI)
This free series of checks is carried out on the car by the Selling Dealer before
delivery. The checks ensure that you receive a vehicle which matches the high
quality standards set by Aston Martin Lagonda Limited.
Initial 1,500km (1,000 mile) Service
The Selling Dealer is responsible for the costs and work involved in performing this
free service. The initial service consists of an inspection and oil change service after
completion of the first 1,500 km (1,000 miles) and includes fine adjustments to
compensate for initial 'bedding-in' e.g. handbrake adjustment. Also, engine oil and
filter will be changed to clear any contaminants picked up during the initial running.
12,000 km (7,500 mile) Service
This is the basic service interval for DB AR1 when consumable oils, filters, etc will be
changed and functional checks will be carried out on all major systems in the vehicle.
24,000 km (15,000 mile) Service
In addition to the 12,000 km (7,500 mile) service items, air filters, wiper blades etc.
are renewed at 24,000 km (15,000 mile) intervals.
48,000 & 96,000 km (30,000 & 60,000 mile) Services
Again the basic 12,000 km (7,500 mile) service is carried out together with the
additional checks and replacement items shown in the following schedules.
2 Years
To maintain the hydraulic brake system performance, the brake fluid is renewed
every 2 years to clear the system of absorbed water vapour.

2-A-5
A - Service Schedules
Pre-delivery Inspection (PDI)
Before you receive your DB AR1, it will undergo a comprehensive pre-
delivery inspection at the Dealer's premises to ensure that it meets Aston
Martin's quality standards. The following checks will be made:
Levels and Leaks
Engine oil
Power steering oil
Brake Fluid
Clutch fluid (manual only)
Engine coolant level
Engine coolant specific gravity
Windscreen washer fluid
Fuel system
Gearbox oil/Auto transmission fluid
Rear axle oil - Differential
Battery
Mechanical Functions
Auto transmission
Selection and P & N functions
Manual gear selection
Clutch operation (manual only)
Throttle pedal operation
Parking brake operation
Steering column adjustment and lock
operation
Seat adjuster rails
Bonnet (Hood) release and catch
Door operation and locks
Storage compartments
Rear view mirror
Wheels and Tyres
Road wheel nuts
Tyre pressures
Front wheel tracking
Electrical Checks
Battery condition
Heated windscreen
Windscreen washers
Windscreen wipers
Air-conditioning controls
Gauges and warning lights
Radio/Cassette/CD player
Navigation (where fitted)
All speakers
Electric aerial
Inertia switch
Window mechanisms
Side and headlights (main and dip)
Front fog lights
Rear fog lights (where fitted)
Hazard warning lights
Instrument illumination and dimmer
Air conditioning panel illumination
Auto Trans. PRNDL illumination
Horns
Interior/map lights
Cigar lighter
Seat adjustment - all functions
Door mirror adjustments
Reset clock (if necessary)
Door / boot courtesy lights
Central locking system
Filler flap lock operation
Seat belt operation
Seat belt warning system
Security system / Remote control
Clutch pedal start inhibit
Interrogate DTC codes (not N.
America)
Record battery open-circuit voltage

A - Service Schedules
2-A-8
Mechanical Function Checks
1000mls 7500mls 15000mls
1500km 12000km 24000km
3 months 6 months 12 months
- x x Lubricate all door locks and hinges
- x x Grease all points excluding hubs
x x x Check / adjust all drive belt tensions,
renew if necessary
x x x Lubricate handbrake links and cables
x x x Check handbrake security
- - 30,000 Check condition of handbrake shoes
- x x Inspect brake pad wear and condition of discs
- x x Check and renew wiper blade inserts
if necessary
- - 30000 Renew wiper blades
- - 30000 Clean out engine and A/C radiators
x x x Check condition and operation of all seat belts
x x x Check security of exhaust system mountings
x x x Check brake hoses, pipes and unions
x x x Check power steering pipes and unions for
corrosion and mechanical defects
- - x Check security and condition of fuel hoses
x x x Check cooling system hoses security
and condition
x - - Check air conditioning hoses security
and condition
x x x Check condition and security of steering unit
joints and gaiters
x x x Check security and condition of
suspension fixings
- - x Check tightness of propshaft and driveshaft bolts
x x x Check interior rear view mirror for security and
function
- - x Check the condition of underbody protection
Electrical Function Checks
1000mls 7500mls 15000mls
1500km 12000km 24000km
3 months 6 months 12 months
- - 45,000 ml Renew spark plugs
- - x Check / top-up battery electrolyte
x x x Clean and grease the battery connections