length ASTON MARTIN DB AR1 Q 2003 Owners Guide

F - Owner Maintenance
1-F-13
Windscreen Washer Jets
A washer jet housing is located on each of the
two windscreen wiper arms. Each housing
contains six washer jets.
Adjust the angle of the jets if necessary using
a fine needle so that fluid covers the full length
of both sides of the wiper blades and all spray
stays on the windscreen.
Wheels and Tyres
The tyres detailed in the specification section of this Owner's Guide are the
only tyres approved for use on this vehicle.
To maintain the high performance capability of the car, specified tyres
should be fitted when replacement becomes necessary. The recommended
tyres for DB AR1 are not unidirectional. Tyre sizes are different on the front
and rear axles. Therefore, complete wheels cannot be swapped between
axles, but may be swapped from one side of the vehicle to the other.
It is a characteristic of high performance tyres that temporary 'flat spots' may
develop if the vehicle is left standing in high or low ambient temperatures
for any length of time. These 'flat spots will manifest themselves as minor
vibrations when the car is first driven from cold. As the tyres warm up to
operating temperature, the normal tyre shape should be restored and the
vibrations cease. If vibrations persist, consult your Aston Martin dealer.

F - Owner Maintenance
1-F-54
Bodywork and Fittings
Checks and Maintenance
Door hinges should be lubricated and door drain holes cleaned regularly
as follows:
• Door hinges should be lubricated with grease.
• Wipe away any excess lubricant to avoid contaminating clothing.
• Check the drain holes in the bottom face of each door periodically and
clear if necessary with a short length of wire.
Caution: Do not lubricate door or ignition locks. They are greased during manufacture
and should not need regular service.
Caution: Automatic car washes and power-operated mops are not recommended,
since prolonged use will cause fine scratches in the paint surface.
Vehicle Cleaning
Paintwork
Washing
For best results, do not wash the vehicle in strong sunlight. Allow the vehicle
to cool before washing. Do not use household soaps or detergents. Do not
direct hoses at full force around the door or boot seals.
When washing the vehicle use plenty of clean, cold or luke warm water.
Remove dust or mud from the paintwork by brushing in a gentle flow of
water from a hose.